Man you say that you have lots of experience doing this but you're an amateur like lots of people on youtube.
@legacyMedia20913 күн бұрын
@@kustomcarsmetics7344 I owned a car customs shop for over 2 years… I’m showing this as a basic installation with tools found at home. Look at my older videos of repairs I’ve done at my shop. I make this videos with the basics, if I wanted to go all in, the headliner would’ve came down.
@pc_games259315 күн бұрын
Thank you Are these cables good? I will install a 1000 watt power supply Is connecting from 8 pin to 12 pin for the processor correct or is there a problem that may occur Have the cables been working successfully for you for this long period
@legacyMedia2098 күн бұрын
That computer that was used in this video is still chugging along just fine!
@pc_games25938 күн бұрын
@@legacyMedia209 Thx , Well that means it will be good and no harm done.
@Liasisws16 күн бұрын
How do you know which side is up for the rear camera? I haven’t installed mine yet but looking at it I have no clue. Thanks in advance!
@grantnzombe127616 күн бұрын
The password is default 12345678. I like this dashcam, the downside is it comes with a small SD card of 32GB. I am looking to upgrade to at least 128GB so you can keep all clips for a full day drive. If not it deletes the oldest files
@davidking864018 күн бұрын
It doesn't run off a weird voltage. It runs off 5v dc. As in a USB cable. What it provided was a 12v to 5v transformer. Ready the text on the 12v cigarette charger and it tells you the output voltage You could have plugged in a USB A to USB C cable into the USB ports you already have and avoid 2 of those components. What you have just done is go from 5v to 12v, and then back to 5v again. Suggest you swap out the cable.
@aushussain21 күн бұрын
Thanks alot for this video, came in very handy today
@blessedRen3721 күн бұрын
You got the wrong mini chain saw.
@sundancer738123 күн бұрын
Good job! Interesting about 12 volt not fitting in car enough.......
@legacyMedia20923 күн бұрын
@@sundancer7381 It’s the first time I experienced this, I didn’t know there was multiple types.
@crunchyface976024 күн бұрын
Great camera. Crystal clear.
@bbcoach2003Ай бұрын
Easier to do it 1 wire at a time 😂😂
@timsaviation4775Ай бұрын
How long do you think it took you to wire everything
@legacyMedia209Ай бұрын
It took me about an hour to do it, but I have some years in experience when I had an car customs shop.
@timsaviation4775Ай бұрын
Just got one for Christmas, thanks for vid
@TheSaabClinicUKАй бұрын
The Z440 has a 700w PSU, so you just changed it for one of the same capacity ?.
@legacyMedia209Ай бұрын
@@TheSaabClinicUK The reason why I changed it because we had it laying around as a place holder. Once I upgrade the graphics card I’ll up the power supply again. Good eyes catching that!
@xMandalorexАй бұрын
Added a 1500 watt PSU to mine, as the 700 Watt psu kept shutting off (can't handle the RTX)
@MeatyLegendАй бұрын
my 700w psu broke and instead of using velcro, i just zip tied a power supply at the back. doesn't look pretty but it works lol, and it the z440 is tucked under my desk so i am not too bothered. just have to buy 90 degree sata power cables so i can close the side panel
@legacyMedia209Ай бұрын
Fatter making this video the power supply came off the adhesive I placed. I added a zip tie as well and it’s. Been working fine since.
@MeatyLegendАй бұрын
i transplanted the standard atx psu i use now, to the case of the broken 700w psu. it works and i don't have to zip tie it anymore. a little bit dangerous but doable if you like to tinker
@shellysmkАй бұрын
Thank you for this! I was able to install a new bridge for my system without having to contact support. Much appreciated!
@legacyMedia209Ай бұрын
@@shellysmk It’s comments like this that make it worth while !
