TheWoj76

Пікірлер

@w1katari 10 күн бұрын

hello, its possible to buy? nice example of turbo dnm :)

@mtmostowski 3 ай бұрын

41 wyświetleń!? Kto to ogląda? 😅

@TheWoj76 3 ай бұрын

😜

@sol_2183 4 ай бұрын

Thanks dude

@Melechtna 5 ай бұрын

An iron, as a board warmer......that is a first, but honestly, that's....genius.

@shokdj1 5 ай бұрын

Looks like there’s a couple bridges on right chip which is an easy fix tbf

@TheWoj76 5 ай бұрын

Yes, very easy, I am not concerned about visible bridges, these take a couple of seconds to fix, the ones under the scary ones. Later it turned out there was also some bad solder around the resistor networks, invisible, that took some time to sort out. The second board came out much better, still with two bridges on the same chips.

@shokdj1 5 ай бұрын

This would probably work well if combined with hot air

@TheWoj76 5 ай бұрын

I do have access to a proper reflow oven, but with some logistics hurdles that I do not feel like getting through ;)

@TZJB-ks1kp 5 ай бұрын

Congratulations Woj. It took a while but you got there!

@mtmostowski 5 ай бұрын

But does it work? 😮

@TheWoj76 5 ай бұрын

See the other video 😉

@mtmostowski 5 ай бұрын

Za dużo pasty, o wiele za dużo moim zdaniem

@TheWoj76 5 ай бұрын

Wiem, mimo, że stencil cieńszy (0.1mm) nakładanie było do bani, nawet bez komponentów wyszła masa mostków.

@mtmostowski 5 ай бұрын

Stephen King could take lessons in how plot is built! Hats off 😂

@mtmostowski 5 ай бұрын

The suspense is literally killing! 😅

@TheWoj76 5 ай бұрын

😜

@nikolaosmnk Жыл бұрын

Hi on Marelli IAW4AF from fiat panda 1.2 i read flash, could you help find idle speed map location, i find target idle speed when cold hot when accelerate/decelarate and when moving, i find possible location could you help?