What is the Felicity solar battery brand?

Nice job 😅

Ultimate Guide

Hi, I'm having issues unlocking the motor cover. We're using the key we were given but its not unlocking. Could the problem be that if the gate isn’t fully closed it won't unlock or is there another issue?

Good job

Thanks. But what if you have an inverter. Does one still need to follow this steps,?

Kak video

you are chatting and pushing buttons at the same time.??????????

You are a hero sir.. thank you

You just saved us from sleeping with the gate opened🙌

Thank you

Please I would like to know if this settings can be use for pylontech batteries and growatts..

Mine is giving a sensor error, how do I fix that?

Useless video 😏

Hi

finger stories

My gate motor displays motor fault disconnected, please advise

Hi How many cables you connect to the gate motor? 2 or 3 cables

Hi,no its not off grid, but we cam do that

You're an absolute legend 🙌

Really it says how to install a invertor but you showed nothing,,,a waist of time

Great vid 👍🏼

You cut if off, then what?

Thank you chief just saved couple of rands

how to enable the system?

Very helpful and grateful for the video

Thanks

Can you do another video on how to program a remote for a centurion RDO garage door you did one but it doesn't show you exactly how to set it. We're do I set it up?

Your video was very helpful..

Hey What is the size of cable you use from DB Box to wire your AUTO CHANGE OVER SWITCH

Swak explanation...better would have been to explain how you install the switchover gear between the inverter and the DB board

Thanks. I've got it working in a way. Beams are not working and the auto closing not active. At least we can use the gate again. Will be closing it manually until I can get it fixed

It is non compliant In an event of fire insurance won't pay out No fuses for battery Wires are exposed 😱

Maybe it could have been helpfull if the screen was turned. WHY?

Thank you, it worked

Please i have problems with my own machine installation please put me through

Please i problem with my own machine installation please put me through

I did bt now my sensor beam is not working

Show me where to add oil on the motto gearbox

Your hand is moving so much, I can't see the screen...

Manual changeover switch and mecer inverter

Nataka kwa lugha ya kiswaili

Thank you

Useless

Thanks for the easy explanation - got me out of a jam! 👍🏼

That really doesn't look properly done. I hope you're following SANS regulations.

Thanks a lot but is there anyway you can use a manual switch to control with the remote

Do wires from both the inside and outside unit connect to the controller

Hi,,,,,,, have an urgent qstn......could someone plz help.......my house load would be about 2000w at any particular moment. So i need a 48v (4 battery) system for which my inverter shelf has no space....so i thought if i can get a small capacity 1700va 24v based system and connect it so that its not live. Meaning i dont have my entire home connected to it. I want an inverter where i just plug it in like a computer ups and it keeps charging the batteries. But it should not be connected to the house load (bec that will be exceeding the VA capacity of the inverter). Now when power fails i will go and manually put a switch of some kind to use the stored power. Only then the inverter output connects to the whole house. The point is that i can have a small inverter which may only support a 500w load and when power fails i can reduce the load by switching off the ac / induction stove / etc and only keep fans n lights on and then switchover to the inverter output. Is this possible ?

I just installed a new D10. After carrying out the programming settings successfully, the gate refused to close and it's showing IRB-C SAF FAIL. what's the meaning and solutions please? 🙏