Singletrax Utah

Пікірлер

@寛古田 2 ай бұрын

メタル位測って付けましょう。

@Jursaw 4 ай бұрын

I feel more confident now after watching this. My 2023 blew a seal at 36 hours. Just have to buy a few tools to get this job done

@kennethsimek8707 2 ай бұрын

same thing happened with my 2021. Seal just went out at 30.

@Jursaw 2 ай бұрын

@@kennethsimek8707 it sucks but I was able to replace my seals. Only thing is now when i compress the forks, they dont fully rebound unless I pull up on them. I can’t feel that when im riding only when im loading and unloading the bike

@timochoa1 7 ай бұрын

That was one of the best instructional videos I've seen. I feel like I can do this. I've always been a bit scared to open my forks up!

@gerrievijloen9604 9 ай бұрын

appreciate you making the video

@jamescummings8956 11 ай бұрын

What size is the tap?

@420loaf69 4 ай бұрын

Must use 5/8-11 tap

@BradVentureAZ Жыл бұрын

i love those trails !!! are you a GhostriderZ UT guy ?!!

@eastsideboys6944 Жыл бұрын

800 ml is if you split the cases and absolutely drain every bit of oil. 675 ml is the target.

@kscott8464 Жыл бұрын

Also curious to know where this is

@kscott8464 Жыл бұрын

I like these videos. Omitting the music would be better, IMO.

@Top_Pops Жыл бұрын

I use a drill with a step bit to make perfect grip holes. Op, any reason why you didn’t tap with a drill?

@dancarrow398 Жыл бұрын

Thank you this was very helpful

@josiahhepworth716 Жыл бұрын

How do you like the FC? Looking at getting an FC 450 for desert/dune riding. Gotta post more videos of the FC 350 👏🏼

@Quadeur-catalan Жыл бұрын

J'ai le même sur ma 200 exc super echappement avec un très beau son

@jackrussell9744 Жыл бұрын

Is the FMF lighter? If so, any idea how much? Do you have any idea about the top speed on the 350’s? I’m guessing the 5 speed gearbox might be a little less than the 6? Nice bikes!

@robjenanderson Жыл бұрын

From what I can see it’s about 1 lb lighter than stock. I now have 4 hours with the fmf on the bike. It definitely pulls harder mid to top end. Each gear seems like it will just keep pulling. I’m not sure on the top speed as it doesn’t have a speedometer.

@srinivasahk522 2 жыл бұрын

Any technique to remove the same factory installed bar end inserts.

@zeroh_chill2966 2 жыл бұрын

Definitely need to lose the music if you make anymore videos. The exhaust note is what the people want! Nice ride though!

@zeroh_chill2966 2 жыл бұрын

This video without music would have been SO much better. This is the type of easy riding i want to take my wife on to build her confidence

@nievoamparado3533 2 жыл бұрын

What is the size of oil seal?tnx

@ethanparidaen9160 2 жыл бұрын

My fan instantly turns on when connected to power. Any suggestions on how to deal with this? Also just want to confirm. If I put the fan relay fuse in without the addition harness directly to the battery the fan will still not run? It needs to go through this harness directly to the battery? I have tried adjusting my temperature when the fan comes on and it doesn't make a difference it is well below those temps and still decides to kick on.

@patpaluch9842 2 жыл бұрын

Does it come with a tap and a drill bit?

@IMurderdTheDevil 2 жыл бұрын

was your bike heating up, you installed new fan?

@robjenanderson 2 жыл бұрын

I ride a lot of slow technical trail rides here in Utah. It was installed to prevent the bike from overheating. The fan kicks on during the hot summer months but keeps the bike running at temp to prevent any over heating issues that come from slow technical riding. Unless you have some airflow across the radiator it will heat up.

@IMurderdTheDevil 2 жыл бұрын

@@robjenanderson ok.. Question... coolant reservoir is the plastic and radiator is the metal one. which one do you fill coolant, plastic reservoir? I'm a little ignorant on bikes.

@robjenanderson 2 жыл бұрын

@@IMurderdTheDevil The radiator is aluminum. It has a metal cap on the right side of the bike to fill it with. Be careful not to open the cap if the bike is hot as it is under pressure and will spray you. I’m not sure what plastic cap you are referring to.

@MechShark 2 жыл бұрын

Where does this track start? The road is so busy and dangerous, an alternate route by dirt bike would be awesome.

@robjenanderson 2 жыл бұрын

I have always staged off the main highway.

@kalebbelnap8997 2 жыл бұрын

Where was this?

@markidaho588 2 жыл бұрын

Thanks

@jesta.drifter1249 3 жыл бұрын

Awesome trail! I kinda like the camara mount? is it on fender or number plate? way better than chest mounts.

@avigaray 3 жыл бұрын

Congrats for the video

@kimojon9665 3 жыл бұрын

I don't know how you guys work on dirty garage floors and wear sandals, no rubber gloves. Appreciate the vid though.

@zeroh_chill2966 2 жыл бұрын

Bro what!? Lol.. He’s not a doctor. WTF he need gloves for. Some people don’t mind getting dirty. How are you on a dirt bike channel and afraid to get dirty. “Dirty garage”? You mean dusty?! That’s a pretty clean garage floor if I’ve ever seen one. Dude aint doing a heart transplant lol

@Thatsupermoto 3 жыл бұрын

Hey man I just got a 2022 ktm 300 xcw tpi and I'm wondering when I should change the oil

@Thatsupermoto 3 жыл бұрын

It is at 3 hours

@robjenanderson 3 жыл бұрын

I have personally done my first oil changes at 5 hrs. I like to then do it on the 20 hr marks. For me it makes it easier to keep track of when I need to change the oil. If you are racing I would recommend to change the oil more frequently. If you ride slow single track I’ve had good success changing every 20 hrs.

@Thatsupermoto 3 жыл бұрын

@@robjenanderson thanks

Ең жақсы KZbin

Пікірлер