Shallow well pumps are not a submersible pump it is usually jet pumps or centrifugal pump that are installed above the ground near wellhead. They are designed for shallow wells where the water level is usually less than 25 feet deep.

In a planetary gear system, the carrier is an arm.

The standard operating temperature range for fluid coupling operation typically falls between 30°C to 100°C . However, specific applications may allow for different ranges, so it's essential to consult the manufacturer's guidelines for the fluid coupling operation.

@@sebyamentor6883 If the temperature is above the temperature range, what will happen?

@@sebyamentor6883 in the video MCQ on fluid, you said the temperature range is between 100-150 degrees C

Ordering a serpentine grid coupling without specific data requires a general approach. Here are the steps you can follow: Determine Basic Requirements: Application: Identify the type of machinery or system where the coupling will be used. Torque Requirements: Estimate the maximum torque the coupling needs to handle. Speed: Note the maximum operating speed of the application. Shaft Sizes: Measure the diameter and type of the shafts that the coupling will connect. Space Constraints: Measure the space available for the coupling to ensure it fits within your setup.

@@sebyamentor6883 Thanks for your Information

Video has been posted in my Channel

Manufacturers provides the data for load calculation. Accordingly we select the gearbox model.

Please watch this video. Link is here: kzbin.info/www/bejne/fKmxiaZoht6YoZIsi=It-GrkFeX_8gR4m0

@@sebyamentor6883 BSS ke bare me toh bataya hi nahi. Aur electrical protection me aur bhi protection hote hai iske alava. Woh mujhe pata lagana tha

Here are some general guidelines for common types of welding electrodes: Low-Hydrogen Electrodes (e.g., E7018) - Temperature: 250-300°C (480-570°F) - Time: 1-2 hours Cellulosic Electrodes (e.g., E6010) - Temperature: 150-200°C (300-400°F) - Time: 1 hour Rutile Electrodes (e.g., E6013) - Temperature: 150-200°C (300-400°F) - Time: 1 hour Basic Electrodes (e.g., E7016, E7018) - Temperature: 350-420°C (660-790°F) - Time: 1-2 hours Special Alloy Electrodes - Temperature: Follow the manufacturer’s recommendations, as they can vary widely depending on the alloy composition.

Viscosity is a measure of a fluid's resistance to flow. For oil, viscosity can vary significantly depending on the type and temperature of the oil. 1.Low Viscosity Oil: This means the oil is thinner and flows more easily. 2.High Viscosity Oil: This means the oil is thicker and flows more slowly.