Пікірлер
@paulvinyard 28 күн бұрын
It`s a Miracle you were able to get it done with that rig. Have you attempted the Yam. 61A bushing, without the front and Aft guides..?
@itszo4168 29 күн бұрын
ru-glyde is what we used when i worked for a marine prop repair shop for 7+ years. Also we have the press and cones for the job. But you can't lick your fingers when using ru-glyde.
@johnherazo3376 6 ай бұрын
Como puedo conseguir esa herramienta para poder colocar el buje
@brittmarchbanks5527 6 ай бұрын
I have been running the prop on my 200 yamaha. I haven't had any slipping issues
@AudreyHaake-pi5vy 7 ай бұрын
Wanting to know if this worked. Afraid prop may slip under load. Will look forward to hearing back. Appreciate your help!
@brittmarchbanks5527 6 ай бұрын
So far I haven't had any issues. I have probably covered around 100 miles with it.
@michaeldeangelis9877 7 ай бұрын
How did you make that funnel tool?
@brittmarchbanks5527 6 ай бұрын
Go to A-1 race supplies and but a SS exhaulst reducer. Then cut it at the exact spot that matches the ID you need. Then I basically cut out a large washer out of SS sheet. Then welded that to the base. Thank for your question