Daniel

Пікірлер

@ВиталийШарыкин-и7м 2 күн бұрын

Рассматриваю такой аппарат к покупке, но что-то после Вашего видео я его перехотел😂😂 спасибо большое за видео!!

@AntonKarpuzikov 6 күн бұрын

just found solution to 0x80E70004 1: In NIUBI, right click on the disk you want to add, delete all partitions, apply. 2: In diskmgmt.msc, create a NFTS partition with 4096 cluster size 3: In NIUBI, delete the partition you just created 4: Reboot 5: Open storage spaces and add the disk try it!

@EyebexRadio1710amSoCal 15 күн бұрын

How did you record this?

@seankearney2592 29 күн бұрын

Great Job Can you do a Video on how you done the Lights amazing...

@patricksalvador3653 Ай бұрын

J'avais cet equaliseur je l'ai vendu et regrette

@brankotrenkoski5278 3 ай бұрын

Do you maybe have service manual for Monarch 5700?

@brankotrenkoski5278 3 ай бұрын

nice work BTW :)

@daboss59 6 ай бұрын

We have a onkyo system at home.

@gabrield8902 6 ай бұрын

This is not a STEREO receiver... It's a surround 7.1 system.

@InfectedCreations 6 ай бұрын

Oke.😊👍 Most of the time I always use the same top line for the radios.

@Ejlectronics6 7 ай бұрын

I'm new to receivers and tuners. Does the antenna wire have a big impact on the quality of the FM/AM tuner? My unit, the same as yours, sounds very crisp in FM but when I turn to AM it's pretty bad unless I press down the MW/LW switch. Is it because I'm using the internal antenna only?

@InfectedCreations 6 ай бұрын

Yes it's always better to use an external antenna the best is to bring it outside your home. 👍✌️

@Ejlectronics6 6 ай бұрын

@@InfectedCreations Thanks for replying. The FM is surprisingly very good from the signal in my basement! Lastly, how did you go around adding the custom LED lighting? Did you use the 8v connectors that the bulb uses also? I've just replaced the bulb but the LED lights look great!

@InfectedCreations 6 ай бұрын

@@Ejlectronics6 I have added an external power supply from 220 volt to 12 volt and build it into the receiver. :) It turns on when you press the power button. Sometimes i have pulled it from the circuit board, but to many lights can or will overload the circuit board that's why i seperate it. It's safer to do so to protect your circuit board from high currents. 😊👍✌Calculate the bulbs that was standard in the device P=UxI then you get watts. Stay around here, but if you get far above it, use a separate power supply.

@chandershekhar5972 Жыл бұрын

Very nice 👍👍👍👍👍👍👍

@chandershekhar5972 Жыл бұрын

Omg

@chandershekhar5972 Жыл бұрын

❤❤❤❤❤❤❤❤❤

Ең жақсы KZbin

Пікірлер