Good day. Do you have a wiring diagram for me. And the number of the switches. My pusch buttons are broken Thanks john
@johnnieveen Жыл бұрын
Good day. Can you give me the description of the connection. i have the same lathe with faulty switches Is this suitable for 220 Volt Thanks john
@johnsmith-wl8dp2 жыл бұрын
hello Jeff, do you have the drawings for EmcoV10 quick change gear box please? regards
@mfoismurphy1432 жыл бұрын
So nice
@zladatv2 жыл бұрын
*👍супер и привет от тренера по футболу!!!!!-!!!!!-!!!!!*
@BobSmith-vm1nd3 жыл бұрын
Hi ya, I picked up an old Emco V10P which has not been looked after at all. I have unseized everything from the 3 jaw chuck, drive shaft bearings and gearbox plus remade most of the tailstock and compound slide and all the gear changing leavers. The only thing I am struggling with is the electronics. It came with no switches but has a motor which goes and I have tried to rewire it using a similar drawing to the one you have on screen. However, the switches I was told to use don't function work with that wiring layout. If that is how you wired it up could you post the schematic up and also the name of those switches you used. Thanks Robin
@slobodanjozejoksimovic9733 жыл бұрын
Koja je jačina i cena nagra uređaj a.
@marcinwolan03 жыл бұрын
hey, can you ask for a photo of the connection diagram of such an installation? because I do such installations myself and I am looking for such a scheme.
@marcinwolan03 жыл бұрын
I would like to ask you to send it to my e-mail, because I am writing from Poland [email protected]
@marcinwolan03 жыл бұрын
?
@mikmerl13 жыл бұрын
I like what you have done. Do you have a wiring diagram and what kind of switches you have used?
@jeffcheng32113 жыл бұрын
Yes,I do
@jeffcheng32113 жыл бұрын
But how can I send you the picture
@atleasttry97812 жыл бұрын
I would appreciate the same if possible, Thank you. Are you using 110v or 220v?