DeerHorns 33

Пікірлер

@carter.coleman 2 жыл бұрын

What about the little air filler nubs for the rims, do they come with the rims?

@StarknightMT_official 3 жыл бұрын

Hello, Do you need to replace the belt for your Polaris sportsman 500 recently?

@jshanegarrett8371 3 жыл бұрын

This video still holds up 6 years later 😂

@0v417 4 жыл бұрын

Thanks boss

@hectorpuente1355 4 жыл бұрын

Thanks for your videos helps I lot

@TheTechGuider 4 жыл бұрын

Can you take those rock trim labels off?? I’m Ordering these and the labels kinda ruin it for me

@rodneyjones6069 4 жыл бұрын

I did the exact same thing in my exhaust belt pipe is smoking !!!!

@edwardberns1341 5 жыл бұрын

Thanks for the video, sure wasn't wanting to take off the clutch even tho I bought the clutch puller. Your video made the belt change out easy and simple. Thank you

@bigheadred3528 5 жыл бұрын

How well did they hold up??

@rodneyjones6069 5 жыл бұрын

? What method did you use to get it off ? I can’t find that video ....

@johnorcutt1390 5 жыл бұрын

How do you like the ancla mt tires?

@shahbazkhan9976 5 жыл бұрын

Twisted two this week on my Chevy silverado

@Tman0517 5 жыл бұрын

Its funny because I see everyone else unbolting stuff but I just did a golf cart belt like this and was wondering the same about my sportsman, my belt is definitely worn so I'm looking forward to putting a new one on.

5 жыл бұрын

Nice work dude.

@12pastmidnight66 6 жыл бұрын

Did the front hubs fit inside the center caps? Thinking about a set for my 2003 sportsman

@severeripper9846 6 жыл бұрын

This happened to me about 6 months ago with my 2010 Ranger. Mine has the 2.3L 4 cylinder. Was redlined shifting from 1st into 2nd and BOOM. At first thought I broke a U-joint. Got underneath truck and seen it was twisted in half. Exact same spot as yours.

@ytlefty 6 жыл бұрын

How have these wheels held up? Have you run them with any air let out of the tire? I was looking at a set for my 2018 Polaris Sportsman.

@dblockvillin 6 жыл бұрын

Update on the wheels please ?

@SoonerSasquatch 6 жыл бұрын

Part 4? Lol.

@chmva2000 6 жыл бұрын

Hey there, This bet does not have a tensioner or it sets itself to its correct tightness as at is accelerated?

@Tman0517 5 жыл бұрын

Self tightening as it accelerates

@waynelaquet 6 жыл бұрын

what was the problem that led to you checking this???

@vadymklimovich934 6 жыл бұрын

I heard about woodprix instructions good opinions.

@faustocamacho6008 6 жыл бұрын

How can i get more info on this rims

@deerhorns3314 6 жыл бұрын

Fausto Camacho what questions do you have?

@faustocamacho6008 6 жыл бұрын

DeerHorns 33 where can i get this rims .. price .. will it fit a 2016 Silverado

@deerhorns3314 6 жыл бұрын

Yes there are lots of places to buy them just Google Dropstar wheels with your year make and model!

@cotyallinson6733 6 жыл бұрын

Looks awesome ,gonna switch my lights out too ,I think

@rollinlikeariver7756 6 жыл бұрын

Nice looking! How did you end up liking the helmet? I just bought a Fulmer online, it is a dirt bike helmet for Adventure riding locally. It was a clearance deal, pretty nice.

@saywhat6453 7 жыл бұрын

DAY CO...is crap...use Gates G Force

@iosefatito4783 7 жыл бұрын

I replace the drive belt on my 500 sportsman but it still makes noise nd it has hard time going foward... any suggestions?

@deerhorns3314 7 жыл бұрын

Iosefa Tito I would say it could be your cv shaft if the sound is coming from the rear!!

@iosefatito4783 7 жыл бұрын

DeerHorns 33 ok thnxs ill check it out

@datchaffeec4529 7 жыл бұрын

Iosefa Tito primary clutch I think

@redneckredcoat 7 жыл бұрын

I just can't thank you enough for such detailed videos. I wasn't getting a slapping and was engine was bogging when revved.... Probably because my badly worn but intact belt had jumped off the rear pulley and was jammed behind it not turning at all.

@redneckredcoat 7 жыл бұрын

Very helpful. Gave me the confidence to do the job my self. Thank you so much.

@ridin_dirty 7 жыл бұрын

How are these wheels??

@redneckredcoat 7 жыл бұрын

3:04 Where did that little bit come from that goes flying off the front pulley ? Very informative. I'll let you know how mine goes.

@redneckredcoat 7 жыл бұрын

DONE IT !!! All thanks to you and these 4 very informative videos. I recon you saved me about $200. Let's split it. Now where do I send the cheque ? ;p

@redneckredcoat 7 жыл бұрын

PS. What kind of person gives a thumbs down ? If I could just keep liking I would.

@samhollan4570 7 жыл бұрын

I like Polaris but I wish they would go to gear driven and getaway from the belts

@Tman0517 5 жыл бұрын

Hell no, Polaris cvt is amazing on the trails, I'm always in the right gear. Unlike the Honda auto where it never gave me the power I needed to go up hills faster until it finally shifted.

