if you changed the angle of the toe-plate so it looked up more it would work better. The toe-plate is flat on the ground as you’re grabbing - the teeth should be angled up and only the back edge of the toe-plate should contact the ground when it’s closing. Plus - it’s impossible to scrape away from you with the back of the front toe-plate. Looks strong and well made otherwise though. 👍

How much is this equipment?

What if you put the clip on rubber tracks on every other steel tread (instead of every steel tread)... half the cost, half the time of bolting them on. Plus a much more aggressive track in dirt, mud and snow... while still protecting the roads...

hey can you maybe help me with a quick answer? when i doo this my own how much smaller should i make the bored hole ( ex. 50 mm kingpin , 60mm OD bushing 50mm ID bushing)? should the hole be 60mm or 59.90?

what kind of steel are the Pin and bushings made from ?

what kind of steel are the Pin and bushings made from ?

Why not sound on this vid

Looking at the photo I thought it was a gorilla fixing something

I am highly impressed by the design and fabrication work that pulled this one, out of the hat. Tell the operator, that he is a good salesman.

hi.. you did a great job..what kind of steel are the bushings made from?

Fantastic Job!!!

Nice

Nice but 2bosh size Los 2right

How much and where can I buy it?

Nice work colleagues !

Top job 👍🏻

Very nice work guys. A couple things that were told to me over the years. Either the leading edge of the bushing should be about . 001” under the bore dia. by .1” long to allow squaring the bushing, or a counterbore.001” over the bushing o.d. for the same purpose. When you have no room for a good hammer swing, a couple plates w/ holes, a nut, and bolt will make an emergency press. Again, these things were told to me by some wizards. Stay safe.

Having lived on a farm for all of my seventy two years, with horses (12-15), and cattle, I would likely grab a scoop shovel for that amount, or a skid steer when it gets deeper. It does appear to be well constructed.

Where can you order one of the rakes from?

Хороший инструмент.

Menyibe kerül euro

What steel are the king posts made of?

Where I can find this company who is selling this front loader?

Perfect operator for cutting a few permaculture swales

Hallo....was kostete der Ballenabwickler ?

Do you make one for a cat 305c cr

Super

How much would a repair like this cost ?.

Be nice to see what the rakes like in clay, and grubbing decent roots out! How easy is it to twist the rake?

Excellent looking fork

With logs that size it would be quicker with an axe, surely?

another p o c

Nice attachment !!