Thanks so much. I thought of making the video for you guys right after I emptied it! Glad I could help.

Probably because of a sensor detecting that it's not empty so it doesn't ramp up the speed to full.

My baby was sleeping! I hope you still got some good information from it.

No clue where localidad is but I hope the video helped you!

My baby was sleeping! Hopefully it still helped you!

What's leaking also?

@@robert997 underneath the washer I'm not sure where the water is coming from but I know it's coming from the washing machine and it just barely spins now well really slow

Thanks Mohamed. He was the best.

Try unplugging the washer for 5 minutes, making sure you do a smaller load first, then check the drain plug again.

I looked up the Samsung code UB and it says typically, the Samsung washer error code UB is called: unbalanced load (too few / many things); twisting of linen; non-observance of the rules of washing (lack of a bag for shoes, improper combination of fabrics). Hope that helps.

@@robert997 yea the ub eventually goes away (I cleaned the filter again) but the main problem for me is that when it’s on spin, it doesn’t spin fast enough- the clothes are soaked so I have to wait a few hours then put them in the dryer

Mine does this aswell. Have you fix this issue?

My pleasure. Glad my video helped you!

Good Morning Ruth, beautiful indeed. I'm glad the washer is working for you again. That's a big relief. As for the dryer, are there any error codes or lights flashing? The dryer vent could be blocked or the breaker could be loose. Make sure the lint trap is cleaned before/after each cycle. Try taking off the exhaust pipe and running a cycle to see if it works. If it works, then you know you have a clogged exhaust pipe. You can also try running it without any clothes or a very small amount of clothes to see if it runs.

Wow sorry to hear that. Try using a slower spin setting. If your washer doesn't have that or if that doesn't work, try calling a local washing machine repair service to take a look. It usually only costs one hour of service to diagnose the problem. It's definitely worth doing.

That's awesome Steve. Glad I could help 👍

My pleasure. I hope it helped 👍

instablaster...

Even with the pedestals attached?

@@nosmokingzoneWasher sits on pedestal; on mine, you open the drawer and the three screws holding the bottom of the panel on the machine are easily accessible. Kenmore put all T-20 Torx type screws on mine. You can get T-20 screwdriver, or get a hex drive set of Torx bits and use a hex driver to do the work - if the driver is not magnetized, the bit will fall out and roll under the pedestal every time the driver w/bit is pointed down. Wera bits and screwdrivers are made to hold the bits on tightly while you're using their brand of tools.

You my friend are a genius.

@@robert997 good video, also, two Robs make a right!

Ha! Sorry I was constantly practicing my indoor voice because of our baby.

Volume is fine..maybe you need to turn up your volume or buy better speakers.

Use captions

I believe I used a Torx bit in my cordless Bosch drill. It took me less than two seconds per screw.

My pleasure Greg!