What would be the best way to run a throttle cable so that the cart can run better
@marte1a2565 ай бұрын
I bought one with a predator 420 motor already in it. I cannot get it to go past 12 miles an hour though and it’s annoying because the joint is lifted and wonderful to ride but too slow.
@racerxtex31775 ай бұрын
You need the smallest sprocket you can get on the rear and a big one on the front’
@marte1a2565 ай бұрын
@@racerxtex3177 mine doesn’t even have a sprocket. It’s just a belt going to some type of transfer case I guess it’s called on the rear end. Is there any way I can send you a video? Just so you can see how it’s laid out
@bobatbilletcreations6 ай бұрын
Nice job, Thanks for sharing!
@DavidSwart-o8p7 ай бұрын
Do you have a reverse?
@davidmiller5717 ай бұрын
It doesn’t look like it. Also others have commented that he doesn’t. You could theoretically put a fwd reverse box where he has the jack shaft.
@racerxtex31776 ай бұрын
No
@Motociclista76011 ай бұрын
Great Job!
@christyc911 Жыл бұрын
Nice job . And thank you for taking the time to make this video . Just curious ..but now you don’t have reverse ?
@racerxtex3177 Жыл бұрын
At first I didn’t have reverse. But later I found gas rear end and swapped it out.
@devthomas617 Жыл бұрын
You are a gas hole you fuck you should have kept it electric you fuck tard
@christyc911 Жыл бұрын
Thanks for the guide on how to do this ! Looks nice and fast …and sounds good
@racerxtex3177 Жыл бұрын
45mph
@jkjgb17m26 Жыл бұрын
Any issue with the chain tension as the suspension travels?
@racerxtex3177 Жыл бұрын
Yes at first. I put a tensioner on it for the travel
@jkjgb17m26 Жыл бұрын
@RacerXtex ok I am getting ready 2 do the same swap. Happen to have a picture of the tensioner?
@racerxtex3177 Жыл бұрын
@@jkjgb17m26 sorry no. And I sold the golf cart
@tjrox03 Жыл бұрын
Hi, just wondering how that rear axle assembly has held up for you. I've heard that the rear transaxle has a nylon gear and can be stripped very easily due to torque from the gas engine.
@racerxtex3177 Жыл бұрын
It worked great. Burn outs was a breeze.
@tjrox03 Жыл бұрын
@RacerXtex thanks for the reply! If you don't mind me asking would you happen to know the year of the cart? I'm currently building one of my own and our frames look very similar, ive been doing research and know club car can be very sneaky with parts! I just worry that with the gas torq-esc 420 engine my Axle spline may strip.
@racerxtex3177 Жыл бұрын
@@tjrox03 1999
@tjrox03 Жыл бұрын
@RacerXtex how was fitting the engine in? I've decided to go alternator setup and im afraid I might have to notch too much out of the frame to fit it and loose structural integrity
@racerxtex3177 Жыл бұрын
@@tjrox03 relocate the alternator
@hankhill5860 Жыл бұрын
I thought about this before but the only thing you won't have his reverse but great job 👍
@mattydelange7679 Жыл бұрын
Super rad
@ournextbackyard708 Жыл бұрын
Do you have a list of everything you bought and how much it cost
@racerxtex3177 Жыл бұрын
No sorry
@travisclaxton7036 Жыл бұрын
It has reverse or no
@racerxtex3177 Жыл бұрын
At first no. But I bought a gas rear end and installed it. Then I had reverse
@dotsllc Жыл бұрын
i would love too do this with mine i have a 94 ezgo but i am not sure i could
@racerxtex3177 Жыл бұрын
EZGO would be easy.
@cabincruiserlittlebigtime84452 жыл бұрын
What hp preditor engine is that and how well will it pull up a hill with 2 people?
@racerxtex31772 жыл бұрын
429cc. It pulled the wife and I really good. 40 mph
@Cherokee-sz7xi2 жыл бұрын
Why is your clutch on backwards?
@racerxtex31772 жыл бұрын
I later fixed it
@Cherokee-sz7xi2 жыл бұрын
What tooth sprockets did you use?
@miataman19852 жыл бұрын
nice cart.What paint color did you use
@racerxtex31772 жыл бұрын
Ford/Mazda 25W red fire pearl
@Cherokee-sz7xi2 жыл бұрын
What size jack shaft did you use?
@racerxtex31772 жыл бұрын
5/8
@G56AG2 жыл бұрын
Very nice job, good looking as well! Well done.
@edbaca69452 жыл бұрын
Nice job what did you use for a gear box so you have a reverse gear .
@racerxtex31772 жыл бұрын
At first I didn’t have reverse. Now I installed a gas rear end.
@chassenmanoi57502 жыл бұрын
What size are the motor shaft so I can order my sprocket. Need help😬thanks
@robertposs38893 жыл бұрын
Great video. Where did you get the muffler?
@racerxtex31772 жыл бұрын
Oreilly’s auto parts.
@raybornwade35683 жыл бұрын
Great job!! My torque converter burnt the belt and tore it all the pieces. What did I do wrong 😔???
@robertposs38893 жыл бұрын
What about reverse?
@racerxtex31773 жыл бұрын
With the electric rear end it was my big foot. I installed a gas rear end now.