@Avinlo76Ай бұрын
It's a good dopamine hit when you reach your finger in and feel that glow rod....lol
@jimmymezzano3865Ай бұрын
Love my alienware. got it for cheap. did buy a new i7motherboard and graphics card cant wait too install it all. how do you install the DDR4 graphics card. is it cross compatible with DRR3? I would of bought a different card then what i did. so the 1050ti fits in?
@legacyMedia209Ай бұрын
That computer is pretty compact and it fits everything perfectly inside. I still use that PC still to this day as my media streaming pc. As for the ram here is a link to the ram I bought for this thing. amzn.to/4glPAW0 Just a heads up it’s a nightmare putting the side panel back on, be patient when putting it back on!
@whitetiger99072 ай бұрын
Samething happened to me with my 2022 x3 so lucky my x3 it has another cigarettes lighter in the back trunk that fit this weird adapter
@TheRoger12052 ай бұрын
Nice job!! Did that adapter come with it? I ask because I was looking at this for my BMW. Thx!
@legacyMedia2092 ай бұрын
@@TheRoger1205 No I had to order it separately, I have the link directly to the product I used in the description!
@davidking864018 күн бұрын
You don't need the adaptor. Just get a USB A to USB C cable, like most phone chargers, and charge it off the USB ports in the car (if you have one)
@MiataGirlStella2 ай бұрын
dashcam is suprisingly nicee
@Dolly-Days2 ай бұрын
Great work! That was spot on with your measurements. That was impressive!
@legacyMedia2092 ай бұрын
It’s from the years of trial and errors, now I think I’m doing decent.
@hiya12345678992 ай бұрын
Very informative!
@legacyMedia2092 ай бұрын
Thanks, I got more videos coming !
@byrne19162 ай бұрын
From my research you were 100% correct. That model vikykin is oem Hikvision, its gen 2 colorvu with a newer deeper base. From other videos I've seen the 4mp version gives a slightly clearer night time image than the 8mp so save a few dollars and HDD space there.
@legacyMedia2092 ай бұрын
I’m going to be making more videos soon on that camera. I was going to upload a video on an install I just did with one but it went horribly wrong. I’ll make it again soon once I order more.
@Nick_R_2 ай бұрын
I guess you were not up for using a dremel to cut the top bulge out of the case, to make the PSU fit flush to the back?
@legacyMedia2092 ай бұрын
@@Nick_R_ I’m planning on buying another HP work station, I’d most likely would have to buy another Dremel since I lost mine. Good idea!
@atm26862 ай бұрын
Use a heat gun or hair blow dryer on when using double sided tape to help it stick better also alcohol clean both surfaces
@legacyMedia2092 ай бұрын
@@atm2686 Thanks for the advice! I’m going to do another video on this again with a different HP computer soon, since the computer setup I have now, I’ve out grown it.
@MiataGirlStella2 ай бұрын
BOOM BANG CRASH
@legacyMedia2092 ай бұрын
Next time ill plug in my mic :(
@ww1www2 ай бұрын
The sound quality in this case has nothing to do with the congested 2.4GHz band. Other 2.4GHz systems sound great.
@PeterFrary2 ай бұрын
The included lav mic is horrid. Dung of dung. However, I tried Movo WMX-1 with a little Sennheiser shotgun mic on a boom and it sounded much better. Not great but much better than the lav. But, yeah, the Movo wireless was only $19.95 so you get what you pay for.
@legacyMedia2092 ай бұрын
@@PeterFrary There shotgun mic wasn’t bad and I am still currently using it for my videos. But the next time I’ll get something name brand.
@MiataGirlStella2 ай бұрын
pppp
@legacyMedia2092 ай бұрын
This goes hard
@williambreeze26593 ай бұрын
These cars are awesome 👌
@raremineralz3 ай бұрын
Thank you for sharing will this work if I plug in my nvr to the Poe bridge and then plug in my cameras into the nvr or will this only work if I plug the camera in to the bridge?
