A beautiful endorsment for american cars.

With all the people having problems with the samething, you would think dodge would have a recall on their trucks also drivers seat

Thank you very much Sir to share your Knowleges. It is appreciated

Thank you, this saved me time and money. Exactly what I needed!

So is the door/shaft going bad or your actuator? I think I have exactly the same thing going on, but is it the door and shaft that need to be replaced because of the pressure or something else?

The rod on my truck just keeps spinning.. does that mean the flap is broken?

So helpful thank you but damn that’s a lot to do

If you look up through the floor vent, you can see a mode door. Would you push the door up or pull it down to switch it to defrost?

THANK YOU I WAS WONDERING WHAT WAS WRONG AND YOU ANSWERED!

Did not work for me

You can actually fix that blend door reaching up through the blower motor once its removed.

I found that all my blend doors were all stripped. Tore out the cowl, replaced heater core, evaporator and installed the aluminum blend doors on my 2004. PITA. It took exactly 8 hours just like the book said. But now it’s done.

Thanks buddy!, makes sense, recently replaced my heater core. The door on the fan moter did look bad. Seen a tip to zip tie it to the grating if it cant be replaced.

Hey at least I can get some defrost in the mean time. Thank you sir.

I found same problem, turn fan off set defrost, turn fan on

🤬

great video sir!

I’ve done a lot of digging around on this and You my friend are the Man!! Well done and thanks you saved me hours of work. I will fix when time is available Thanks again

Well done sir!! Same exact issue. No defrost! Then...used your described sequence and voila! defrosting! Same sequence to go back to cabin air!! Thank you, Thank you! You saved me from spending money and time before it was needed!!!

Dude your video is black

My nightmare

Thanks for the video. It help fix my problems.

Man these Dodges are pieces of S**T!!

Durango too. 👍

Just purchased my dodge 2004 couldn't get it to switch to defrost. I Shut blower motor off switched to defrost no problem. You saved me alot of time. I was ready to tear the dash apart. Vacume lines were all good couldn't figure it out. Thank you

Thats cool, I shut off the fan, moved the switch all the Way back and forth and just like that when I turned the fan on it was working on defrost, thanx it was a big help!

Thats the wrong door the door your looking for is under that one right behind that metal panel below the mode door switch your pointing at. The one you pointed at controls dash vents on and off

Come summer again I'm replacing everything including the heater core and wht not under the dash, this will be a one time deal hopefully those pesky gremlins once you fix something everything else will start breaking

This has helped a lot, I've noticed that the vents are all I get, i watched this video and turned the fan off and the defrost worked afterwards

Thank you. It helped my problem. God bless.

My 2008 Dodge Ram 3500 will not "switch to defrost" as well. The solution was to turn down the fan speed before moving the heater system door from vent to Defrost. It's weird but works.

Work for my 2004 3500.... Thanks...

I’m going to give this a shot hopefully it works. I have replaced the blend door and two of the 4 actuators with no luck. And the stupid Ac/heat control knob. Good video thanks for the info