Mike Langston

Пікірлер

@raycimbalnik5159 2 жыл бұрын

What is the best way to align the glass when reinstalling hinges?

@steve28849 3 жыл бұрын

thanks for the video. have ordered after market hinges from amazon

@EJ-tx2zs 3 жыл бұрын

My hinges broke a few days ago at Lowes. Thanks for this video I’m attempting to swap my hinges out tonight!!

@jorgiecolon2350 4 жыл бұрын

Thank you very much for your video, it really help alot n save me alot of money, thanks again

@luciofernando10 4 жыл бұрын

That whole glass dismounted in my hand suddenly today at Walmart, hitting the asphalt.😱😱😱 Lucky the glass didn’t break.😰😰😰

@philb707 4 жыл бұрын

I dont know why Nissan didnt just use a 10mm nut on the bolts. Its the most universal size nut. SMH. Video helped anyway thanks

@georgeanthony380 4 жыл бұрын

Clear and concise, great job !

@MasaCheez 4 жыл бұрын

You're awesome. Thanks man!

@dick1433 4 жыл бұрын

Thanks for this video this was exactly what I was looking for my hinge broke off

@jparker9320 4 жыл бұрын

Worked great and while I replaced the hinges I was able to replace the third little. I didn't realize those plugs had screws. Thanks a lot Mike!!

@christophernace6961 5 жыл бұрын

Dude ... you made my morning so much easier. Thank you

@daved3633 5 жыл бұрын

Just happen to my wife , she lift the glass, to put her shopping bags in , Bammm. broke off , lucky the gas actuators save the glass from falling..

@luciofernando10 4 жыл бұрын

Same just happened with me at Walmart. Got some scratches, but lucky it didn’t break.

@Shane23Armada 5 жыл бұрын

Mine happened yesterday the screw was corrosive

@jackfax2006 5 жыл бұрын

Mike, I have the 2007 Armada. For the life of me, I cannot figure out why you have to take the cover off inside to see the six screws you identify. Can you elaborate?

@mikelangston9034 5 жыл бұрын

You have to remove the cover on the inside to get to the bolts that loosen the plastic cover (where third brake light is) enough to get access to the hinge bolts. You're not removing the whole plastic assembly, just prying it up enough to remove hinge screws. I hope that this helps.

@jackfax2006 5 жыл бұрын

@@mikelangston9034 I did that and stopped. It all looks so simple to do but I just know I will screw it up. To make matters worse, the REPLACEMENT LIFTGATE GLASS LIFT SUPPORTS were broke on the bottom on one side so now I have to replace them. I did not read down on your posts here to see the link to the NissanPartsDeal.com I bought the OEM part for the hing for $124. I think it wouldhave been cheaper on your site.

@mikelangston9034 5 жыл бұрын

@@jackfax2006 It sounds like you're breaking it but its just the threads on the screws popping against the metal when you are prying it up.

@jackfax2006 5 жыл бұрын

@@mikelangston9034 I just need to be able to see those screws to loosen that is why I asked why I needed to remove the panel on the inside. I really can't see up there where the screws are.

@willhuerto3850 5 жыл бұрын

Snap, Crackle, Pop!!!! Thanks Man!

@fa3556 6 жыл бұрын

Thanks. Made it a piece of cake for me.

@georgea0731 6 жыл бұрын

Bolt on Dr's side just broke into. Can I just order/get a new bolt and nut and use the original hinge? Thanks (email [email protected]) BTW Dealer, young guy said there was a $15 bolt available.

@mikelangston9034 6 жыл бұрын

Not sure if you are talking about the bolt side that goes through the glass or the top of the hinge itself. The whole hinge is about $25, so I would replace it completely because they rust out so bad. Part numbers are below and here is a link to the parts breakout. www.nissanpartsdeal.com/parts/nissan-hinge-glass-hat~90321-7s000.html

@93mustang 6 жыл бұрын

Lucky me, my 2004 Armada doesn't have those three holes to access the bolts along the bottom.

@mikelangston9034 6 жыл бұрын

That year is exactly the same. Not sure what issue you are experiencing.

@93mustang 6 жыл бұрын

Should be, but it isn't. The three holes, you call 4, 5, and 6 (at the 0.40 mark) (and the three caps you mention at 0.31) are not there on mine. Mine only had two holes to access two nuts (1 and 3) The rest of the points were secured with plastic studs that make the popping sound when you pry the plastic trim piece on the outside off. Might be something they changed from the 2004 to the 2005 model years.

@metalliholic 4 жыл бұрын

@@93mustang yea same here. I got the hinges off because the bolt just melted off but now I can’t figure out how to run the bolt from underneath. It’s covered when looking from within the door

@metalliholic 4 жыл бұрын

Never mind I’m an idiot lol

@davidderfus3462 7 жыл бұрын

Hey Mike, GREAT video. I am changing my hinges this weekend. I had had 1 replaced a few years ago, but I am changing it myself this time, and was wondering how long it took to complete ?