@legacyMedia2093 ай бұрын
So when you add the camera, before you install it, note the last 4 characters of the MAC address. An example would be A1:3B. Then go on your computer and download advanced IP scanner. Once you have the camera plugged in, scan your network and in the search bar inside of the scanner program. Type the last 4 of the camera’s MAC address. That should give you the IP address as well. Then inside of your NVR software manually add the camera and type in the IP address you got from advanced IP scanner and it should appear on your NVR.
@jp927043 ай бұрын
It's almost like the chain is on backwards. It is not cutting...
@legacyMedia2093 ай бұрын
@@jp92704 The blades on this one are on the right way. A manufacturer wouldn’t mess this up that bad.
@metaldragonbraveheart3 ай бұрын
I'm running a 22 core Xeon very happy with the factory 700w PSU , But you could gut both supplies and use new inners with old psu case,
@Nick_R_2 ай бұрын
You might be able to fit an SFX PSU entirely into the HP PSU case, with the innards removed from the HP. You could even mount a fan to the exterior, using the existing fan mount. In fact I wonder if you could fit an SFX PSU into the HP anyway, using two of the case screw holes as they are (being 52mm apart)?
@xMandalorexАй бұрын
700 Watt Struggles with RTX demanding games though, i upgraded mine to 1500 watt
@RezidentZombie3 ай бұрын
I just ordered these. It says they come on dusk to dawn. Do they do that automatically or do you need to turn them on with the remote?
@legacyMedia2093 ай бұрын
@@RezidentZombie Just turn the device on and then it should do it automatically.
@williambreeze26594 ай бұрын
Nice focus man!
@legacyMedia2094 ай бұрын
Sadly I sold the car to an idiot that didn't fully grasp the concept on why I warned him that parts are scarce and expensive sometimes. Then he got hit 2 times and splattered paint in the interior to make it look cool. Fattest L I took.
@MiataGirlStella4 ай бұрын
I died on the toilet bowl sound effect
@MiataGirlStella4 ай бұрын
Stinky fat Gigi fits on it too, shes the one in the start!
@ajingolk77164 ай бұрын
The after market psu you choosed is not the same form factor.👏
@legacyMedia2094 ай бұрын
None of the power supplies you can buy will fit in it. Only the oem power supply will fit.
@JamesJReid4 ай бұрын
why did you change the power supply? I feel the z440 had an excellent 700w power supply already installed at the factory?
@legacyMedia2094 ай бұрын
@@JamesJReid I changed it due to the fact I want to add a more powerful graphics card in the computer.
@MeatyLegend4 ай бұрын
if you've got the 700w psu it does have the 2x6 pin pcie connectors. the 525w i believe does not have any pcie connector. you can use the 9.5mm optical drive bay and power connector for a sata ssd caddy, that's what i did with mine
@legacyMedia2094 ай бұрын
@@MeatyLegendThat’s good to know, but I think I’m just going to leave the drive the way it is.
@USA-CANADA14805 ай бұрын
You mean Ali express? 😂😂😂
@thermogenic51376 ай бұрын
I understand the Cheap crap comment . i bought one a month ago, did tons of video research and i am happy as anyone with a new toy. i'm in an urbam area so there are not too many chances i have after a day for chopping. BUT i think the way this video showing flaws - may BE that the chain is not going in the correct direction. So many videos with the same type of chainsaw(s). never seen one stop as fast as yours. (and it looked like the most no-name brand of all units offered). you do get what you pay for. Mini chainsaws are a gimmick - yes - make it optimal, don't rely on an item out of the box / then use. Big box stores dont assemble bikse correctly. still gave you a ike!
@krank2kold6 ай бұрын
You actually can use a regular water hose. Just gotta make sure it's on tight & the water pressure is up high.
@alex-v4w6 ай бұрын
Those type of tool are for 1. weekend works 2. for guys to add to their display case to say they own tools 3. for guys to say they have the perfect tool for the job.