Hey! I got a great idea! Start the fucking bike

In my country Those splines, just the splines alone cost a fortune I'm looking for a 20mm rough spline for my bike buut super hard and not in my price range Any idea from what other bikes the 20mm kickstart lever come from?

Thanks my man.

Just came here to thank your for the Honda carb idle video.

My Goodman furnace looks a little different but the advice worked like a charm. Thank you!! We are beginning to thaw out 🥶

What if you do that and it still gives the same code? What if you replace all the limit switchs and it still gives the same code?? What if you replace the board and its still the same?? I am stuck.

You just saved me from having to call someone out on a Sunday…it’s -18 here and woke up to a 40 degree house. Thank you.

On my furnace, I was getting 10 flashes and was not sure what this was so I pulled off the fuse off the circuitboard that noticed that it was bad. I went to Home Depot found one replaced it and my furnace works perfect.

Worked like a charm

I have a goodman but it’s not the same style, and this still applies. If it’s blowing cold look for the style button he points out! Mine was way different layout with the same buttons! Thanks so much! I have heat again!

I’ve been messing with my furnace all week. Checked everything from fuses, drain pan, igniter wiring and nothing until I came across your video and tried this!! Thank you so much🎉🎉🎉🎉🎉😅

Thankyou so much

Thank you so much for getting me to this step!!!!

Just be careful folks a roll out switch is exactly what it means. Flame rolling out where it shouldn’t be. Perhaps the storm caused air to be pushed down the chimney causing the flame to roll out of the heat exchanger into the house. It’s best to watch to make sure the flame doesn’t roll out any more if you reset the roll out switch(not a fuse). Best to have a professional taking a look at it.

Thanks brotha this is how simple youtube videos should be

Saved my ass in a pinch. Thanks a lot!!! I'll still investigate why it happened.

I owe you one!

you just saved me a couple hundred dollars. thank you friend. liked and subbed

good job

Thanks for the tip. You saved us during a winter storm.

Thx Bro❤

Thanks it helped me with my problem!!

Thank you so much friend..you save my 500 bucks 👍👍👍👍

My fuses were up higher, but this was the solution! Thank you!!

Is this the same on all years of ttr?

Hey good video.. my issue is different though my led light isn't on. Its the control board error. I have voltage everywhere including the transformer not sure why the led light isn't on

I tried one on my 1987 CR500. It does fit but to get a good kick I had to move it ahead 2 extra notches. Doesn't fit good that way but so far it's working.

Hello. For the air filter do you have to remove the battery every time? Or you just put asides the wires?Thanks

It’s great how short this video is. Just got to the point and showed me exactly what I was wondering.

Please keep us updated

Please keep mak>ng videos about qthis bike their are alot of people who never had a bike.

Thanks saved my from a cold day.

감사합니다

Thank you for the video you’re a lifesaver and save me from calling A service tech can’t thank you enough

Thank you for the video I have heat now ..Thank you 🙂..

This video saved me from freezing my ass off. Thanks!

What’s the wedsite to get one

So I get 6 beeps om my furnace. But only when my furnace is working really hard. For the most part furnace is fine till we get a cold snap then I get the 6 red blinks. I usually cut power to furnace. Then back on and it works. But it usually happens when its really cold.

do you know if the 1987 kickstarter splines are the same as the 84 cr500? looking to find a kickstarter replacement for it that has a longer throw for easier starting.

So would this cause ot to blow out cold air

Price???

Nice video. What’s the price on this bike ?

get metal zip ties.

Thank you so much . You saved my Sunday . God bless you

Nice review John, we're you able to title this bike for the street?

Mine keeps popping the fuse. No heat

I’ve had mine at a small Mx track, it’s great for an old man! My rear shock is squeaking so it’ll be changed for a 2009+ crf-r shock in the future. She runs beautifully though🙂🙂🙂

Thank You soooooo much. I’m a single mom with two kids and this absolutely fixed my furnace problem. I would not have been able to do this on my own without your help.

Where did you get it

Thanks👍