2 жыл бұрын
6 жыл бұрын
Пікірлер
@supersonicsoares2425 5 ай бұрын
Are you a angel
@beast3508 Жыл бұрын
The base of the sensor bed can also be lowered and raised
@beast3508 Жыл бұрын
There is a square on which the bed is fixed. There are two parallel columns. Unscrew the screws and place the two parallel columns higher so that the bed is balanced.
@beast3508 Жыл бұрын
I have solved this problem. I hope that everyone who has this problem, the bed base, should be done in reverse. The 8 screws should be unscrewed and fastened from the top.
@brianchristenson6055 Жыл бұрын
That was sick! Great vid
@Duhvidd Жыл бұрын
Thank you I really appreciate that
@carlton997 Жыл бұрын
That's a common issue with these, try adding a Z axis belt drive system. Less that 15 bucks online. That helps tremendously
@steveu235 Жыл бұрын
The problem is when it starts to print the bed drops about a millimeter or 2 it doesn't go the z offset posision
@TalkingGIJoe Жыл бұрын
Did you try adjusting the center screws when probing the center?
@DeprisaDryICeBLasting 2 жыл бұрын
Hi there I'll just got one still can't.get the correct level.. could you please share corner bracket STL...
@DRHON-EL 2 жыл бұрын
a very nice location and amazing footage ! I subscribe
@Duhvidd 2 жыл бұрын
Thank you so much ! 🙏
@GumptionGarage 5 жыл бұрын
Exhaust sounds nice, what is that?
@Duhvidd 5 жыл бұрын
E.F. Insanity thank you man! i was running a 4-2-1 header with 2.5in stainless piping to a DC axle back no left side bend!