2 ай бұрын
4 ай бұрын
5 ай бұрын
6 ай бұрын
6 ай бұрын
11 ай бұрын
Жыл бұрын
Пікірлер
@Blueberrystop 7 күн бұрын
❤
@holmesy321 12 күн бұрын
Thanks for this video, some great tips. I hadn't heard of the baking soda one. I got one of these secondhand off eBay recently, it plays very very well and sounds pretty good too. I will probably change the pickups and electronics just for a project, but it is not really necessary. Also, I read in a few places that these 40th anniversary JMs already have an angled pocket, so you don't need to shim.
@oktrabnotreve 13 күн бұрын
Isso aconteceu comigo em 2015... Uma semana antes de um show....
@lincolncalvin5876 15 күн бұрын
Bro that's funky😂😊
@geoffgoodall3839 16 күн бұрын
In the uk Allen Collins used the bird on a televised concert we had the full 12 minute solo circa 75
@geoffgoodall3839 16 күн бұрын
I own a76 medallion V saw a clip from mr Bonamassa he recommends you back the tone off on the bridge pick up mini buckers are a little like the tone on a tele biting treble so backed off to 5 and bamm!!!
@sammyrothrock6981 18 күн бұрын
Did you check the 68000 mfd capacitor what does it read on an ESR meter ? You may be masking another problem like either a bad regulator ic ? Something else could be pulsing ac on a dirty dc supply? Maybe a rectifier? Just a thought ? I have the same amplifier with similar but ,intermittent switching issues? Going to get into it soon !
@6dbthreshold 17 күн бұрын
The ESR was around 50ohms if a remember correctly, but I don’t think the cap was loading the rectifier too much. These amps are notorious for switching issues, especially after a retube. If the tube heaters draw just a little too much current, the cap starts to fart out. These amps use +/-3.5vdc to run the heaters. There is a balance pot, R3 that lets you adjust voltage coming off the regulator. Since your problem is intermittent, I would bias the amp first on the cool side, then adjust heater voltage balance and see if your problem goes away. In my case, I replaced the bridge rectifier and all the caps in the power supply since I was into it that far. The voltage regulators tested fine when fed with clean dc.
@sammyrothrock6981 17 күн бұрын
@@6dbthreshold These are DC heaters for sure! I will check mine as well thanks ! Do you still have yours?
@sammyrothrock6981 17 күн бұрын
@@6dbthreshold These are also notorious for a bad bridge I believe 6amp rectifier for the DC heaters also they overheat . Replace with a 25 amp just better heavy duty .
@6dbthreshold 17 күн бұрын
Sold mine. After I got it running again, I played it for 2 weeks and never fell in love with it. I knew it would eventually have to install better tubes and get the dc regulators upgraded. I didn’t like it enough to want to spend more time on it.
@SkellyBones06 9 күн бұрын
I have the Bogner alchemist 2x12 and It wont switch over to the left channel at all. How would I fix this issue?
@what1864 Ай бұрын
have a traynor ycv80q with alnico jensen speakers gets real fendery now ...
@emvom4194 Ай бұрын
If I wanted to install Real Rickenbacker pickups on this bass could I?
@6dbthreshold Ай бұрын
I would think so, but I really don’t know.
@laminatesnow4651 13 күн бұрын
You could, but you'd need a Rickenbacker-style wiring harness, otherwise it'd sound worse.
@valleywoodstudio7345 Ай бұрын
Very creative and fun video! I got a B stock one a few years back - I've a vid on my channel - and was quite impressed stock. Raised the pickup with a shim and changed the bridge for a fixed 'lightening' one and it sets up better. The stock bridge on mine looked like it was at the minimum it could be to set a decent action as the saddles are too high and the bridge a little too bulky. Its a very bright guitar acoustically and with the bright P90 (which is quite good tbh!) I found changing the pot to 250k tamed it a bit. A new nut is in order as cut slightly off centre - hence the B stock. Fun guitar to keep around in the studio!
@sgtmac62 Ай бұрын
The Gibby really grabs! Thx.
@bwhit716 Ай бұрын
A great example of numbucker vs single coil p90. Both outstanding but diff applications. Excellent vid -6dB.
