Mini vs Mustang Promo
1:57
9 ай бұрын
Пікірлер
@777-Crypto
@777-Crypto 5 күн бұрын
I’m replying to this just because some people obviously have the issue I had but I can’t find an answer online. Our 2010 R57 has NO retaining clip for the bulb. The bulb twists into place. So if you have no retaining clip turn anticlockwise about a 1/6th or a turn and it will pull out. I can find nothing online detailing this.
@HAASMINIMILL1
@HAASMINIMILL1 6 күн бұрын
Pointless
@tricky3746
@tricky3746 14 күн бұрын
Good video, pity the adverts for the next post cover the final part🤔
@jeffcunningham9632
@jeffcunningham9632 23 күн бұрын
Pitiful! You read the directions with no real video. Thumbs down!!!
@akbo47
@akbo47 27 күн бұрын
Thank you. This was very informative as I am looking at a 1966 mark III that was modified and it has a 1275 engine what I have learned from your video.
@koupdude
@koupdude Ай бұрын
Do they have mechanical attachment?
@Samglax
@Samglax Ай бұрын
This video saved me. Had no idea the auto shop I got my car back from unplugged the power cord to my headlight!! I didn't even know that was a thing!! I was freaking out and no one else mentions this in any other video. You are a gift on this earth my dude. Thank you so so much!
@geoffburch9389
@geoffburch9389 Ай бұрын
How do you id an hif44 when there is no tag on it?
@minimania
@minimania Ай бұрын
Measure the area where the butterfly is - if it's 1.75" it's an HIF44.
@geoffburch9389
@geoffburch9389 Ай бұрын
@minimania hi there thanks for your reply. I should made my question clearer. I have an hif44, there is no tag on it and I want to get a refurb kit for it. There are so many kits I don't know which one to get
@minimania
@minimania Ай бұрын
@@geoffburch9389 the kits only vary in the parts included - they're not specific to different types of HIF44's.
@freddy1jumper58
@freddy1jumper58 Ай бұрын
could anyone actually SEE?
@freddy1jumper58
@freddy1jumper58 Ай бұрын
I couldnt see the wires or anything.. Are you just showing off? Looking for people to just take it to a pro. tired of this Hitler car and wanting to get R Done… You wer NO help to anyone.
@Mario-nl7jl
@Mario-nl7jl Ай бұрын
🤩👍👍👌👌💪💪👋👋👋👋...
@BrannuStudios
@BrannuStudios Ай бұрын
How do you disable the light? I like most people use my visor as a sun visor so it's draining the battery if it's all the way down especially if it's holding up a sun shade
@minimania
@minimania Ай бұрын
The lights shouldn't be on with the car turned off.
@mrcannongg
@mrcannongg 2 ай бұрын
Sounds so damn good
@sparrow4809
@sparrow4809 2 ай бұрын
fantastic! thank you for the great video!
@mikeyjohnson6610
@mikeyjohnson6610 2 ай бұрын
Is the green light supposed to stay on when i shut the car off?
@minimania
@minimania 2 ай бұрын
Yeah, it will eventually go off. Not a problem.
@mikeyjohnson6610
@mikeyjohnson6610 2 ай бұрын
Okay one more question what's the difference between the red light and the green light?
@minimania
@minimania 2 ай бұрын
@@mikeyjohnson6610 green is the less aggressive range, red the more aggressive - green is "Sport" and red is "Race".
@herenow2895
@herenow2895 3 ай бұрын
That's a very light flywheel. What cam were you running with this engine ?
@johnjohnson-zp8gz
@johnjohnson-zp8gz 3 ай бұрын
nice - I enjoyed the good info
@briancornish5857
@briancornish5857 3 ай бұрын
Maybe very simple but thank you for the reassuring tutorial. 👍( 2005 R53 JCW)
@Robbie-mw5uu
@Robbie-mw5uu 3 ай бұрын
is this same for bmw i3 2014?
@Robbie-mw5uu
@Robbie-mw5uu 3 ай бұрын
yep the bmw i3 has same wiper as Mini Cooper Countrymen I just did it
@daledawson1102
@daledawson1102 3 ай бұрын
WTF?
@dirgemoot
@dirgemoot 4 ай бұрын
I just had to comment .... a video about replacing the pads .... at the moment he took the pads off, camera was on dude's butt ... great job!
@annabognuda2417
@annabognuda2417 4 ай бұрын
Dove potrei comandarlo ?
@richarddamico9894
@richarddamico9894 4 ай бұрын
Great info, now I understand tire sizing
@peterchesney5923
@peterchesney5923 4 ай бұрын
Watching the video so you can explain what you're doing 🤔
@asepkusnandar5110
@asepkusnandar5110 4 ай бұрын
Please gearboxs automatic mini clasic
@parttimetourist
@parttimetourist 4 ай бұрын
It should be a 2 Litre Engine with 4 valves per cylinder twin cam cross-flow head and 2 DCOE 45 webbers😄
@christiantorres3482
@christiantorres3482 4 ай бұрын
I need that front windshield for one like it, it is still available on your website
@TheAdamwest29
@TheAdamwest29 4 ай бұрын
Maybe a dab of blue thread lock on those bolts. I fear if they back out at all, we're gonna have a geyser.
