Best comment I heard was you could have just pulled the cable had you known. I spent all day even buying a scope and then watched this and pulled what I could grab. Viola! No sweat! Thanks!
@1995RangeRover9 ай бұрын
Thank you!
@jacektyski537010 ай бұрын
Excellent Video. Plain and simple procedure if you know what you are doing. Thank you Remi.
@ythniafps10 ай бұрын
how much did the spacer affect your fitment?
@rocktheman56 Жыл бұрын
What a bad design Mercedes
@reminr7152 Жыл бұрын
Totally agree
@steventembo2157 Жыл бұрын
Thanks so much nice one
@JohannPietsch Жыл бұрын
Did you have EPB problems?
@crouton4209 ай бұрын
having the same issue right now have you resolved it?
@vernon11671 Жыл бұрын
Thank you! Remi. Very good video. For anyone with the early model Mercedes C230 Kompressor, ( I don't know about other models) I would suggest taking the plastic part off as Remi did, then look for the main hood latch cable. Give it a strong, steady pull. If the cable is not broken, this will save alot of trouble. If the cable is broken, just continue with Remi's instructions. Good Luck!
@abif2463 Жыл бұрын
"Promo SM"
@shaazy Жыл бұрын
Nice vid Remi, RHD just like mine. Where are you located? I have the Terminal 30 too, along with tonnes of other codes. Did you have to delete fault codes after doing this or does it go away automatically?
@tomdaarga Жыл бұрын
Hello, my w221 headlight and some computers turn off while driving, after 2 seconds later turns on. Could you please help me
@reminr7152 Жыл бұрын
Sorry i had same issue, but didnt figure it out, try to look answer in the forums
@drumluck69 Жыл бұрын
Good video. Thanks you saved me $$$
@markhanke35702 жыл бұрын
Good tip. Not very easy, but possible. I did it with some difficulties. I have "open hood" message. In 2010 W221 there is a micro switch. It clicks when pushed with thin screwdriver. I tried to block it pernamently, but no joy. The micro switch is not listed in EPC. Any idea, pleasse. Cheers
@zemoney9542 жыл бұрын
No sound ?
@fredinhisshed52352 жыл бұрын
Hope you are well Remi been a long time now
@paulholtzclaw84762 жыл бұрын
Очень хорошо!
@georgibalabanow75272 жыл бұрын
Thank yuo ...so much bro ❤❤
@Plattinumstatus2 жыл бұрын
Are the front screws connected to the upper radiator support or is that the reinforcement bumper?
@gabornyerges48012 жыл бұрын
👌👌👍
@acballer18312 жыл бұрын
Great video thanks
@mohammedabdulrahman23902 жыл бұрын
doesn't the pain decrease the reflection and decreasing the light beam quality?
@paliuniskis12 жыл бұрын
ABS light stay on where terminal 30 problems?
@reminr71522 жыл бұрын
Check abs sensor. Terminal 30 more for bad connection or damaged wires
@TsarOfRuss3 жыл бұрын
All of that work just to change a tiny bulb!! Mercedes is something else
@JTR...3 жыл бұрын
Thanks a lot I have the same problem. My plan is to get new turbo as well. But have a one more problem. When driving 65-80mph then car vibrates. Tires alloys are new. No idea what’s the problem.
@reminr71523 жыл бұрын
Badly balanced tyres. Go other shop to check them
@nitrous07me3 жыл бұрын
These are a direct bolt on for the 3g eclipse?🤔
@reminr71523 жыл бұрын
Yes
@jczerozerotwo30713 жыл бұрын
looking good
@reminr71523 жыл бұрын
Thanks. Have a big plans for it this year
@eugenebarry53763 жыл бұрын
Great video. What crazy engineer came up with making it so difficult. Big car and still no room. Thanks for the video, great skill you have makes it look easier than it is.
@deans67pala3 жыл бұрын
Good job Remi!
@5gg-h6k3 жыл бұрын
Im replacing my lens this really helped me thank's
@5gg-h6k3 жыл бұрын
Thanks my man
@petersimon77343 жыл бұрын
For parking light replacement you don't have to remove the bumper and headlight. Removing only part of the wheel well plastic covers, and you will have enough room to replace the bulb. If you want to make your life easier, you can remove the wheel as well, but turning it to left or right (depending on which parking light are you replacing) would do the trick.
@reminr71523 жыл бұрын
The point of the video to show how to remove those things. But after the video i learned how to change without removing everything. Even though its not easy job for such a small thing. You have to have tiny hands:)
@tyroneclark29023 жыл бұрын
I had a feeling i could go thru the wheel well !!! Thank you !!!
@tyroneclark29023 жыл бұрын
As long as you are sure W221 ? 2007 S550
@jakesizemore58853 жыл бұрын
Is the 2.4 trans the same as the 3.0 v6 trans
@reminr71523 жыл бұрын
No they are different
@fredinhisshed52353 жыл бұрын
Good to see you mate!! Looking abit different 😁. The Eclipse is looking good!! Maybe give the hub faces a clean with sand paper make sure they are flat no rust, may help with the squeeky brakes as the disk may be ever so slightly off square. Look forward to the next video hopefully we can meet up at a car show this year.
