Thank you sir

You can unclip the seams if its a snap lock. Start at one end and run it up the seam. You'll have to remove that section of ridge cap and Z bar. It's unlikely that the colors will match though. Good luck

I think you are referring to a hip roof.? On the hip ridge, first Lay your ridge out and sure it's straight, mark each side. Install your z bar flashing 1/4 to 1/2 inch inside those marks. Rivet the ridge to this continuous z. If it's too tight it will buckle and leave small dents on every standing rib. Hips are tricky. Ridge must be bent on the correct pitch as well. Good luck

@MandMconstruction thanks I'm thinking about using the manufacturers sheet forming machine and roll through marine aluminum to form the roof profile and bend to 45 degrees at 4 inch coverage on each side of ridge . Might dent, though. Don't want to weld the joint seam to achieve the 45 cap angle . The pointed ridge cap looks great compared to the same old flat sheet ridge cap. Tricky problem for me. Andrew Nz

They are snap lock panels. Yes directly to a deck with a high temp underlayment is best. This was a retro fit over an existing roof, which is why it has the furring strips and a radiant barrier insulation. The transition and valleys both have a cleat installed to hook the panels to, this cleat has 1 inch butyl tape under it before it is fastened down to the roof. Hope that answers everything for you. Have a great evening.

@@MandMconstruction Super sweet. I plan on tackling it myself. Was going to cover 45x12' so going to buy enough panels to cover. Get box gable for the sides and drip edge at the botoom. Other than butal tape and some fasteners with the rubber seals anything else i need?

This is a standing seam roof. No fasteners are exposed. Check with your vendor for recommendations on what type of metal roof best suits your needs based on function, roof pitch, cosmetics, and budget. They will reach have different specs and accessories. Standing seam requires clips and fasteners that are covered by the next panel, z bar, offset eve, open hem ridge and gable etc. You may want a PBR commercial panel if it's a low pitch.. Good luck to you sir. I'm sure you can handle it just research the manufactures specs.

English please

I'm not sure. Call your roofing contractor back out to take a look. They might need to replace that 1 panel or rivit a tab over it. Hard to say without seeing it...

You spelled Biden wrong.

@@ArkanZen You could be right, because "President Biden" is the direct result from having had "President Trump".

If you ordered flat pans without striations or mini ribs then it has oil canning. Most vendors require you to sign a waiver at the time of the order warning of oil canning. This will show where fasteners and clips are applied usually. Feel free to send a Pic 601.750.2274 or [email protected]

They literally used sleepers

The fasteners hold the clip down and are covered by the next sheet so no fasteners are exposed. Also, the clip allows some movement for expansion/ contraction. The runs on this roof are so short that expansion and contraction aren't really as much of concern compared to 40 ft long runs.. thanks for watching!

Thank you sir

Headed to work. Maybe I can do some pretty work on a floor that someone u Kno what up

How we gonna make it in this new world? I really asking. I need someone to talk to. Pls help me man

John Doe.... it's 26 gauge