KilnParts

Пікірлер

@siufergonzalez8167 2 жыл бұрын

What happens afterwards? How do you test if you did a good job? Is the smoke normal when firing new elements for the first time. My graph flat lines and it didn’t ramp up. Smelled like burning and there was smoke inside is this normal? I really wish scutt had not videos. How about diagnostics? What is supposed to be normal? Not enough info in manuals to understand diagnostics 😢

@melissanelson1926 Жыл бұрын

I have had really good customer service when I call. If you can't find what you need- I would call :)

@selcouthconcepts 2 жыл бұрын

Best informative raku video I've seen!

@christiecomstock3009 2 жыл бұрын

Should I have the plugs in the holes to start? Or add them as the kiln runs?

@abdulazizalkhabaz1981 2 жыл бұрын

🌺🌺🌺🌺🌺🌺🌺🌺👍👍

@wisdomwisdom817 3 жыл бұрын

Is it OK to have a fan blowing at the kiln in the garage ? It seems it effects the temperature rise.

@mikewatson5281 3 жыл бұрын

Hello is there a way to set the temperature to 450 degrees and stay there?

@TheRakuman 3 жыл бұрын

Yeah.... use your oven in the kitchen. 😂

@markspc1 3 жыл бұрын

The narrator has an annoying voice !

@EarthNationCeramics 4 жыл бұрын

Is delay just the word for a hold while the temperature comes down? I'm trying to put a hold on my kiln at 1500 degrees for my bisque but I don't exactly know how to program it in the skutt kmt 1027

@ellakrohn8266 5 жыл бұрын

I dunno about the design of this kiln, the chimney is directly above the flame, meaning most of the heat will just rise straight out the top, seems like you'd loose a lot of heat unnecessarily, seems a bit inefficient.

@corvusmoonpottery 3 жыл бұрын

The shelf is actually between the port and the flew, causing the ClayDog kiln to act (and actually be) a true up-draft kiln design.

@cindymillergirl3537 2 күн бұрын

That hole on the top serves an important purpose. You need to look into it and determine when your glazes have melted and are ready to come out of the kiln. Without this top window, it would be impossible to make this determination. The glaze should look smooth and glassy and have melted. Be sure to never look directly into the hole. Rather, watch it from an angle.