Solid review of real use! And not just opening and closing it once or twice a day

How does it handle pine needles?

Where did you get the thread maker for the new holes???

its useless it does not pickup large item

wish you had one for a first gen

What air filter is that?

I was taught to put grease on when I installed a battery.

Do you mind putting in the comments what size terminals you had to get? And were they just Napa brand ?

Dirty battery tops will discharge the battery. Oil attracts dirt.. just clean the battery top every oil change.

Just solved my solar battery problem

What type of oil are you using. motor oil?

WD 40 is good??? Oil is 40$

Did all of this. Then when I went to adjusting the sensor with the set screw I could not get it to go below .7 volts

274k on my 5.4 2 valve with 10w-30 its entire life.

Hey I have a 1999 24v that is idling at 1000-1200 after tapping the throttle. It only goes away once in gear I follows everything in the video but still doing it. Any suggestions.

Need more vids with the gen 10 f150 !

Thanks man your a live saver

Gmorning i just joined the group. I also have a 99, 24v. Mine just quit with no notice while towing a trailer. I have a.code.reader but it fails to.connect. The wait light stopped coming.on.a.while.ago, but the truck cranked up and ran fine. If i shoot some.start fluid in her she wants to start. So i took a chance and replaced the CPS, made no difference. The fuel pump is not.receiving any.power. Does this act like i need an ECM? It has 327k miles use to run great. The PO had changed the IP. Ricardo

Yup, dem towers will work you 😊 I've climbed a bunch in the plants when I did turnarounds. I'm too old for that stuff now.😂😂😂

Thanks for uploading Sir

RTIC coolers are ROTO molded, it says on their website. Nice video!

Does it work on the artificial grass?

I would suggest avoiding ice all together.

I see you like Royal Purple too.. I've been a user of it since 1988, won't run anything else.

I use grease but oil is new for me.. thanks

Bakingsoda and lukewarm water does the trick too

A chia pet,two good points! I definitely will try it, thanks.😊

A note to my previous post: Their is no indication of any problems with acceleration or throttle response or problems with ABS. Thanks

Good video. Now I need your opinion. Iam getting a ABS and Brake light on my 1998 Dodge 2500, 24 valve Diesel. My first thought was a faulty speed sensor on universal. However when I run codes it gives me a P0122 and P1693 which indicates a faulty TPS. I also had a check engine light but that has since disappeared. My question is : why would ABS and brake light show if TPS is in fact bad? Are they related some how? Or are they both bad? No code indicating speed sensor however just ABS and brake light.

I sell mine, its a unusable sh.t! Its not for use, its for sale. 80% of dirt is lost. I give 1/5 for this product.

My truck doesn’t have a dead pedal and can drive but it’s idling at about 1200. I’ve tried researching to see if this is common with the AAPS but everything I’ve read says it has a high idle AND dead pedal? Just trying to make sure it’s the AAPS before I drop the cash and that’s not it…

I don’t have one of these trucks but what a great video. I sure appreciate people like you taking the time to make these types of videos

Fantastic video. Very helpful for the diy guy. This has got to be my initial pedal feel issue.

great video, to the point

great video, to the point

hey man you got a link for the kit you used? great video, just subbed.

did you restore your stock headlights or are those repros?

The oil eventually will place between the clamps and the battery post and will not longer make a good contact. I’m a Jeep owner And a professional truck driver. I just to do it but I learned it . Sounds logical but in reality won’t work .

I hve been driving for 30 yrs & nvr done thys. Nvr had a problem with thys so stfu already that chyt happens on fords

Nobody's heard of it because it's unnecessary. If you're the kind of person who allows your car's battery terminals get corroded. Then you have a whole different set of problems to worry about in your life.

Thank you

Get a AGM battery.

Great Review!

We use a red grease in a spray can that is specially sold for battery terminals. Works pretty good.

I underspray them

I’ve had a canna battery terminal protectant spray for 20 years now I’m not a professional mechanic but I’ve gone through maybe a quarter of it and I’ve seen and used it on 50 vehicles it’s cheap

Side post batteries..... 20yrs in no corrosion.

A long-haul trucker made a million miles without an oil change

You know what else that pil does keep uour dodge from rusting out. Thats chrysler undercoating

I really like the way you explained. IED.😂😂😂😂