@jayschulz8060 Ай бұрын
Revstars are totally sweet
@guitarplayergeek Ай бұрын
They sound nearly identical, but the Reveverend pickups have a slighty different character that I like.
@Jesuswinsbirdofmichigan Ай бұрын
#916_Subscriber_#18_comment_ThanksAboutTheWaxwing_😇
@kitchenbriks3685 2 ай бұрын
I would have asked for at least 50% off because of the damage
@6dbthreshold 2 ай бұрын
They offered a full refund. But they can’t discount more than 15% on the spot. So I just lived with damage because it is a somewhat rare amp to find used.
@channel-fs3tg 2 ай бұрын
You refer to "pots", are there potentiometers in this amp?
@6dbthreshold 2 ай бұрын
Yes
@channel-fs3tg 2 ай бұрын
@@6dbthreshold I don't understand how the tone studio software can change the volume if it is determined by the potentiometer setting
@6dbthreshold 2 ай бұрын
@@channel-fs3tg. I haven’t seen a schematic, but it’s very possible that the panel pots feed inputs to adc converters for the logic processors. Then the processor determines which volume signal to follow (local pots or software). Then a processor output probably feeds a VCA that adjusts volume at the audio power transistors. I don’t really know. But I bet it’s safe to assume the pots adjust control voltage and not audio signals. Still, pure conjecture on my part.
@ideclineify 2 ай бұрын
I know now why you got this so cheap... what am I supposed to do? I don't know no electronics
@ideclineify 2 ай бұрын
Love this... you ggot talend old man/// class of '77
@MutambaBrazil 2 ай бұрын
Holy shit, the Aerodyne sounds so amazing.
@ideclineify 2 ай бұрын
Best five minutes on youtube ever.
@ideclineify 2 ай бұрын
That watt eyes dream uv!
@ideclineify 2 ай бұрын
You are not boring and that's for sure... glad I stayed around till the grand finale!
@paulmattle6683 2 ай бұрын
I bought one of these and made a big mistake by trying to adjust the tension rod. By the time I had it tight enough it snapped the truss rod. Does anyone know if I'd be better off buying a new neck or taking it to a Luthier to fix the truss rod. I looked up how to fix the truss rod and have contemplated fixing it that way. Or just buying a new neck and installing it. Does anyone know what kind of neck I should get? There's a few different pocket designs and I don't want to get the wrong one.
@isolirionband7300 2 ай бұрын
I man, i want to modify my amp adding it more gain ,i got a Rivera M100 and Peavey 6505+112 plus combo. Can you give me some advice?
@6dbthreshold 2 ай бұрын
More gain? Which amp? The 6505 has too much (more than enough). The Rivera is a nice cleanish fender. Soldano added more gain by adding insane non-symmetrical bias at the third gain stage. Very smooth and creamy. But mushy in comparison to fender circuits. I always recommend playing with overdrive pedals first, before modding an amp. Way too much circuit analysis involved to give a simple answer. Rob Robinette has a great website for simple amp mods. Good luck.
@isolirionband7300 2 ай бұрын
@@6dbthreshold thanks
@LedufInfraLeDufiNFrA 2 ай бұрын
very good video , but i'm really not done for sound design lol
@coolvibesradio3267 3 ай бұрын
Behringer is only slightly better than arturia but the moog is on another level. get the arturia and save to get the moog. behringer is not worth.
@JHKNVY02 3 ай бұрын
I’ve had the Katana MkII 50, 100 MkII and 100 Artist MkII Combo. IMO the artist sounds and is built much better than the 50 (I’ve had 2) but at a huge weight and size penalty making it a PITA to move, but the Artist clean is loads better than the 50, almost - very nearly almost as good as Fender. The Katana 100 MkII is the “in between” more controls than the 50, less than the Artist? sounds better than the 50, but not as good as the Artist, and a price less than the Artist more than the 50. The other problem is the Artist can get LOUD. That said for the house, I sold both the 50 and 100 and kept the Artist. Sounds amazing and love the controls on the panel. The waza speaker, shaping, cab sim, and solo functions on the artist are on the panel and don’t require using Tone Studio or the xSonic with the mobile app, an are terrific. I wish Boss would add the same controls to the entire line.
