3 жыл бұрын
4 жыл бұрын
4 жыл бұрын
5 жыл бұрын
Пікірлер
@Rick-z4h Күн бұрын
The magnetic switches is what made me order the xt.
@TNT.Fishing 14 күн бұрын
We need to run this back. Maybe get some Flattie Finder footage this time. With some TNT action too of course.
@BenState Ай бұрын
You should never go stronger than 10:1 water to acid ratio as this can damage the cell. 4:1 is crazy.
@LittleSkrunkey Ай бұрын
😂😂😂
@J-Justice666 Ай бұрын
You made a good point about the copper wire. Conducts heat all the way around your other wire. And it won't melt. It doesn't make sense why they want you to use zip ties.
@LittleSkrunkey Ай бұрын
Hi
@LittleSkrunkey Ай бұрын
Hi
@LittleSkrunkey Ай бұрын
Hi
@danielguerra4447 Ай бұрын
Go to this channel name Channel Little Sknunkey
@danielguerra4447 2 ай бұрын
Please like the video
@danielguerra4447 2 ай бұрын
I don’t even know what those skins are. I just think they’re your old
@danielguerra4447 2 ай бұрын
Might be not there game called blacktop
@danielguerra4447 2 ай бұрын
Map code 3349-6720-1022
@danielguerra4447 2 ай бұрын
Oh no, I don’t care 🤷
@danielguerra4447 2 ай бұрын
😂 he he
@franciscobbinah5782 2 ай бұрын
9ce idea
@peterk6806 2 ай бұрын
Remove the Styrofoam on the panel did that a year ago now it works with no ice
@childrenyoutube 2 ай бұрын
how does the oring go after that ?
@ericekency8194 4 ай бұрын
Would have been helpful to show heater instal
@budhramrasiawan3257 4 ай бұрын
Thanks i would like to know where you get the addational coil wire and fan .
@danielguerra4447 4 ай бұрын
@@budhramrasiawan3257 fan Amazon link is in description. The extra wire I used to wrap the heater wire was just spare wire I had sitting around.
@tahaahmed5617 5 ай бұрын
Did you install this while fridge is still running? I dont think defrost is working all the time?
@danielguerra4447 4 ай бұрын
@@tahaahmed5617 you have to force defrost the second you hear fan scrape ice. I unplugged while I installed heater wire and clips, and plugged in immediately to make sure the new heater wire got hot.
@chuckken3438 5 ай бұрын
I gaurantee there was nothing wrong with the fan...next time connect the red and black wires to a nine volt battery and see if it spins!
@danielguerra4447 4 ай бұрын
@@chuckken3438 it had been stuck frozen a few times and was original fan. I chose to change it even though it was still working.
@maxentropy7596 6 ай бұрын
I have the same frig with ice build up after six (6) years. Question: 1: Why now? 2: What has changed? I see suggestions about an addition heater coil, but it ran for six (6) years. What is failing now? I have seen above that the entry point for coil may need to be reseated?
@offdutycharterstx3898 6 ай бұрын
A little windy, NICE Red
@Anthonygarage 6 ай бұрын
Intex sand filter pump graveyard that’s already old broken ones
@mattreese-7 6 ай бұрын
this fridge is such a piece of crap, nothing but problems since ive had it
@chilitoday 7 ай бұрын
My own update on this same repair..it still works ok. No icing up in evap area. I checked it six months in. I was ready to junk this fridge but we’re good I think.. never again Samsung! Btw the door flap is busted now but I saw a video and should be easy to fix for less than $20
@Edward-Norton 7 ай бұрын
All Masterbuilt gravity grills should have magnetic switches.
@danielguerra4447 7 ай бұрын
1
@ethanding3504 7 ай бұрын
Do you know what is the front rubber tube used for, if it is missing is it gonna affect this working? Thanks
@codydonovan7356 7 ай бұрын
What brand pool? How did you install the skimmer in a temporary pool
@larryzoellner-cl7tq 7 ай бұрын
I added a similar heating wire 2.5 years ago. It hasn't frozen up since.
@danielguerra4447 7 ай бұрын
Yeah it definitely helped mine out too.
@D_A-G 8 ай бұрын
Bro, salaam to you, i’m a conservative Muslim and we don’t like our kids seeing the garbage on the home screen. I really appreciate your guide. Salaam.
@rayraycheshire3430 8 ай бұрын
Thank you. Sad thing is I only looked this up because I got tired of getting advertisements for trans bs.
@jeffmoreau-gh8sq 8 ай бұрын
Where did you buy this net?
