I used to make them nice to see there is still a few going
@freedomfromcocktailjabs2 күн бұрын
Going under gone
@octive83 күн бұрын
Gizmo 💩 designed by 🎃 heads. Manual over ride is my objective to delete or circumvent that electrical junk. Manual over ride is the 'final solution'.
@ronaldhamblin46154 күн бұрын
Why don't you do something decent like change the timing chain this is for the mindless waste of time
@itsajaaaag2 күн бұрын
Because the chain does not need changing perhaps ?
@tinman107112 күн бұрын
Same issue driving me crazy and like warm heater air
@hotmasked112 күн бұрын
Yeah i still have my 2002 jag X type 3.0 and I replaced the lights but i think i want to convert to LED they look much better.
@thesenator501316 күн бұрын
I own a 2.0 diesel X type with 36,000 miles on a 2007,great looking car and very underrated.I love my Jag.
@hotmasked119 күн бұрын
i still have have 2002 jag x type still so classy
@ottofumbler7267Ай бұрын
You're not bothered it's made from Russian crude? It's dirt cheap for a reason you realise?
@itsajaaaagАй бұрын
It is cheap but its good quality oil ? never had an issue.
@SanjaySharma-qv3unАй бұрын
I would love a xjr with a switch to bypass the exhaust
@Malmes999Ай бұрын
did you drill rivets ? i have 05 the lower arm came with fixed reverts from factory just drilled them out on one side waiting for ball joint.. going to do the other as well👍
@ronaldhamblin4615Ай бұрын
You work hard not smart😅
@frankw9836Ай бұрын
Bosch = German ( made in china) = rubbish
@Malmes999Ай бұрын
Thanks for this good tips 👍doing mine soon have the part my mount has a arrow on it... read up it points from front to back wing side 👍 the manual says to paint mark front stud before removal that's what i'm going to do to make sure the old one wasn't put in wrong as the bearing isn't there on mine hence why it needs changing need to put a big washer on before hand in case spring pops with bearing been gone
@jkml7088Ай бұрын
Did you have any problems with the CV after doing the work?
@itsajaaaagАй бұрын
no all good.
@ronaldhamblin4615Ай бұрын
You call that a mod that was hard work to watch
@TiranosaurioRex2 ай бұрын
Hello, I hope you are enjoying your new jaaaaag, I remember that in the video of entering the radio without a code, your previous one did not enter with the key combination, but what you have to do is put it wrong 3 times, and it says waiting, You put it there and it works.
@mumtazzafar56962 ай бұрын
Hi m8 what do you think of this oil. I am thinking of giving it a try mannol 5w30 seems quite cheap
@itsajaaaag2 ай бұрын
German brand, Its mass produced and not a well known brand but its a great product used it a few times, good quality oil.
@mumtazzafar56962 ай бұрын
@itsajaaaag does it make the engine more noisy? I've been told that the cheaper oils tends to make engine slightly more noisy. I drive a toyot avensis 2.0 diesel. I bought this car last year in October and have carried out 2 oil changes. The oil that I used had a toyota fuel economy label on it and cost me about £22.00 for five litres. Since the engine takes 6.3 litres I have to buy 2 containers. I don't think this toyota fuel economy oil is any better. The fully synthetic 5w30 from toyota is £50 for 5 litres. It's a 2013 reg car and to be honest I wouldn't really pay £100 for the engine oil. Nowadays I see this mannol in almost every small car parts shops as well on ebay etc. Where I live it is being sold for £16 for 5 litres. As I like to service my vehicle twice a year I think the price really suits me lol. There are few other videos on KZbin where people have used mannol engine oil and they seem quite satisfied. Therefore I am going to give it a try next month and if it doesn't increase the engine noise it would amount to be declared good.
@Azifiqbal2 ай бұрын
Got a question , would u say xtype is a good first car ??
@libertad96013 ай бұрын
El termostato del enfriador, mejor montarlo en la bomba fuera del coche. Cuesta bastante meterlo a presión. Yo lo hice con la mordaza de un tornillo de banco y dandole jabón a la junta tórica.
@ronaldhamblin46153 ай бұрын
This video was a waste of time
@stefanpuszka11603 ай бұрын
That was great thanks for the info about acquiring the spares, cheers.
@richardautenzio81173 ай бұрын
Nice car, nice condition. It's as nice as my 2006 2.1ltr . Lord Luxurious on youtube.
@TiranosaurioRex4 ай бұрын
If you add an EGR blank, don't you get the engine light? Mine apparently has a bad EGR and it turned on.
@itsajaaaag4 ай бұрын
Nope, no engine light experienced on either of the xtypes, both 2.0d
@TiranosaurioRex4 ай бұрын
@@itsajaaaag Mine is 2.2, I don't know if it has anything to do with it, the error it tells me is that it has insufficient recirculation gas flow or something like that. That's why the question.😅
@itsajaaaag4 ай бұрын
@@TiranosaurioRex you may need it mapping out or you may need the blank with the tiny hole to prevent the engine light.
@TiranosaurioRex4 ай бұрын
@@itsajaaaag If you made a video about that that would be fantastic,😅 by the way that jaaaaag does shine 🤩
@MarkPrydderch240zNorthWales4 ай бұрын
If you blank the EGR , and it’s then seen by the MOT Tester on the retest, surely he would fail it?
