Day time running light doesn’t work with high and low beam can i code it through obd???
@studiocanalespanol8121Күн бұрын
Where can i buy those headlights?
@dragxngaming2485 күн бұрын
They look really nice I hope to upgrade my car to these at some point, will they need coding in for if I where to use LED bulbs not halogens or are they fully plug and play, also how do I know if the beam image and adjustment will be correct and does the headlight aim slider still works ok any advice will be appreciated.
@dragxngaming2485 күн бұрын
Looks brilliant, does your golf has TPMS? Is there anything to reconfigure with that?
@carriecottle8 күн бұрын
Where can I get a new motor?
@DailyshortsNL8 күн бұрын
This video is verry helpfull, thank mate! Greets from the Netherlands!
@alireza07113 күн бұрын
U didn't mention u have to remove black plastic trim on bottom side of speedo b4 remove speedo trim
@picklemagic18 күн бұрын
I know this is old but you didn’t need to remove the bumper? How easy is this to do with the bumper still connected
@SamB0619 күн бұрын
Thanks for the Video! Got these Vland lights today with the D2H bulbs. Few things i came across 1. They come with halogen bulbs in the full beam slot. H9 i think. 2. Low beams are H7 or D2H. I had H7 led bulbs with ballast built in but they wouldnt work but the halogen full beams were working. I installed D2H bulbs instead and then they became the low and full beams so dont know what the full beam halogen bulb is for now. 3. Wiring for the D2H bulbs couldnt fit in light housing. The cap for housing was solid plastic unlike in some other videos ive seen where theres a slot for wires so had to cut a hole in it for wires and then have the ballast tucked away behind lights. 4. Sequential indictors and hazards work straight away without programming. 5. Lights will needs to be adjusted to fit perfectly
@rijojoseph85074 күн бұрын
Same issue for me too. Everything else works fine except for the low beams. I swapped the stock halogen from my old headlights and those headlights i bought from ecs tuning looks completely different because I don’t have to connect all the wires like i see in other videos, but i’ve got two extra connectors which has two black wires that looks like it needed to go somewhere but I don’t know because I can’t find info about it on the instructions or any of the videos.🥲
@hafizali345825 күн бұрын
Where did you get the side wing spoiler from
@99tomsmithАй бұрын
Hey mate did you have any issues in the months following this install? I'm tempted to do the same in my 2013 giulietta with the flip-nav and bose speakers.
@99tomsmithАй бұрын
Has it got built in GPS? DAB?
@Chrzs2cjАй бұрын
Did your new grill come with the metal threads for the screw already installed? Bought one of aliexpress with non installed, wonder if theyre needed.
@ks07766Ай бұрын
Hi where did you get the headlight units from I’m looking to do the same to my golf and will they work with factory fitted xenon’s?
@alireza0712 ай бұрын
Atleast use bosch filter if u can't get genuine and all the time castrol edge
@surahatahdrammeh70932 ай бұрын
Where are you based
@Skiinye2 ай бұрын
Love it
@johnboy24362 ай бұрын
why would you use sealant? curious?
@yvonneferguson97572 ай бұрын
wait, there's a drawer....
@othusitselokailwe28573 ай бұрын
Do they just work, or do you need to do some modifications?
@benyoung87563 ай бұрын
You’ve done well to remove the old bulbs. I’ve managed to remove one but the other was very stiff. Made an awful mistake by using a plier which resulted in the glass of the bulb breaking! Now what’s left is stuck inside the housing 😡
@alireza0713 ай бұрын
Hi thanks for ur time and affort, I know is long time ago how were the head and tail light did u get and warning light in dash and and fogging inside the head or tail light?
@jakehauss72343 ай бұрын
How did u take the sun visors off
@mustafaozgunes73933 ай бұрын
will this also fit on a non s-line?
@scimptaciom3 ай бұрын
why you only got the back windows tinted not the front ones
@jeremy92453 ай бұрын
J'aimerais savoir si cela se monte en lieu et place sans modification ?
@tobyyoung17973 ай бұрын
Hey mate, got the same lights but i have this error code that i can’t get rid of. Did i wore them incorrectly or? There’s there’s two random cables on both sides that don’t plug into anything, is it something to do with them?
@realtrappalini43462 ай бұрын
Have you sorted this?
@tobyyoung17972 ай бұрын
@@realtrappalini4346 yeah it’s hard to explain but basically hat to run a resistor for both the positive and negative drl cables in the wiring loom
@callumglazebrook4994 ай бұрын
Did you use primer, did you sand it, and how many coats of paint and did you clear coat it
@foxxyfox43824 ай бұрын
What's the ground clearance roughly on the mudflaps,any issues with catching on speed bumps,ramps etc
@drinkbleach94434 ай бұрын
Wasn’t ur speedo out cuz u went from 16s to 18s
@S3MiT3X4 ай бұрын
Fuck me that’s a bad one…
@blaked10745 ай бұрын
How did u get cable to reach ?
@keithshouler16825 ай бұрын
Shame the skirts cover the original N badge on the side skirts
@etaos8335 ай бұрын
In few years you are gonna look back at this and think why the hell 😄 Nah really... Although the window covers are kinda practical, have to admit, but they look super out of the place on the car and basically all mods look of really poor quality... I don't mean to trash you, just talking out of experience. Because this heavily reminds me of when we were young and didn't have money for proper mods and looking back we are all like... how silly were we... Except we had old trashed cars, you've got beautiful new one 😄 Try to go with the way of some front splitter, rear splitter, rear wing extension. They are pricier, sure, but they sure look good on i30n. Although avoid the side skirts, since they often require drilling into the metal sides, not plastic which always starts rusting after few years :)
@oliprice16775 ай бұрын
THE N IS UPSIDE DOWNNN😭😭😭
@AJW216 ай бұрын
Where did you get the back badges from can’t find then anywhere in the uk
@05elliotth6 ай бұрын
Ya N stickers are the wrong way round
@samirmurad99696 ай бұрын
Was für ein Klebe haben Sie dafür benutzt?
@sebastianarayaguerra9600Ай бұрын
Poliurethane
@sebastianarayaguerra9600Ай бұрын
The one used on windshields
@MaxTV_CCm126 ай бұрын
Original badges look much better imho. Also, I prefer the old Scudetto over the Honeycomb
@jerzybulwa55676 ай бұрын
Did u use any special paint for it mate?
@MaxWillus-e7g7 ай бұрын
What H7 LED did you end up buying? Brought the headlights but my old LEDs dont fit them
@silvergeek45957 ай бұрын
Se ven muy bien 👌saludos desde México
@kamimaza7 ай бұрын
They're ugly AF
@Snokk107 ай бұрын
Hi! My Blue&Me apparently is dead, so they told me I have to replace it. I was wondering if by installing a screen like you did would solve the problem instead of having to replace the Blue&Me. My odometer is actually blinking and I don’t know how to do the proxy aligment, they tried in the mechanic but did not work. Thanks in advance!
@rics97877 ай бұрын
What bulbs did u use I have same headlights and I’m unsure what ones to get ??
@esmmm9907 ай бұрын
Are these vland ones ?
@gourlsgarage7 ай бұрын
Yeah I got them here: fastlifecustoms.co.uk/products/led-car-tail-light-assembly-for-volkswagen-golf-7-5-mk7-5-vw-golf-7-mk7-2013-2016-up-brake-light-with-turning-signal-light?_pos=7&_sid=b2d8ef934&_ss=r They say out of stock but if you contact them they will order some in for you👌