Remove the traction lock relay and if the code remains then pin B, wire 4100 in the traction lock solenoid connector should have 12 volts. I could send you an image of the complete test for the error, if you want.

Verifique todos los pines en el conector J3 en el ECM. A veces retroceden en el conector y es necesario volver a colocarlos. Salud

@@steveb153 bro no me llega una señal al módulo que va al relay y dela relay al selenoide del freno

@@cristianmorales5154 ¿Tienes un correo electrónico con el que pueda contactarte? ¿Se muestran otros códigos?

@@steveb153 si dos códigos pero no no es con el problema que tengo

@@cristianmorales5154 Además, ¿cuál es tu modelo de Bobcat?

It's an Ideal model 61-361.

loose connection?

Bottom right of the engine compartment.

If you have the deluxe panel it sounds like it could be locked. Anyone else use the skid steer besides you? If I lock the panel I use the 4 digit code I set up. If you think it might be locked there is also a master code that you should be able to get from a dealer. They can look it up by serial number. My master code is a 6 digit code.

@@steveb153 If the panel were locked, would it (the panel) not power up asking for a code then or would it atleast still power the panel when the button is pressed?

@@spyderjosh Yes, it should power up. I read your reply as if it were asking for the code. Sounds like a panel issue. My panel is not hard to remove and you can check for power getting to the panel when you press enter/run button. That's where I would start.

Is it possible to upgrade to the deluxe panel ?

Are you getting the 15-02 code when you try to "Push to Operate?" Sounds like the Traction Lock light is not off. If that is the case the traction lock solenoid is not pulling the pin to allow the loader to move.

Trying to locate the traction lock solenoid. Any pointers on where to look. I haven’t washed it out or really dug for it yet. But didn’t see it just glancing under cab.

Yes , Thanks

Does it lock up when you only use the tilt? What error code do you see? What model Bobcat do you have?

María Guerrero Salasar lo único que dijo fue que nomas checke las connections por atrás del panal del relay, que los empuje y que aver si están flojos, sorry si mi español no está tan bien

@@hmproductions2618 gracias

@@mariaguerrerosalasar560 mmm 8 8mh

Hi Amanda, where are located? I might be able to help.