Dad Life Texan

Пікірлер

@dissectingdiy 5 күн бұрын

I usually run wires through the door. There’s these ports that make it really easy and you don’t have to cut that boot.

@adrianmartinez7170 7 күн бұрын

Soooooooo it’s just there with no purpose 🤔….. have you installed a led bar or something to the switch panel? If so can you do a video of connecting something to the switch board.

@navyav8 21 күн бұрын

love mine too man ...

@RonnRicco Ай бұрын

Don't be afraid to show more butt next time, it's nice ;)

@artiemcbride629 Ай бұрын

Useless, why wouldn't they add enough pipe to delete the useless flapper.

@dadlifetexan Ай бұрын

you could probably get away with cutting the back pipe a little closer to the muffler than I did and that would give you enough on the delete pipe to get rid of the flapper as well, I just did mine by following the directions in the package, but I have seen other guys do it a little different and were able to get rid of the flapper as well

@arhtxcabinetsmillwork Ай бұрын

“I’m in Houston and I’ll never need a snow plow.” February has just entered the chat.

@dadlifetexan Ай бұрын

every like 5 years lol

@acedogg692005 Ай бұрын

It's weird that the lights don't blink to tell you which tire to go to. My 2016 sierra did.

@Ivanadrama87 Ай бұрын

The 2nd gen Cruze is overly complicated should have kept this design

@marklucas2591 2 ай бұрын

Argh the music!!

@dadlifetexan 2 ай бұрын

Yeah my bad on that lol

@bus-fun-addict 2 ай бұрын

Worked great around my gas filler neck.

@dadlifetexan 2 ай бұрын

Right on

@outlawmultigun7076 2 ай бұрын

Bad bad bad too loud music

@dadlifetexan 2 ай бұрын

Yeah my bad on the music

@udoerwin 2 ай бұрын

Thanks, this helped me replace the starter om my R850R which saved me a few hundred euros. And yes, one should first disconnect the battery.

@dadlifetexan 2 ай бұрын

Awesome, good to hear

@myTrailer_rental 2 ай бұрын

Did you do the long term effect video? Just curios, I didn't seem to find that if so.

@dadlifetexan 2 ай бұрын

Unfortunately, the jeep was totaled shortly after I recorded this video so I wasn't able to do the follow up video

@myTrailer_rental 2 ай бұрын

@@dadlifetexan Ohh no, hopefully you where ok. Thanks either way, like the video, about to dig into it myself.

@champie2323 2 ай бұрын

Does the reset tool work for adding larger tires, or do I need something else? I have 33s and new moto rims.

@dadlifetexan 2 ай бұрын

Assuming you kept the factory TPMs sensors it should work. If the new tires and wheels came with their own sensors then I’m really not sure.

@ryanperry4634 2 ай бұрын

Sounds good! Quick question... does it sound funny when it goes into 4 cylinders like a helicopter? Did the same thing to my wifes 2022 tahoe and got that helicopter effect. Ended up putting the muffler back on 🤷

@dadlifetexan 2 ай бұрын

I actually ended up wiring the flapper valve open all the time so I never really had that issue

@wytejonez 3 ай бұрын

I'd clean the torch then polish

@dadlifetexan 3 ай бұрын

Good idea

@v3lcro_usr 3 ай бұрын

Torch method would be good as a one time thing. Then just keep on top of it once a month with a good black polish to maintain color. Good video

@dadlifetexan 3 ай бұрын

awesome, thanks

@ItzCassie312 3 ай бұрын

also if u can’t clean the white part at the bottom use nail polish remover it’s works

@dadlifetexan 3 ай бұрын

thanks, i'll have to try that

@XdragonPie 3 ай бұрын

I use the torch and let cool befor I using the plastic product . Works great using both techniques together.

@dadlifetexan 3 ай бұрын

That's a great idea!

@bossjpro8432 3 ай бұрын

What do you use?

@myname9407 3 ай бұрын

Wait why cant i thonk if a downside to this😂

@dadlifetexan 3 ай бұрын

lol

@PaulTamayopaintingismypassion 3 ай бұрын

Why not use both methods. Burn it. Seal it.

@mpogca 3 ай бұрын

Just received this device yesterday from Amazon. Used it today on my 2022 Chevy Silverado High Country and it worked like a charm. Hardest part was finding a 9v battery. Thanks.

@dadlifetexan 3 ай бұрын

Haha yeah not something I usually keep around either

@RegisTraiter 3 ай бұрын

Pushed dislike with the greatest of satisfaction just for this crapsack earrape music.

@COPENNY2 3 ай бұрын

Good video. Just reset my sensors on my 21 AT4. Thanks.👍

@dadlifetexan 3 ай бұрын

Awesome man, glad it helped

@carloslamprea3521 4 ай бұрын

Nothing like a good candle to remove all the bad things 😂

@dadlifetexan 4 ай бұрын

lol exactly

@playz_is_a_botgrant9438 4 ай бұрын

Is it road legal? Like noise compliance?

@dadlifetexan 4 ай бұрын

Completely legal here in Texas

@davidhaney1394 4 ай бұрын

I know this is a long time ago now , but, why didnt you just service the starter ? 30 mins job .

@dadlifetexan 4 ай бұрын

Probably would have been the better option

@HarryParker-v1z 4 ай бұрын

I found a McQuires Hot Shine Tire Coating spray that I use on my plastic parts. You have to be careful to wipe it off the paint. But it’s fast and works great. Not the foam stuff. It’s an aerosol spray.

