RobRealistic

Пікірлер

@NotHomeownerApproved 11 күн бұрын

What causes the power steering pump to whine when turning? Mine just started on my 1975 k25

@danielmancuso66 19 күн бұрын

Way WAY more helpful. Thank you.

@RobRealistic 13 күн бұрын

@danielmancuso66 thanks. I was just sharing what I do. I appreciate you.

@ivan5595 Ай бұрын

based tip

@11bangbangshaw93 2 ай бұрын

Where does that little spacer go, the spacer just under the right of the pump on the orange fang af 7:26 in the video? Does it go on the top left or left side adjustment?

@RobRealistic 2 ай бұрын

@@11bangbangshaw93 that's just a spacer specific to my truck because I didn't have the original bracket on the engine. It's nothing you need to worry about.

@pro-hz7kx 2 ай бұрын

Thanks you. Now TND can go on

@JonnyBlazeTCB 3 ай бұрын

How are they holding up?

@RobRealistic 3 ай бұрын

@JonnyBlazeTCB I mean, I haven't exactly "tested" them if you know what I mean but they are still good as new.

@JonnyBlazeTCB 3 ай бұрын

@RobRealistic I want to order a set, but no way in hell I'm paying the $40 for shipping they are trying to charge me.

@RobRealistic 3 ай бұрын

@JonnyBlazeTCB buy 1k worth of stuff and shipping is free.

@JonnyBlazeTCB 3 ай бұрын

@RobRealistic they told me $2500. 😂😂😂😂😂

@vc5917 5 ай бұрын

Is the support for the trim molding 1 big piece that goes across? (The piece were the trim slides on) Did you put the same you had or did you buy a new one? Mine broke and my trim on the passager side won’t clip on. I just don’t know where to buy this from or if it’s one big piece or multiple pieces

@vc5917 5 ай бұрын

Sorry if it’s confusing but it’s basically the item that the trim sits on

@RobRealistic 5 ай бұрын

It's multiple pieces. It's sits on a butterfly clip,

@deeeg4098 6 ай бұрын

Nice video, why is the washer so big? I can use a smaller one I’m sure?

@RobRealistic 6 ай бұрын

Yup, I just used what was included. The washer is actually for the floor to spread the load out but this was the only way I could get my belts to work properly

@deeeg4098 6 ай бұрын

@@RobRealistic ok, thanks for the video. I’m installing some today.

@mrmidnight32 7 ай бұрын

Do you know what size fittings the lines from the rack are? I found the one that’s towards the cab, but the lower one is bigger. I’m trying to convert mine to AN lines since they were already missing off my c10.

@theiceageiscoming.5516 7 ай бұрын

💪😎🇺🇲

@johncook3273 8 ай бұрын

thanks

@mr.breadNwater 8 ай бұрын

Best tutorial I've found hands down. Do you happen to know the dimensions of the L bracket? I know they're 3/16" tick with 5/8" hole but what are the lengths and the width?

@drucl8n 8 ай бұрын

thank you for this

@sabinarnaut4510 8 ай бұрын

How did you remove the decals ?

@RobRealistic 8 ай бұрын

Heat gun and goo gone

@alanbuster7390 10 ай бұрын

Great video! Thanks for your very helpful information- this saved me several hours.

@RobRealistic 9 ай бұрын

Glad I could help

@TempoDrift1480 10 ай бұрын

Thats bullshit having to cut and hack everything all up. You'd think for the price you could get a better product. I just ordered the kit that looks like the one you took off and I will be surprised if it lasts a year.

@RobRealistic 10 ай бұрын

It's been fine. I have no complaints.

@RobRealistic 10 ай бұрын

Been over 4 years and still works and looks new

@DBCooper363 10 ай бұрын

Wish I found this video earlier. Spent almost a whole day trying to figure this out

@gyoflow 11 ай бұрын

Part number?

@SOU6900 11 ай бұрын

I just remembered I need to order a tap to install mine in my 82. Got the reel out, but I can't get the bolt out for the clip half of the belts out. Ruined a brand new torx bit trying to get said bolt out.

@kabbablabba4073 Жыл бұрын

thank you for helping me with this problem now i can finally go back to commiting TND

@holinessorhell1964 Жыл бұрын

Dude you did a good job explaining it... Is it possible if I accidently used a pry bar to tighten my belt and lightly pushed against the power steering reservoir. Could I have pushed some of the fluid out of the cap area because I don't think I ruptured the pump..?

@RobRealistic Жыл бұрын

Is there a question in here?

@dimakomarov4422 Жыл бұрын

So much talkative... You could explain it within 1 minute.

@RobRealistic Жыл бұрын

You could always just figure it out your damn self instead of looking to KZbin for answers... and it was made about a GPS that's not made anymore. So if your looking for this information now, go buy a garmin. SMH.

@dimakomarov4422 Жыл бұрын

@@RobRealistic I didn't mean to offend you. It's just a healthy criticism. Thank you anyway.

@glfmarmadison5126 Жыл бұрын

How did the molding go around grille?

@ernestsanchez4865 Жыл бұрын

Is there a way to repair the charger itself? For the 750

@coreyg3658 Жыл бұрын

3 minutes in and I'm waiting for you to get to the point.

@pech33 Жыл бұрын

Excellent video. I was wondering how to get these installed. My truck had shoulder belts but the “PDSO” cut the shoulder belts off using just the lap belt (death wish I guess). Now I know how to install them. Thanks!

@jackhennessey4154 Жыл бұрын

This is our second K-Classic. We had our first one for many years, so when we had to replace it, we wanted nothing else but this exact kzbin.infoUgkxBrV-RbF5Nk0Rlt9i15aao-YMzqzTG8Vf model. We use it for about three people everyday in the morning. The taste and quick brew is one of the reasons we like it so much. There are so many choices of brands of coffee that we would grab what was on sale and test the different brands from there. I would definitely recommend trying different brands of coffee to find the ones you like the most because there are brands that quite frankly taste horrible.

@DefaultKnight Жыл бұрын

I had an issue where it wouldnt turn on at all just hild the reset button for 10 minutes

@chili3578 Жыл бұрын

@robrealistic can you please give me the exact name and info of the charger?

@simonedoesitbetter Жыл бұрын

My 2.0 has only 4 and 6oz options! Why?

@drouleau Жыл бұрын

Looks like riding near/through Mesquite Ranch? I'm over on E Rose Hill St

@sportguy17 Жыл бұрын

Nice

@haniballecter7605 Жыл бұрын

What year and type front bumper do you have on that truck? Thanks

@simsrodriguez3545 Жыл бұрын

The old brackets where modified for bumper be flush. You got a big gap they sell bumper fillers

@emilyprakel-cassidy1837 Жыл бұрын

Thanks for the video! It's really helpful. Waaaay more helpful than my Hayes Manual....

@ClassicSilveradoTrucks Жыл бұрын

Did you have to do anything to the vertical brace in the grill? Did the camshaft hit it?

@williambrown2098 Жыл бұрын

Find a mother fuck do you sit there at the beginning of the fucking video and just talk about it's a paperweight I bought it after I got my own truck I know this video is supposed to be about fucking fixing the charging problem but it is such a great device to have if you can learn how to fix the fucking charging issue God damn dude stupid fucking shit

@jackboyd9280 Жыл бұрын

You talk too much bs

@patriziaamaddeo2093 Жыл бұрын

Buona

@tom110111 Жыл бұрын

Great video! Just put mine in watching your video. Started with the passenger side and reversed the 2 pieces on the belt. On mine, I already had the 3 point top piece so I was able to re-use the bolt and not have the molding issue. Very helpful.