Ponderosa Garage Doors

Пікірлер

@gregorylambrihgt2757 3 ай бұрын

Where did you get battery backup?

@mazharuddin1942 3 ай бұрын

How to fors adjust

@rafaiturralde9218 5 ай бұрын

how do you remove the front cover to access the emergency release cable . the door was closing on a windy day and the pull handle got stuck in the rolls now it does not work i pull the string but nothing happens. the door does not engage.

@leewilkinson8328 Жыл бұрын

I just had a new garage door installed. It takes some force to start to close it. Will this unit work?

@Tendertroll1 Жыл бұрын

The top panel of his garage door is not flat whenall the way up. Is this because of the side motor?

@jbklaudt Жыл бұрын

How do you program the remote

@1agaragedoorssacramento Жыл бұрын

Great video!

@korykolsbun9769 2 жыл бұрын

Any idea how to add a key release from the outside? I don't have an entrance other than the garage door so if mine breaks I'm out of luck

@williammorales8204 2 жыл бұрын

Certainly sounds like it. I haven't seen one yet in these vids.

@llmiller6895 2 жыл бұрын

We have a chain on ours to open manually, does this get installed beside that mechanism and just over rides the chain? or do you have to remove the chain first?

@IMiss_The90s 2 жыл бұрын

Getting ready to build. My ceilings are 14 feet. My garage doors are 12 feet. Can I still have my doors hug the ceiling? Or do I need to go 13 foot high doors?

@maiyang2778 2 жыл бұрын

I need help. My liftmaster 8500w has an error code 1-6. What does that mean? Can't find the answer anywhere.

@2015_Rubicnn 2 жыл бұрын

Call Liftmaster

@KarateSensei71 2 жыл бұрын

Diagnostic Code: 1 Up 6 Down Why the error code is being displayed: RPM detected after motor shut off at the open position. Door/Opener Behaviors: The garage door moves down after reaching the open position after the motor has turned off. Note: RJO openers will show this error code while manually operating the door. Symptoms/Resolution: Opener activates and brings the garage door to open position Opener activates and brings the garage door to open position: Test the balance of a garage door. Motor attempts to reopen a closing door Manual disconnect pulled: Reconnect the manual release.

@obduliagabriel968 3 жыл бұрын

Remote so sensitive good thing i turn back my head i saw my garage door was open again. My remote was inside my purse it might press accidentally.

@pbm7858 3 жыл бұрын

Every so often ours has a problem where when it closes, it'll pop back open and say that Excessive Closing Force detected... Any thoughts? There doesn't seem to a direct force adjustment with these, just the travel adjustment which I then try to redo whenever this starts happening.

@nafear72 3 жыл бұрын

These units are very sensitive to any sort of obstruction or if the door is not travelling up and down the tracks smoothly it will sense a drag and it will pop back up. I had one where the door was dragging on the climate seals/ door stops and from time to time the door would go back up. Release the door and move it up and down and make sure it is nice and free. Also make sure the down limit has not been set too far.Use bee wax if you need to.Hope this helps

@migueljimenez3036 3 жыл бұрын

I installed one, I like it but even though I leveled it correctly, it has a slight wiggle when running. Is that normal? Thanks

@stdenis25 3 жыл бұрын

I have the same "problem" - if you watch his unit its doing the exact same thing! thinking that might be normal

@nafear72 3 жыл бұрын

We normally level the unit before tightening up the set screws at the side of the torsion tube. That seems to work for us. Level the unit, then tight the sets screws. Hope this helps Miguel.

@shrimpmoney8 2 жыл бұрын

Nofziger Door just installed this unit at my house today, and it does have a slight wiggle.

@bradbarnette716 3 жыл бұрын

Is it still possible to manually open the door with this opener installed?

@ponderosagaragedoors 3 жыл бұрын

Yes Brad you can. You can disengage this motor just like any normal garage door opener

Ең жақсы KZbin

Пікірлер