The newer crowns stop much better. I've drove two crowns and honestly they're nice machines. I still usually throw my foot off the deadman to stop. Working at home depot the only time I really travel full speed is if its night time and the store is closed doing nightcrew work. Too busy during store hours to even really go full speed with a spotter.

Depends how tall your mast is. But for the most part, they aren't used to load trailers.

Reach.one Teach.one Unless you're using the top-secret nuclear powered reach truck, I can confidently say that keeping your phone in your pocket is a bigger radiation hazard. In any case, you probably shouldn't be breeding.

smart ass..

Not normal. I worked at a place like that and it sucked ass. I know what you mean though, I couldn't get used to it at all.

You can have the steering changed pretty easily! Sounds like yours has it set up for driving facing backwards

Where are the Crown videos???....

Iibad ., direct your elbow the direction you are going ., so if you turn the handle left you are pushing your elbow out to the right ., when you pull your elbow in your elbow in your turning your handle to the right but pulling your elbow to the left ., I just tell people link your mind to your elbow

That's how accidents happen and why forklifts have tons of accidents. That's the biggest reason I wont go work for a real warehouse. Even more unrealistic expectations and productivity times. Its plain unsafe. I can drive the machine and get things done fairly efficiently but it's by no means a race.

Exactly ., I can hit 17-18 replenishes an hour going at that speed ., it’s before you get to the pallet that takes the majority of your time ., if your quick on the touch “ touch of an angel “ . You’ll still get 2-3 drops every 10 minutes

Yodam Bomb and again that's why forklifts have such a high accident rating. They're dangerous machines to begin with but adding that speed gives a lot more room for error

Yea doesn't help when everyone at the warehouse is speeding around trying their best to get bar smh.....

Sorry bud, but as a tech that works on both Crowns and Raymonds, you are dead wrong. Crown is a FAR better design. Raymond in fact copied the setup exactly like Crown with the 7500 series. The older 7400 series could not come close to run time of a Crown because it did not have regen on lowering the reach carriage. It was not until the 7500 series came out that Raymond was able to achieve what Crown has since 2009 with running the lift motor in regen mode when lowering the reach carriage. Also, Raymond still uses brushed DC motors for the steering and in the new 7500 series a brushed DC motor is used for the reach carriage functions. Crown uses all AC motors. Please be careful what you try to tell people because people like me will call you out that has experience with working on both.

You sound like you dislike black people ., he was going at very slow and comfterble pace and that was only a level 4 drops ., shit won’t tip 10 ft at that speed ., your a racist Tommythe bear

You don't need a safety vest if you're already on a machine, you tit.

@@Xachremos You would be written up at my job for not wearing one.