@ทดสอบระบบ-ห4ห
@ทดสอบระบบ-ห4ห 4 ай бұрын
In Thailand Where l can buy it
@checkpointcharlie1788
@checkpointcharlie1788 4 ай бұрын
Does anyone know what the difference is between the 'center-change' gearbox, and the 'close-ratio' gearbox? And when the change was made to 'close-ratio' gearboxes?
@mattkott6740
@mattkott6740 5 ай бұрын
I’ve done a few of those coolant pipes behind the engine. Learned the hard way that it pays to pull off the manifold since that’s the only way to make sure the oring seats correctly in the back of the pump. I also use the dielectric grease since without that it’s impossible
@CaptainFury767
@CaptainFury767 5 ай бұрын
I have a 67 BJ8, very similar wiring, so this was helpful. I've put in blade fuses to the switched components, but the hot (brown wire) leads are unfused as original and concern me a bit. Sorry if I missed it in the various fuses, but did you (or do you recommend) placing an inline fuse in the hot lead going to the ignition switch? Or any other brown lead for that matter? Thanks.
@minimania
@minimania 5 ай бұрын
Not unless it's something prone to failure or shorting. If those ignition switches are fairly robust I don't think I'd worry about it.
@CaptainFury767
@CaptainFury767 5 ай бұрын
@@minimania Cool, thanks for the input.
@Rob-fx2dw
@Rob-fx2dw 5 ай бұрын
To remove the bearing just put a wooden block against the axle with the axle nut on few turns and install the wheel you took off to press it up agaisnt the block by tightening the wheel nuts. It should remove the hub easily when you tighten the wheel nuts against the block of wood.
@ramonamonamonie
@ramonamonamonie 5 ай бұрын
bro skipped the most impportant part on how to take the mirror off
@PICADALOL
@PICADALOL 5 ай бұрын
How high can the vmaxx coilovers go? What's the minimum height? thank you!
@ignaciogonzalez4699
@ignaciogonzalez4699 5 ай бұрын
Thank you! Brief and effective!
@SolarControlPgh
@SolarControlPgh 6 ай бұрын
Great video. Do you sell the cover with seal and premachined? Also is this the same for a 1098?
@minimania
@minimania 6 ай бұрын
Yes, the covers are available in new castings these days with the seals already installed. The only ones we have currently have are for gearbox rebuilds but they are available from ESM in the UK, too: www.morrisminorspares.com/gearbox-c76/gearbox-all-o-h-v-models-gearbox-c79/gearbox-front-cover-r-h-d-with-oil-seal-modification-1098cc-new-p830914 That one works for LHD Sprites/Midgets and RHD Morris Minors with ribcase gearboxes (1098 and 1275's).
@আবুবকর-ন১ধ
@আবুবকর-ন১ধ 6 ай бұрын
fantastic video to never to do like this 😂😂😂😂 take expensive pad but poor for brakereset tool and if car on jack never put your legs lower car only idiots do it and once 🤣🤣🤣🤣 if car drop it was your first&last walk. bullshiit horrorable video 🤮🤮🤮🤮🤮🤮
@FelixGonzalito
@FelixGonzalito 6 ай бұрын
Thank you very much
@olafarndt
@olafarndt 7 ай бұрын
Thanks a lot from Germany! 👊😎
@sonidosdepoesias1847
@sonidosdepoesias1847 7 ай бұрын
Recording person sucks
@davidlawhon9303
@davidlawhon9303 7 ай бұрын
Thank you, you really helped me out! Thanks again!
@alexmstudio
@alexmstudio 7 ай бұрын
Amazing work!
@vincentchan6741
@vincentchan6741 7 ай бұрын
Thanks for the comprehensive video. As an aside, is it just me … or is anyone annoyed as hell that the entire visor needs to be replace just because the cover falls off? Why can’t only the visor cover be replaced?
@misottovoce
@misottovoce 5 ай бұрын
No. It is just the mirror COVER that needs to be replaced. The lights are behind the cover. I found a good video on how to pop it off and snap on the new coer. Inexpensive and quick...order from ebay or amazon (got mine on amazon). I too did not see why he had to replace the visor.
@yesloow
@yesloow 3 ай бұрын
@@misottovoceany chance you can share the video on just replacing the cover? Mine is floppy
@Mikhail72051
@Mikhail72051 8 ай бұрын
Parts stores will usually loan you the tool to do this if you don't have a harbor freight close
@bb590
@bb590 8 ай бұрын
Please respond.. Does the 13x6 165 tire rub on the front when turning? I want to order the same wheels if they dont rub when turning as you explained the rear just fit.
@minimania
@minimania 8 ай бұрын
On a 5-5.5" inch wheel you should be good - couldn't say on a 6" wide rim. I believe there are folks who do run them without issue, however. I would ask on the forums about someone's exact set-up if you're concerned.
@bb590
@bb590 8 ай бұрын
Please respond.. Does the 13x6 165 tire rub on the front when turning? I want to order the same wheels if they dont rub when turning as you explained the rear just fit.
@roastdinner
@roastdinner 8 ай бұрын
Thank you so much. The only video I’ve found with these calipers. Made it so simple, great work lads
@VelocityInvitational
@VelocityInvitational 8 ай бұрын
Fantastic Race!
@praveengoonathilake2866
@praveengoonathilake2866 8 ай бұрын
This video helped me today. Thanks a lot.