@danielguerra4447 7 ай бұрын
ProTuff 17.5" Pool Silt Net -... www.amazon.com/dp/B01FSRNT66?ref=ppx_pop_mob_ap_share
@danielguerra4447 7 ай бұрын
ProTuff 17.5" Pool Silt Net -... www.amazon.com/dp/B01FSRNT66?ref=ppx_pop_mob_ap_share
@gecikaslater7296 8 ай бұрын
So im a first time pool owner and i set my pool up and it was 6inches off on one side. So i bought pavers but i was going to stack two of them that are two inches high to try and level it and then not put any under my other side. Should i not do that and if not how do i fix and level it? by the way im draining it to do this not with the water in it if that helps
@danielguerra4447 8 ай бұрын
Best way is to level ground. Sand can help level, but only 1-2 inches. If you are off 4+ inches you have to dig to level it. You need a paver under each leg. You can dig paver down or leave above ground, whatever is necessary to keep frame level on top of pool.
@raist3001 8 ай бұрын
Do not listen this awful advice. DO NOT CUT your butterfly gasket. Once you cut out your opening, the butterfly gadget will fit exactly as it is MEANT to do.
@danielguerra4447 8 ай бұрын
This is not a hard side. You don’t cut out a soft side before mounting plates. Therefore you cannot insert butterfly gasket. 🤷♂️
@Blayze1017 8 ай бұрын
Split the gasket like the video says. If you cut the opening 1st it’s probably going to stretch and fit like crap. Split my gasket and it never once leaked in 6 years of use.
@danielguerra4447 7 ай бұрын
Might want to make sure what you say makes sense before commenting an absurd statement 🤣🤣🤣 Haven't heard a reply from you yet 🤷♂️
@sandratrim4309 8 ай бұрын
Me too
@sandratrim4309 8 ай бұрын
That's what happened to my refrigerator I had a repairman coming frosted but I can't order the part I have it put in until June I was just making sure he wouldn't sell me a lot of c*** that that would stop the problem that's why I like KZbin you can see other people figure stuff out
@chilitoday 7 ай бұрын
Not an easy fix but if you’re handy it’s doable. I did and it works good.
@djprideone1 9 ай бұрын
can we maybe get an updated video on what happened a yr later after the repair ??
@danielguerra4447 8 ай бұрын
It worked fine. I had it happen once in last year. This time I removed all lower panels in back and cleaned the dust buildup in the intake vents. Didn’t happen again. After that I moved into a new house and got an LG fridge so not messing with the Samsung anymore. I would have brought the Samsung to new house but the spot for it was shallower and didn’t want fridge to stick out several inches so I got the shallow depth full size capacity LG and I love it.
@boredinibiza 8 ай бұрын
@@danielguerra4447 glad to hear it worked out pretty well over time. samsung also issued a new drain kit with better drain hoses and some insulating tape to help with the blocked drainage that also contributes to bad airflow behind the panel. some fridges can really create some nasty air particles that basically turns into sludge and blocks the drains. biggest symptom of that is the water under the dwarers. samsung also changed the design of this setup in really recent models so they are finally trying to fix the problem. i think I read there is a class action lawsuit that probably helped move their butts :D
@BrandonMobley614 10 ай бұрын
Best above ground pump and filter you can buy. No question. Top notch salt system as well. Your plumbing on everything is outstanding. Great work!
@mellieunicornz6436 10 ай бұрын
Can u use broken pavers?
@dagoelius 11 ай бұрын
Never immerse the terminal ends of your cell in muriatic or hydrochloric ACID. It will break down the terminals and shorten the lifespan of your salt cell.
@jasonroscoe7259 Жыл бұрын
How did you install these?
@danielguerra4447 Жыл бұрын
Just cut the old switch wires and connect to the new switch. Mounted them with small stainless screws. Only one that failed since I made this video was the firebox as it did get to warm. You could use a bracket to move switch away from firebox so it doesn’t get warm or just connect the two wires together and Jair bypass the whole thing. I did that for the fire box. Hopper and door still working great!
@hanoimartinez571 Жыл бұрын
Hi, could you explain to me how to diagnose that I don't get current to the fan?
@grahamsmith347 Жыл бұрын
where can i get this heater wire kit ,here i AU ? 240 volts ? and i dont like the "squash locks " for water cant we get something water /moistor /resistaent/ but yes i agree same prob, very good vidio .
@santiagoalvarez1392 Жыл бұрын
Question: Is this a repair recommended by the factory or something you invented?
@chilitoday 7 ай бұрын
It’s not a factory fix. But it’s safe. I did it and it works good a year later. No overheating or melted plastic. It of course uses more electricity than it did before but not much. I had a Samsung guy out who wanted $350 to repair it out of warranty. It would just keep happening without the auxiliary heater wire. It’s a bad design and the repair guys know it and admit it. It’s job security for them. The guy had not seen this fix and was impressed.
@danielguerra4447 Жыл бұрын
Cchmh
@danielguerra4447 Жыл бұрын
😢😢
@danielguerra4447 Жыл бұрын
😂😂😂😂😂😂
@danielguerra4447 Жыл бұрын
😮😮😮😮