Will this do a Mercedes Benz E class 2019 W238

W238

How do you remove the old one and what solder wire do you use? Do you dermal the old one out ? Thanks

Could you show how to open the TCU after releasing the clips?

Can you tell us what is common fault and symptoms

Hello master good evening I have question please can you help me?

Hi Team! I have a Benz A170, W169, year 2005 (Automatic), still running and serviced regularly. The issue with the car presently, is that when starting (fresh from rest), the transmission is somewhat 'choked' and the drive reduced. The indication then is 'Transmission..'. But, once the engine is turned off (obviously) and started anew , after a few minutes, everything works properly. When 'warm', car is ok. Recently, this has happened more than once during the same journey, after 'fresh' start. Again, after turn-off and turned back on after a few minutes, it worked good! The fluid level is ok too. Note that this only happens after 'cold' start. System hot - no problem. If anyone could comment and share similar experience, it will enable me to understand the issue, please. Many thanks!!!

How do You tal out the board after desoldering al Pins?

Hii, I have a Mercedes M6 diagnostic device. Can I code the ELV module and start the vehicle with it? Thx

Is it smp 132-192 and smp 132-532 same sensor?

good morning. Do you have the schematic of the cat 320d hydraulic module.

excellent work 🇻🇪💪

Heyy sir please answer me this suitable for my nissan a33 cefiro 2003 model VQ20de engine?

What did I just watch?

Hi, where did you get the cable controller?

Р074100 че за ошибка

www.youtube.com/@thiagosantos2541

Hallo friende kann i have you gmail or watsap number?

Das brauche Programm

Super David how are you doing? I have Hino Ranger no signal on injectors. Kindly help

bnas . trdes. el precio del componente

This sensor is for clutch 1!

Hi David how can I setup this test platform

спасибо брат

Can this do vag and bmw

Terminal15N<1 No voltage issue

Hi, how we can test remote . ?

Hi tiguan 2012 dq500 p175d00 clutch opens unintentionally. Car jolts hard to get into gear when first starting engine and selecting D or R. Can fix by turning car on and off when suspected the issue is there on start up in D. Is it clutch position sensor or the hydraulic clutch pressure valve ?

W204 kasalarda kendi anahtatı olmasada Ezs'yi dönduruyo,elv olmadan testi göstermemişsiniz

Ond consigo comprar esse equipamento?

Hi does this act as a gateway looking to connect 7G tcu and read live data not just renew ?

Замена датчика помогла исправить неисправность акп gle. Спасибо)

Mantp

Cela fonctionne sur class c w205?

The Benz dealership will charge you $1300 to fix it here in GA ((USA )) when in reality all you need is a $20 part.

I have the same problem with skoda kodiaq 2L 2019 can I use P173500 -P173600

Where are you from?

Hello guy❤

Thanks!

Very nice 👌 is there any system available for newer cars 213, 222, 223 etc ??

Wtf is this shit😂

la conexion del motor esta soldada a la placa... no sale como lo has hecho de ninguna manera... primero desoldar y luego la puedes extraer. Tambien puedes quitar los cuatro pasadores y tendras acceso al motor.

Me manda el whatsapp

Is this still available ?

buenas. amigo los sensores de tiempo del motor c6.6 son inductivo o hall ? se le puede medir la resistencia ?

How much?

Did you use power supply for battery o no need to ?

Hi Name of K2882 Price?

Price ji?

Hello , I purchased this do I need gateway to communicate with Cas and Dme?