@tylerthemad63254 ай бұрын
Brooo I used to whip I nice silver one v6 and I haven’t found a good video of the 3-4 shift sound or on the highway when you let off the gas mine used to rumble and on throttle the bitch sounded like a chainsaw 😂 or BROOO the start up jet engine fans before you hit the key are crazy loud loll
@theteadrinker-1434 ай бұрын
My brake fluid is as black as coal too , a job on the list . Watching from Spain 👍🏻
@theteadrinker-1434 ай бұрын
The age old problem of alighting the clutch ! 😒
@theteadrinker-1434 ай бұрын
I must check our jag , just waiting to get over Covid 😒
@stan-ut5gj4 ай бұрын
Had mine done 2 years ago.
@itsajaaaag4 ай бұрын
Yes they all go no matter what, but on this one they aren't too bad, so worthwhile trying to protect them and future cost but eventually they will need doing.
@stephenbates83704 күн бұрын
I always thought you had to drop the subframe on these to do the clutch what did you have to remove to get the box were it is👍
@someguy8724 ай бұрын
You do the work yourself, the only thing i can do is change the filters lol
@itsajaaaag4 ай бұрын
That's how i started. Don't doubt yourself.
@theteadrinker-1434 ай бұрын
The rebuild is always the best part 👍🏻
@miketherefurbisher80004 ай бұрын
Let me say first of all that's a brave move tackling the clutch on your own! Well done it's a job to get more than 65 - 70K out of one, they tend to fall apart as your driving, I had the same issue at 70K. it's normally injectors and cam belt with new bottom pulley next. The turbo's go on quite well on them. Keep it going we Like the channel and of course X types. 👍
@someguy8724 ай бұрын
Nice X type you got there, i bought one from 2003 and it's a sweet car to drive. Even though it's done over 30000km it still lives.
@JTOSPICY4 ай бұрын
How many miles does it got 300k plus?
@matthewjackson30344 ай бұрын
If you're doing the flywheel, may as well change clutch. Save yourself the hassle.
@itsajaaaag4 ай бұрын
Yup will be doing.
@theteadrinker-1434 ай бұрын
Watching with interest from Spain just in case mine goes ! You’re doing well saying you don’t have a lot of room there .
@toucan2214 ай бұрын
Don't blame you getting getting rid of the old, the new one looks Fab ✔✔💜💜😃😃
@dima.english4 ай бұрын
Thank you for your helpful videos! I always watch all of them. Can i ask you to formulate the problem once again?:) I am afraid i did not grasp fully what it is this time. Probably i will have to do the same on my jag...
@itsajaaaag4 ай бұрын
I will put it in a new video and explain why you may need to do this.
@matthewjackson30344 ай бұрын
How clean is that engine bay. Bloody hell.
@itsajaaaag4 ай бұрын
Indeed its a great find, i will actually do a video on it. thanks for the comment and idea.
@Pantheroful4 ай бұрын
Trying to understand what you are showing here. What was that block? Was that a break in the weld? Can you please provide more information?
@itsajaaaag4 ай бұрын
Ok if you look in the front arches either driver side or passenger side after removing the arch cover you will come accross a rubber bung, now that rubber is useless as it traps all the water and leaves, hence i removed it and you see all the crap and mud come out.
@du7ch3844 ай бұрын
18" alloys are either Aruba , Valencia, Proteus or Melbourne. The standard Aruba's are quite fragile to potholes so go for the performance drop forged ones off the later cars. Can't help feeling what a nice car but needs the 2.2 in it with the 6spd box.
@richlee55784 ай бұрын
You don’t need the radio code it can be bypassed with the buttons on the front I’ve done it a few times can’t remember how but I’m sure it’s on KZbin
@itsajaaaag4 ай бұрын
I did try that but it failed to work, anyway i got the code.
@matthewjackson30344 ай бұрын
Sold mine few months back, got 500. Was like wtf. But I couldn't justify the amount I was spending on it. 😢
@itsajaaaag4 ай бұрын
Depends if you are capable of doing the work yourself, if not then i understand. I've spent about £2k in 6 years of ownership, i'll take that over depreciation of a newer car.
@dima.english4 ай бұрын
Congratulations! A beautiful car. Maybe you will build a garage for this beauty?:)
@TiranosaurioRex4 ай бұрын
I hope many videos of that beauty
@kirkadam46444 ай бұрын
Remember your as well to do the dmf if your going to the extremes of a clutch. Did my 2 litre d and its really driving like new...From my experience, the Jerky acceleration was a turbo boost pipe split, however I have put all new filters and ran wynns diesel injector cleaner through several tanks. She runs like new, no smoke pulls like a train. These 2 litre turbos are immensely torquey....looks great 👍
@itsajaaaag4 ай бұрын
Yes you were right, it was the upper boost pipe on the driver side, now all fixed and drives superb.
@theteadrinker-1434 ай бұрын
What a beauty , like new ! Mine fled through the mot today 👍🏻
@richardjackson53804 ай бұрын
Oh no😢
@Sickiey4 ай бұрын
I am saddened to see you it go. I have been following your video for a long while now, . however that is the problem with these cars,. they have so many common problems I have mine 5_years and changed all the same things you have, starter, injectors, brake cable, Belts, alternator, water pump. door handles etc. only got it back last week from Ford expert who looked at the wiring for me. I know the shocks, bushings and other rubber is starting to perish, I am afraid to check the sills So do I put more time/money/effort and "off road time" into keeping it,, or let it fly as beautiful as the x-type looks ,, it does not drive like a 2018 Merc C class :(
@andrewfrench87894 ай бұрын
What a shame, mine has just turned 20 this year and running well., it a 3.0 V6 AWD with 79,000 miles. I found your videos very helpful as I like to do as much on mine as I can. I do hope you get another one and keep the informative videos coming for the XType