@xFirestormerX 4 жыл бұрын

@@Tman0517 I like both, but when I go with geared transmissions I rather a foot shift or electric shift, not the dumb automatics

@jaredwages2697 7 жыл бұрын

How do you get the old belt off??

@parkerreese1315 4 жыл бұрын

You could probably just cut it

@patrickbarker771 8 жыл бұрын

I have a sportsman 400 would the belt be the problem if the quad wont go any faster than 20 mph in high and in low or would it be something else

@bagels451 7 жыл бұрын

I've been having the same problem. Won't go over 20 or so in high gear. I changed my belt but still have the same issue. Mine has over 5000 miles on it. The book says to check the valves for our issue.

@MrSours69 6 жыл бұрын

@@bagels451 hi bagels 451 it could be I. Limp mode or the pilot jet in the carburetor.. I had the same problem and I looked everywhere for the problem for about a week then just thought it was the carburetor and it was because it was not getting the air in the intake like it should have...

@codyeverette6191 5 жыл бұрын

I had this same problem on my 2012 sportsman 500. Turns out that my “clutch buttons” in my secondary clutch were busted which wouldn’t allow the helix to rise like it should. I opened up the secondary clutch and there were fragments of the clutch buttons scattered. $10 replacement part from EPI I believe. Put the new ones in, they just have a simple screw in the middle that holds them in place, then put the secondary clutch back together which was the only aggravating part as it is spring loaded. I was then able to get full power again! Hope this helps

@lawnizimmerman9444 8 жыл бұрын

What kind of gear fluid do you recommend anything aftermarket or should it be Polaris brand

@lawnizimmerman9444 8 жыл бұрын

Ive changed the oil since ive had it. Never changed any other fluids though. I thought about popping the cover off and looking to see if they were any groups on the clutch plates but I wouldn't know any reason why there would be this thing has had had an easy life since I've had it

@lawnizimmerman9444 8 жыл бұрын

It is the exact twin of your machine in your video

@lawnizimmerman9444 8 жыл бұрын

No I never changed it I have owned it for almost 2 years so I do not know the history of the drive belt on it it just started doing it last week you had never done it before and has not given me any problems half the time when you idle down it'll come to a stop perfectly the next time you can idol down and it wants to keep chugging forward and you have to pull hard on the gearshift to pop it out of gear

@deerhorns3314 8 жыл бұрын

I dont think the belt is the problem but its possible. Kinda hard to point u in the right direction with out seeing it in person. However it could be a lubrication problem. If your not positive on how it was maintenance i would suggest changing out all fluids. Do oil change, radiator flush, new gear fluid. probably coast around 100 if u do it all you self. I hope this helps a little.

@lawnizimmerman9444 8 жыл бұрын

my 01 500 sportsman is sometimes staying in gear, when I come to a stop it lugs and wants to keep crawling forward. wondering if it could be a belt problem, it doesn't do it all the time though

@deerhorns3314 8 жыл бұрын

Lawni Zimmerman Did u just put a new belt on it? sometimes when u put on a new belt the tension might be a little tight and the belt needs to be broken in, witch will happen over a short period of time riding it.

@RZRMINERBDR 6 жыл бұрын

Yes mime did the same thing just before the belt flew apart. The old belt is too worn out to ride on top of the clutch pullies properly.

@techedfireman4981 8 жыл бұрын

maybe they were thinking safety in numbers....who knows

@kimboslice1233 8 жыл бұрын

how are the tires wearing for you?

@deerhorns3314 8 жыл бұрын

Mike Hump so far there is no wear on the tires other than the white husky emblem on the side wall is rubbing off.

@kimboslice1233 8 жыл бұрын

I'm thinking about getting a set for my RZR. How do they ride?

@deerhorns3314 8 жыл бұрын

Great

@unclejim2330 8 жыл бұрын

I've been looking at these. 25" has 3/4" lug and 26 has 1" lug How are the wearing?

@deerhorns3314 8 жыл бұрын

I've been extremely happy with them so far!!!

@Citizen8700 8 жыл бұрын

nope had to take off primary but good video still

@Citizen8700 8 жыл бұрын

well hell... all the other videos pulled the primary clutch to install belt... you might have saved me that trouble :)

@jamesssss621 8 жыл бұрын

Ty for this video.

@jamesssss621 8 жыл бұрын

nice sportsman dude!

@DonaldVervaecke 8 жыл бұрын

Hey DH33 I have a Sportsman500ho 2013. It started acting like it was pulling hard when you give it gas also it vibrates hard when you let up on the gas, I am wondering if it could be my belt? Any info or suggestions you can give would be greatly appreciated

@deerhorns3314 8 жыл бұрын

Its crazy right

@MattJoinesVietnamWarAirsofter 8 жыл бұрын

My f150 just did it last night lol

@j-n_colem6554 5 жыл бұрын

Just happened with our sons F-150.

@david197979 8 жыл бұрын

Great video. My sportsman 500 ho was making the same sound. I pulled the cover off to find it full of dog food. Mice using it as storage. My belt was like new and now have the mice a special dinner. Pull cover off before ordering a new belt

Ең жақсы KZbin

Пікірлер