3 жыл бұрын
Пікірлер
@jeanbeaumont2810 10 күн бұрын
8
@Stevieb333 Жыл бұрын
Slow down for christs sake.
@pacone9694 2 жыл бұрын
Are you happy with this lathe? Did you buy it a second time? Do you recommend it?
@woodsmanartistic9878 2 жыл бұрын
This is my first lathe and so far it is still holding the most important things, however, a good head and well-sharpened chisels which have not been shown in this video yet because I did not have the right sharpener. you can see me rolling on my instagram now and it comes out much better in my opinion.
@andrexxxuk 3 жыл бұрын
You need to slow down a bit mate, and stop forcing the chisel when you’re first roughing out. Just take your time and I’m sure things will progress nicely 👍🏻
@woodsmanartistic9878 3 жыл бұрын
thank you very much for the advice
@stefanopolcharalampous4150 3 жыл бұрын
my friend i'm thinking of buying this particular lathe. the only thing that bothers me is compared to other lathes in the same category, it has low engine power. I see in the video some moments in the tool pressure stops momentarily.
@woodsmanartistic9878 3 жыл бұрын
I agree with it is enough for me, but to be honest I would need more power with a larger turning diameter
@andrexxxuk 3 жыл бұрын
…There is enough power with these little machines, it is the belt that slips not the motor power not being enough! Also, very sharp tools make a massive difference, and as I stated earlier, take your time.
@pacone9694 2 жыл бұрын
Stefano, what lathe did you finally buy?
@tomaszmadej7278 3 жыл бұрын
Megaaa