@davidcastle653 жыл бұрын
what is the brand and size of pulse pump
@timothyhand60503 жыл бұрын
Where did you get the jack shaft and the bearings at
@racerxtex31773 жыл бұрын
Amazon
@tomwarren52583 жыл бұрын
Looks great I'm trying to take a 88 dies from Electric to gas seeing how you did to jackshaft do you have reverse on yours
@racerxtex31773 жыл бұрын
At first no. But now I do. I bought a gas rear end and swapped it out.
@Kronos23613 жыл бұрын
Really good job. Lots of patience and thought.
@racerxtex31773 жыл бұрын
Thank you. A lot of trial and error. But I finally got it right.
@raysanchez79623 жыл бұрын
I’m in Florida. If I bring you my golf cart can you convert it ? I already stripped the club and put a gas engine , gas rear end.
@racerxtex31773 жыл бұрын
😂
@mack_mandarb3 жыл бұрын
Nice conversion, I see you've upgraded to a gas rear diff. bet that made a world of difference. I wanted reverse and gears so got a 250 4wheeler motor and trans. You could hook stock lights up to the battery and if you turn a cheap alternator off the jackshaft charging system complete.
@nickelnoserestos25983 жыл бұрын
Nicely done.
@garygogo90483 жыл бұрын
Wow, that is bitchen!! Nice work and thanks for sharing!!
@racerxtex31773 жыл бұрын
Thanks dude
@ryanlynch14143 жыл бұрын
Thanks for getting back to me. I’ll be starting mine soon.
@racerxtex31773 жыл бұрын
Good luck.
@ryanlynch14143 жыл бұрын
How fast is your cart? Great video and description!!!
@racerxtex31773 жыл бұрын
45mph
@ryancarroll82953 жыл бұрын
How did you hook up the throttle?
@racerxtex31773 жыл бұрын
From the bottom where the electric throttle was.
@jderouen893 жыл бұрын
How did u get the shaft out the rear end
@racerxtex31773 жыл бұрын
Like out of the motor?
@jaleon273 жыл бұрын
I’m wanting to do something like this on my golf cart but I’m afraid I’m going to mess it up. Lol I’m a welder and can fabricate anything but when it comes projects like this I wouldn’t know where to start
@racerxtex31773 жыл бұрын
Believe me I’m no engineer. I drew it out on paper first. I placed the engine in different spots first before I did any cutting. What kind of cart do you have?
@walterschilling45123 жыл бұрын
could you give me a measurement from the sprocket on the electric motor shaft to the sprocket to the jack shaft roughly.Thanks
@gabyrivera19633 жыл бұрын
Hi what pulley do I use since I see that it is longer than the one that comes from the factory?
@rickgalvan53193 жыл бұрын
What is the muffler you put on that motor I have a 420 Nd want to install a muffler but I don’t know which to choose would you mined telling me the part number of the muffler please thank you
@racerxtex31773 жыл бұрын
I don’t have a part number. I just went to O’reillys and told them what I’m looking for. The smallest car muffler with the smallest inlet and outlet. It was a 1 1/2 was the smallest they had. I think I paid around $40 for it.
@henrygibson29064 жыл бұрын
What size sprocket did you use on the electric motor shaft? Inner diameter and tooth size? Thank you
@racerxtex31774 жыл бұрын
I had the shaft turned down to 3/4 with a 3/16 key way. Then I was able to use a 10 tooth sprocket.
@henrygibson29064 жыл бұрын
Does it have reverse? And what about a charging system to run a radio or lights ?
@racerxtex31774 жыл бұрын
The original build did not have reverse. I do now with a gas rear end. I making a new video of the swap. I don’t have a charger system. Right now I have no radio or lights.
@TheLonesometoad4 жыл бұрын
If you can locate a junk gas car from 1984 thru 1991 you can use the transmission from it. It will bolt in place of the electric motor with NO modifications and will allow you to have Forward, neutral and reverse.
@racerxtex31774 жыл бұрын
I already found one. Installing it as we speak. I’m making a new video of it and other mods I’ve done.
@twanamona4 жыл бұрын
Can I buy it from you
@racerxtex31774 жыл бұрын
Sorry. It’s not for sale. Many people have asked me that same question. I’m modifying as we speak. So far I’ve gotten it to 47 mph. But have steering wheel shake. I’m installing a gas rear end Saturday. Then I’ll have reverse and more speed. Look for the new video soon.
@nobodyizhome14 жыл бұрын
What rear sprocket did you use and where can I get one? Can you send me a link?
@racerxtex31774 жыл бұрын
I had the motor shaft turned down to 3/4 with a 3/16 key way. It’s a 10 tooth. Got it on Amazon.
@frankgomez19654 жыл бұрын
How did u do the throttle set up with the stock pedal?
@racerxtex31774 жыл бұрын
I took apart the throttle resistors and rigged up with a bracket.
@wesleylandry39484 жыл бұрын
How much did the whole swap cost and where did you get the clutch and fuel pump at?
@racerxtex31774 жыл бұрын
Around $500. Amazon
@wesleylandry39484 жыл бұрын
RacerXtex ok thanks!
@SPR13264 жыл бұрын
Hey Racer! Thanks for making this video. I'm working on mine now and wanted to know if you used a solenoid?
@racerxtex31774 жыл бұрын
Just the one on the starter.
@SPR13264 жыл бұрын
@@racerxtex3177 Thank you sir. That's what I was thinking would be the one to use.