Tom Lowrie

Пікірлер

@Hyprmtr Күн бұрын

I finished my 50% Laser a few years ago. It flys great. I have a build video and flight video on my channel. Have you worked on yours anymore?

@johna.s.3847 3 ай бұрын

RMJ rings come pre gapped. I have been having problems with a Stinger 15cc weak compression from new. Poor idle and unreliable. They claim 2 gallons of fuel will break in the ring. Thats BS. That would be over 8 hours of continuous running. The end gap was .015 ! Gallons of fuel through an engine will not make that any better. Ordered a new ring from RMJ pre gapped at .001. It should break in enough to fly with 30 minutes of running. Obviously Stinger engines have QC issues.

@anujregmi4582 7 ай бұрын

do you have more videos on this

@Hyprmtr 11 ай бұрын

Did you finish this Laser? I been flying mine for the past year or so. It flys so good.

@Clownworldmatrixviewer Жыл бұрын

I’ve got to convince my boss that he needs an RC airplane strip on his big awesome field🤞🏼

@christopherknee5756 2 жыл бұрын

The density of resin is 1100 kg/m3 and the density of paint is 1200 kg/m3. So, by removing the top layer of resin and replacing it with paint, no only adds weight, but makes the construction weaker than before.

@AHETom 2 жыл бұрын

Paint is not used to fill the weave. Not removing the resin to save weight (although it does help), it's to provide a consistently smooth surface to then be sanded and filled. When the resin is left on the surface is not consistent and it can be easy to sand through the cloth in one area and leave resin in another area.

@ASK-fm6kl 2 жыл бұрын

Wonder you didn't check the ring gap clearance?

@AHETom 2 жыл бұрын

It was pregapped prior to the video

@AHETom 2 жыл бұрын

agreed shoulda mentioned it

@dwaynejohnson7499 2 жыл бұрын

Like it where I get one to buy?

@doncunningham3124 2 жыл бұрын

Wow! I wonder how much peel ply (and $$) I've wasted over so many years?! Great tip! Thanks!👍

@swaldoski 3 жыл бұрын

Thanks you for sharing. I would of never thought to use TP.

@scottdunlap4109 3 жыл бұрын

You don't get toilet paper fibers?

@AHETom 3 жыл бұрын

Nope and if you did they would sand off easily with 400 prior to priming

@keithrush4168 3 жыл бұрын

Are you doing a build thread? Sure would like to follow along.

@josephrcampisi1548 3 жыл бұрын

Excellent

@joseaechev 3 жыл бұрын

???????????????????????

@timothyroth8073 3 жыл бұрын

Awesome !

@Hyprmtr 3 жыл бұрын

Is this the G&L Hobbies 50% laser?

@AHETom 3 жыл бұрын

No this is a custom built 50% Laser

@Hyprmtr 3 жыл бұрын

@@AHETom Ah ok. I’m about to build one myself. I will use foam rib wing and a built up fuse. I will power it with a 3W 342cc. It will have similar construction as the old Jack Strickland and Brad Shepard Lasers.