@reminr71523 жыл бұрын
Thanks mate. I believe this are the brake discs. I swapped for a day the old brembo pads, and still was squeaky. The hubs I've cleaned properly when I was swapping brembo kit
@fredinhisshed52353 жыл бұрын
Remi NR Hopefully you can sort it, one little annoying problem the squeeky brakes!!!
@reminr71523 жыл бұрын
Specialy when you are in the traffic. Everyone looking at you.:)
@dorotejabarakauskaite78523 жыл бұрын
That nicee
@reminr71523 жыл бұрын
Thank you
@IvanIvan-hm8fy3 жыл бұрын
Наш , я знаю английский язык плохо и понимаю что говорит 😀
@garyleonardo35383 жыл бұрын
No visiable screws on the W221 S550 2013 LOWER Grille, I know it comes off pushing in, but can it be completely removed, have you done it...MANY Thanks
@reminr71523 жыл бұрын
No sorry I didnt. I just saw on amg style bumper pre face-lift are screws
@garyleonardo35383 жыл бұрын
How does the lower grille come off...w221.. 2013 S550? I pulled hard doesn't want to move. Thanks
@reminr71523 жыл бұрын
Check for the crews in the middle top and bottom and on the sides
@emileschoemaker91213 жыл бұрын
if you can take off the complete wheel on the side where you need to change the bulb and you remove the front complete -mud-cover-plastic / splash guard (half of wheel size) seen at 1:34 you can reach for the bulb holder and take it out, renew the 12v 5w light and push it back in, that way no need to remove complete front bumper. Just did this yesterday. besides the two plastic plugs it is held by only 3 more screws. Still like your video how you show to get the job done, many roads lead to Rome keep the good work up guys! thanks!
@happymanekpeni963 жыл бұрын
Thanks for helping me
@reminr71523 жыл бұрын
Check as well your battery. Does it hold the voltage
@mohdkhairimohdmushahar2554 жыл бұрын
Everything plug n play for the evo 8 caliper and rotor or some modification needed?
@reminr71524 жыл бұрын
Yes they goes direct fit. Just the wheels have to be at least r17 and et22
@mohdkhairimohdmushahar2554 жыл бұрын
@@reminr7152 I got evo 8 stock wheel so it should clear.. Now need to find evo 8 brembo rotor and caliper..Thanks
@reminr71524 жыл бұрын
Yes then will be no problems
@jonahsandoval_65234 жыл бұрын
So the calipers fit on the caliper bracket or how is the caliper not falling off?
@reminr71523 жыл бұрын
Yes direct fit
@carrepairservicesindubai93664 жыл бұрын
I need to modify my car lite
@yasoutherncousin4 жыл бұрын
So terminal 30 doesnt point to one thing
@reminr71523 жыл бұрын
No it doesn't. You have to check first of all the battery which is in the trunk. It must be good quality. Then go through those connection points
@christopherdecosimo91974 жыл бұрын
What steeling wheel is that? Can you link it
@reminr71524 жыл бұрын
I bought it like 10 years ago on ebay. Don't think I can find it now. But it's a cheap one. And a bit to small. Considering to change it in the near future.
@Mizza21434 жыл бұрын
Thank you bro!
@tyrannyterminator41794 жыл бұрын
All you need to do is only slightly open the splash guard and replace. Mercedes techs never completely remove the bumper, they only charge to remove the bumper.
@reminr71524 жыл бұрын
In general i was removing the lights. So the bumper had to go anyway and i just showed how to take it out and if you or other people know how to get access with out removing the bumper is great. Just just showing with what difficulties I met
@tyrannyterminator41794 жыл бұрын
Remi NR it is a pain in the butt to do it the correct way for sure. Keep the W221 for as long as you can! They are amazing cars!
@reminr71524 жыл бұрын
Yes I like them as well. But they have problems and I notice people need a lot of information so I will do more videos about some issues that I was lucky to fix by my self.
@jsj31313jj4 жыл бұрын
Do you have a video 😢🙏
@El__Cherry4 жыл бұрын
This is dope !! Is it the same process for the fog lights ??
@reminr71524 жыл бұрын
I believe yes. But would suggest to use heat resistant paint. Because of the hot bulb
@El__Cherry4 жыл бұрын
Did you have to take off the front bumper?
@reminr71524 жыл бұрын
I think if you lift the car up you can get them from the bottom.. unless you have under tray.
@saint_iri4 жыл бұрын
Been considering getting a bumper from TORQEN, how long did the delivery take? + where there any additional charges ?
@reminr71524 жыл бұрын
Took 6 moths
@RAYMUKAS4 жыл бұрын
3:16 there is 1 REMI push Power, of course any insurance heven't any information about that carriage :P