@SaschaOnBass 3 ай бұрын
Kind of funny listening to you. Nice Video man! :-)
@6dbthreshold 3 ай бұрын
Glad you enjoyed!
@mca1960 3 ай бұрын
I find the "old" firebird looks better than the new one inspired by Gibson custom shop. The sound is also the same and the tuners are not so heavy as thos banjo style ones, the new Epiphone has.
@doppelgangereffects3798 3 ай бұрын
Best review I’ve ever watched. I was wish more reviews was like this.
@stefanwerner5799 3 ай бұрын
In my opinion, adding a bright cap over the red channel gain pot is a nice improvement of the amp.
@muddyh2os131 3 ай бұрын
HUH ! I CAN'T HERE YA GOOD. LIKE THE JAM THOUGH!
@6dbthreshold 3 ай бұрын
LOL. You’ll just have to listen closely and multiple times. Perhaps your eyes are distracting your ears?
@Beets82 3 ай бұрын
Could of used a little more cowbell, really explore the space. Joking, nice solo!
@ChaplainDaveSparks 3 ай бұрын
More precisely -- those figures are *SUPPOSED TO BE* referenced to a precisely defined lightning-induced power spike with an exponential rise time of 8 *MICROseconds* and a decay time of 20 *MICROseconds.* (That's measured in *MILLIONTHS* of a second.) That said, the > 140,000 amp rating is well in excess of anything realistic, mainly because that much current would never make it to your surge suppressor (short of a *DIRECT STRIKE* on your house). In that case, all bets are off. You probably will have bigger problems than damage to whatever is plugged into this device!
@markmalonson7531 3 ай бұрын
Thank you!
@randomchance5657 3 ай бұрын
Thanks Champ! I dig the vid and your insights into music history!
@6dbthreshold 3 ай бұрын
Glad you enjoyed it
@auntjenifer7774 3 ай бұрын
😂 You got a micro freak too !? We are definitely going to be friends !
@diegob6729 4 ай бұрын
It’s not about the patch it’s about the playing 👌😅
@howardcox2918 4 ай бұрын
I always take new guitars to Spruce Tree Music in Madison,I want one and I want to Frankenstein it with EMG'S. Not sure which EMG's I want yet
@ExploreAmerica 4 ай бұрын
Bravo!
@nimitz1739 4 ай бұрын
Billy Gibbons plays 7 lol
@DavidGarcia-pi9wn 4 ай бұрын
I loved this video man Felt very real in the sense that it feels like this is what my experience would be like if I had bought it You should post a video on how to set up a guitar I felt like I learned a lot about the set up process
@EleanorPeterson 4 ай бұрын
I've seen lots of 'cheap Ricky' bass videos on KZbin, and they all have the same poor quality bridges fitted. On one review of a Chinese model the action was badly off, causing lots of fret buzzing. After much fiddling the reviewer found that the A and D strings were mounted flat, and not set to match the radius of curvature of the fingerboard (I think it worked out at 12"). By raising the A and D string mounts about 1/16" with shims, the action was improved dramatically, and the buzzing disappeared. I suppose the problem with fitting a really good bridge to an instrument like this is that it'd cost more than the guitar. 🤭
@Lordbaccus 4 ай бұрын
I just got one of these New Yesterday
@6dbthreshold 4 ай бұрын
I still have mine but haven’t used it much. I’m curious if you are glad you bought one.
@Lordbaccus 4 ай бұрын
I traded a 26yr old Peavey Raptor 6 string for it@@6dbthreshold
@sonnybrasco9735 4 ай бұрын
Great video!
@6dbthreshold 4 ай бұрын
Thanks for the comment!
@mass-1128 4 ай бұрын
Great video. What features would you like Novation to add with a firmware update?
@6dbthreshold 4 ай бұрын
Quick initialize function from front panel.
@officespace123 5 ай бұрын
this was a really fantastic tutorial - not only for getting to grips with the bass station, but solidifying core synth concepts - thank you very much!
@davidknipe3536 5 ай бұрын
Thank god for the metric system!
@LLJJEEYY 5 ай бұрын
Thank you for taking the time to do such a great tutorial. I wish I would have seen this as a year ago. Best synth tutorial I've ever seen.