BMW being so thorough I can't believe they didn't make this standard on the convertible

Anyone know what wires he used and which version of the sensor it is?

once they have deployed, then reset, is that all that needs to be done? and it should work again fine? i was told that it is like air bags in the sense once deployed you would need a brand new set but after researching i dont believe that is true. any advice is appreciated thanks.

Hello can you please tell me how you connected the two together to both pop up? Thanks

I tried to put a screw driving and push it down it didn't work

I crashed my car it's still works fine but my bars came up and I can't get them down

Thanku mate

Massive props on this, man. I want to put one of these in my 240sx(fastback), since I'm interested in using a 5 point harness.

hello I actually have a question you accidentally and schedule of the same I would be very happy if you can give me schedule

Words cannot begin to describe how grateful I am for this video. I bought the bars and tested it with 2 9 volt batteries. Thank you!!!

What year and model did you get the rops from?

Hello, I am planning to buy an E36 vert that also does not have the ROPS. Manual vert. I found a set of the roll bars on eBay and was wondering how hard it is to install it? I also need to find a sensor if I get it. Should I get an actual roll bar fabricated for it or go this route? Thanks.

how much did you tilt the sensor and did you use any spiid or just slowly tilt it? thanks...

I ran a wire from the ignition fused to the module

Great video! I did the same modification. Where did you connect the power to? (violet green?) Can you tell me an exact wire set to connect these to? Thanks!