@dadlifetexan 4 ай бұрын

Awesome, thanks for the tip. I’ll have to check it out.

@stianh.1195 5 ай бұрын

No follow up? 😥👎

@dadlifetexan 4 ай бұрын

unfortunately, this jeep was totaled shortly after I did this video

@matheusresend3 5 ай бұрын

Hey man I’m interested in getting the same delete, do you still recommend ? Have you had any issues?

@dadlifetexan 5 ай бұрын

No issues at all, everything has been good

@PrestonFarney 5 ай бұрын

could you use a heat gun insted of a torch?

@PrestonFarney 5 ай бұрын

heat gun works ok, but i think blow torch would work better

@dadlifetexan 5 ай бұрын

you can use a heat gun, but the torch is definitely faster

@PrestonFarney 5 ай бұрын

@@dadlifetexan ok, thanks

@joshtrotter4878 5 ай бұрын

Do you have a link to the tool you used? I purchased 2 of these on Amazon and neither one worked like the one in your video. Thanks for your help.

@dadlifetexan 5 ай бұрын

oh man, no good...here is the link to the one I bought a.co/d/87qWcxL

@vevenaneathna 5 ай бұрын

ha, there is a reason they are going to thermoplastic (uhmwpe) for the next gen stealth fighters. so easy to repair with improvised tools.

@dadlifetexan 4 ай бұрын

Ha nice

@twicetrader 5 ай бұрын

it doesn't last. Actually you are exacerbating the problem. A couple of weeks and there you go

@dadlifetexan 5 ай бұрын

Yeah haven't found anything that actually lasts, any tips?

@twicetrader 5 ай бұрын

@@dadlifetexan Nope, only temporary remedies kzbin.info/www/bejne/jomyiWewa9qqjtE If you love hard work and the other side of plastic part is like new you could go with this plan kzbin.info/www/bejne/fKjOkJmEesp7bLM This is the most effective way but also time consuming. If the area is too large, go for painting like Trim Black by SEM Products for black parts. My 2 cents

@Jay-ju9jw 4 ай бұрын

It’s called Pro tex, by pro xl. The best yet.

@ITSJBTV 5 ай бұрын

Hey, I think the torch was the best way to go, the heat brings the oils in the plastic out and it is pretty permanent Vs the other, you will have to redo it a lot to keep it that way. And don't worry about the trolls and the negative comments, we all get em lol. P.S. I looked for the next video you said you were gonna do later on, I see you didn't make anymore showing how they looked months down the road, which is looking best today? 👋🤠

@dadlifetexan 5 ай бұрын

yeah, if it works it works! couldn't do an update video because the jeep was actually totaled shortly after the video was recorded...

@benpeters5703 6 ай бұрын

Two words. Donkey gelatin. Works like magic.

@dadlifetexan 6 ай бұрын

interesting

@QueensK718 6 ай бұрын

The torch is the way to go bro, thanks for the video!

@dadlifetexan 6 ай бұрын

yeah man!

@rebarguy4051 4 ай бұрын

Or shoe shine

@insane4wheeler1 6 ай бұрын

Torching them last about 2 weeks then its worse. Back to black sucks too

@dadlifetexan 6 ай бұрын

Anything you recommend?

@insane4wheeler1 6 ай бұрын

@dadlifetexan I used duplicator trim and bumper paint on my van bumper. It has a few scratches in it now, but it ain't faded white anymore. Thinking about putting another coat on it. Its been 2 years.

@dadlifetexan 6 ай бұрын

I’ll have to check it out, thanks!

@MerphSleds 6 ай бұрын

Just curious if you have the 5.3 or the 6.2? A lot of exhausts I'm finding are saying they're for 3" exhausts, when the exhaust on my 5.3 is 2.75". Has me hesitant on ordering them if they're not gonna fit.

@dadlifetexan 6 ай бұрын

5.3

@MerphSleds 6 ай бұрын

@@dadlifetexan Yeah i re-watched the video after and realize you said it in the beginning! Appreciate the answer all the same! Pipe should be here tuesday for my truck!

@dadlifetexan 6 ай бұрын

@@MerphSleds awesome man, you're gonna love it

@robertozapata9719 6 ай бұрын

How does it sound inside while driving?

@dadlifetexan 6 ай бұрын

Better than stock but honestly not that much noise

@TheEvilTwinCG2 6 ай бұрын

McGuire doesn’t work on my 2002 crv.

@dadlifetexan 6 ай бұрын

Found anything that does?

@wyatthaskell9988 6 ай бұрын

I have a trailboss. I could never hear it idle until I deleted it.

@dadlifetexan 6 ай бұрын

Exactly why I wanted to do this

@rachelg400 6 ай бұрын

How long did the torch hold up?

@dadlifetexan 6 ай бұрын

It lasted for a while, but unfortunately, this jeep was totaled about a month after I recorded this video...

@rachelg400 6 ай бұрын

Oh man! That sucks!

@aprustic_creations 6 ай бұрын

I'm finishing up my coffee and heading out to chop off the HUGE muffler and replace with the muffler delete by MBRP. I too will be leaving flapper valve for now and then possibly do the spring mod to keep it open. Likely I'll run with this until I save up some sheckles for the full cat back. Truck sounds great man, nice job!

@dadlifetexan 6 ай бұрын

Awesome, glad you enjoyed the video!