Is that so? Just bought one for 60 bucks

@johnshultz3058 I am no expert. But I read that the Wheel Horse, Work Horse 700 was only built in 1969. But I have no idea of the production numbers. And I will again state that I do not know and I am no expert. However, I assumed that because the Work Horse 700 was only available for one year; logic lead me to believe it must be rare. If I am wrong, if I am deserving of ridicule, please enlighten me as to why, exactly?

@@Woody_Florida no I was curious cuz I bought one and was looking for more info on it

Im currently doing the same swap using the 4.3 harness. Noticed the knock sensor is on the oppsiste side with the 5.7 -What would you say splice and length the connector it to reach opposite side or is there another solution?

​@@alejandrogonzalez9910 I'm thinking about doing the same on my 95 I have a 350tbi out of a 1990 I'm just not too familiar with it

Summit

Did you drill holes for the new motor mounts on the frame?

@@Mrmudbone_gaming no they bolted right up

I’m not sure i know I had to change a couple plugs

The one off the 4.3 will work

Thanks man

I was 15 when I did the swap. It’s getting a 454 so who cares.

Actually 88 through 95 every thing is pretty much the same. Vortecs didn’t come out till 96

@@blockheadgarage7790 Vortec v6 come out 95 in the Astro vans I know I had one and it was all-wheel drive and had spider injection keep in mind that 91 thru 95 trucks had some change as I have 1988 C2500 and in 96 the V8 Vortec come out you can adapt them to accept TBI injection with rigth parts

@@SHSPVR the motor I swapped in is out of a 94 they are the same till 95.and you will have to swap the whole wiring harness if you want to use a vortec they are a lot different

@@blockheadgarage7790 No with the Vortex 350 from 1996 to 2002 they to can be swapped into older vehicles all you need to do is change the intake manifold with a standard Vortec Carburetor Intake than all you need to is get TBI adapter that bolt right on top of the intake manifold. And what I am referring to is the Vortec 4.3 that comes with spider injection system you cannot easy swap too V8 motor because it dosen't have additional wires to make all of injectors work and few other thing and still need V8 computer unlike the early OBD 1.

@@SHSPVR why do all that when you can just throw a Hei and a 4 barrel on it.

They came with the motor, call around to some junk yards they will have them

Mine does that sometimes and other times it doesn’t. I’m not sure what causes it.

Throttle position sensor

Ya just order a radiator for a truck that has a 350 in it and I had a parts truck for the fan shroud.

I got a new one off summit

Ya the salt will get to them fast, I park it in the winter

@@blockheadgarage7790 That's my plan. I am going to get something a bit newer so I can make it a show truck (all stock).

@@PCBasics ya I regret putting the 14 bolt in it

Ya they still work

I didn’t do anything with the suspension

Yes, but I just put a mechanical gauge in it

I’m not 100% sure if there identical but they have to be close because it runs fine

Same

No there totally different

Yes just had to change 2 plugs

What two plugs did you change?

@@StepTooRawTv coolant temperature for the gauge and one on the throttle body can’t remember what it was

​@@anthonyrauscher3730 Throttle position sensor?

@@phodailey yup that’s it

Just fine