@@BoostedBDF yessir. No modifications needed.

@@BoostedBDF I'm not sure on the Whipple since it is wider but I know the ROUSHcharger fits under it.

@@kalyndiehl7555 Camera Bracket: 68566612AA

@@MrJeepCanada check Etsy you may have more luck there

@@icetrae91 yeah if you are replacing them all together it's easier to take the bumper Off. Not hard to do. If you're buying the ones that stick onto the front, you don't have to take the bumper off at all, but they're likely to come off.

@@dksgarage6061 yea i thought this was just a 123 thing tbh like everything else i just did lol.. iv seen vids were people take the whole bumper off, they pry just the foglight caps off, or they had the sticky stuff and just went right over original covers thats why i was getting confused. i actually just had my front bumper replaced to so thats why im not really trying to take it apart again.. iv seen others just plasti dip all the chrome i might just do that since its only the fog lights

@@Max1m1lli0n due to copyright laws there wasn't a whole lot I could play through the speaker anyhow

@@davidflowers4057 video your truck and it'll do the same thing. It's just how LEDs work with cameras.

@@_z06_vette47 these are the OEM ported ones. You send your stock ones in as cores. Now, Frankenstein does make some aftermarket ones that might be more of a gain but are pricey

@@carlosportillo2640 yes it should

@@carlosportillo2640 I think it might yes

@@nestorthepestor9147 heat gun and a plastic razor. Then goo gone

@@therod785 it's been sold.

I don't actually know but I do need to do a detailing on it so when I pull off the wheels I'll try to remember to measure

@dksgarage6061 OK thanks please do if you can remember!

Thanks! It's not easy to mod 3 different vehicles and have a full time job hahaha

@@dg98adams yeah I've heard stories of just about every brand. AAL, Quake, Rugged Ridge. None of them seem to last

@@dksgarage6061 this last set I cut a relief in the bracket so the cord is not pushed into a hard 90 degree bend. We offroad so it could also be water intrusion. I have 2 sets to take apart and look into repairing. Good luck.

Stock wheels are like +43 or something so the +20 with wider tires does stick out further. The closer you get to 0 the more it will stick out.

​@@dksgarage6061​thanks for the quick response. Yeah I looked up what my current wheel (I have the OEM 20" wheels) and it says ET55. So its just moving down towards "0" from that number, you don't have to go to a negative number per say? And like you mentioned you had a little rubbing on the inner liner but no issue hitting the suspension component? And last Question, so for sure you need to purchase those new leveling/lifting air links because stock would cause an issue?. I see that you no longer have the vehicle so I thank you again for being able to answer my question(s) still. I Just bought my '15 GC ecodiesel with the quadra-lift a few months ago and am learning this whole new platform/setup

@@saint_keeblerElf yes I think you would need the level links if you were to go larger tire or a different offset wheel.