I've purchased two Emtek Tubular Round Privacy Pocket Door Lock. Neither one will lock. The little catches do not pop up. Frustrating
@luke98224 жыл бұрын
5 seconds? Can we get a little more on this? Wondering how these compare to the much more expensive mortise version.
@endrei225 жыл бұрын
I want to install an ikea ledges picture Self above and below my TV. My only problem is that i have a cat. He sure is going to jump onto that self. Is it strong enough to stand a “cat attack”?
@OnTwoFan5 жыл бұрын
I tried it, didn't work
@LuisRamirez-ln3cj5 жыл бұрын
Thanks. I believe you have to make sure the arrows point up and down to increase the surface area holding the pressure of the weight on the anchor.
@qqkk55815 жыл бұрын
What is that fastener wheel holder you have at the 0.57 mark? I occasionally would have a use for that.
@takla32105 жыл бұрын
This video is so poor on details. So many unanswered questions. Why is this better than traditional door stops? Drilling holes in my flooring? What's the advantage of making holes in my hardwood flooring. How close to the wall does the floor stopper need to be? What type of noise does it make when it stops the door? Etc. Etc.
@NM-fd3jo6 жыл бұрын
Simple that even ordinary carpenters can able to make
@kimberlyShursen20158 жыл бұрын
You saved my life!!!
@pujanithyananda47099 жыл бұрын
Nice, your video!
@Capris9x10 жыл бұрын
Hi, I noticed that the toggle goes back until it's against the back of the wall. Does that mean the screw you used will just hang out and not be screwed it 100% completely? I'm asking this because I'm installing shelves and I need my screws to go all the way, so do my screws need to be a certain length?? (I have 3/4 inch drywall as well) Thanks!
@TheHardwareHut10 жыл бұрын
When you order the Hafele E-Z Toggle Drywall Anchors, a screw is provided for installation. It is best to use the screw provided due to the threading and screw size being a perfect fit for the anchor. The screw cannot exceed 2 1/8" in length, should you try and use your own. The screw will sit flush with the front of the wall when the item is fully installed, the only part that will protrude will be the screw head.
@TheHardwareHut10 жыл бұрын
It's actually best to simply screw it further in till it falls behind the wall. That way you do not damage your drywall.
@jerold377710 жыл бұрын
How do you remove this product without tearing a whole in your wall? Thanks.
@FridayNightArcade7 жыл бұрын
Just push it the rest of the way through... it will fall harmlessly into the inside of your wall. Spackle up the screw-sized hole left behind and repaint.
@melloyelloguy10 жыл бұрын
how to remove ez toggle?
@PankajGulatee10 жыл бұрын
Show hand twin corner
@DecorationTV10 жыл бұрын
Cool!
@TheHardwareHut13 жыл бұрын
@scriptures4life - Precisely
@Backtoflying13 жыл бұрын
So basically the "bolt" part works on the face of the door near the pocket, instead of near the pulling edge side, eh?