Unfortunately there was no fix here. The bubbling cells were producing hydrogen gas ..... overcharging. This caused another cell to drop out and we were at 8.6v ==destroyed. Try adding concentrated sulfuric acid to you weakest cells. problem is getting pure acid at more than 10%.
@THEOFFGRIDMOUNTAINHOMESTEADАй бұрын
Are you using 2-100W in series?
@zaneenaz4962Ай бұрын
Victron mppt (see phone app) has 300W panel in parallel with 2-100W (in series) panels. The pwm-solar charge controller to the right has 6-100W panels in parallel. Both controllers fed 178Ahr-12.8v LFP battery. that powers a 600W inverter.
@bemsela36922 ай бұрын
Washing cycle always on.
@bemsela36923 ай бұрын
Energetic
@stephenrogers96643 ай бұрын
The old Vanagon’s don’t like the heat. We have the same problems over here in Australia
@zaneenaz49623 ай бұрын
Replacing the plastic cooling pipes (see Key Vanagon Upgrades video) that run the length of the Vanagon with stainless steel pipes, like from GoWesty, has a big impact during summer driving. No longer have to dump heat using the rear heater
@stephenrogers96643 ай бұрын
@@zaneenaz4962 I’m def going to look at a set of those pipes. I still have the old plastic pipes.
@zaneenaz49623 ай бұрын
@@stephenrogers9664 also check wt busdepot.com ..they have cheaper 2-piece pipes
@davidpatrick18133 ай бұрын
You bet, the coast . .it was 72 for me. bandon
@zaneenaz49623 ай бұрын
Cool marine air !!
@stephenrogers96645 ай бұрын
They are a great idea
@petea73235 ай бұрын
Isn’t there a spare tire in the menu amongst all the crap on the touch screen?
@zaneenaz49625 ай бұрын
or the re-inflation kit that gums up the tire pressure sensor. ....more $$
@biscuitcatz5 ай бұрын
Is that a Jeepla?
@НовиковСергей-з4п5 ай бұрын
🥲😢😥😭😭😭🤦♂️
@tybi125 ай бұрын
i cant lift mine.what i noticed when i try to bind the drone moving the joystick up end down it does not make any sound.is the problem with the controller?is beeping when i make the other preflight operations though
@zaneenaz49625 ай бұрын
There are several ways to calibrate/bind the vertical and horizontal gyro. one way is to use the two buttons on the right hand side of the controller.....you should see and hear cues for horizontal and vertical. the other way is to use the "calibration" functions that are in the Rx Drone software program where you see the modes of flight (circle, waypoints). The battery for the controller needs to be carefully watched....it runs low very quickly...many choose to replace the battery.
@aadg116 ай бұрын
Thanks for this video 👍👍👍
@zaneenaz49626 ай бұрын
Draining these large packs too far is really hard on the cells. Rebalancing on recharge is critical.
@Veritasnetwork6 ай бұрын
Please speak more quickly. Also, promise me you’ll never work taking emergency calls. People lives may rely on getting out more than 5 words per minute.
@tomn52jz53Ай бұрын
🤣😭😂
@hettze7356 ай бұрын
first
@AJ-qn6gd7 ай бұрын
Elephant 1 Syncro 0
@jahsurhofjudah60537 ай бұрын
Man, no closure is displayed.
@Dubnoid8 ай бұрын
Omg....What was that elephant driving ?
@vw4x48 ай бұрын
Your another idiot in action...
@stephenrogers96648 ай бұрын
Great tip. I’m in Australia, & I quite often run a fan in my van for a couple of days non stop. That always help 👍👍
@zaneenaz49628 ай бұрын
Opening up also exercises the fabric. Scotch Guard protects it, too. The little things make a difference.
@RichardNaslund9 ай бұрын
That's very nice I'd love to buy that
@RisijayaVimukthi-y5w9 ай бұрын
Can the L900 drone be connected to the iPhone 6s?
@zaneenaz49625 ай бұрын
Have only used Android phones..LG V40 and Note 1+
@breandanh49129 ай бұрын
How much?
@zaneenaz49629 ай бұрын
was salvaged for parts.
@mlmora099 ай бұрын
Thank you for the video!
@CNCRobotics-fh8iq9 ай бұрын
You need rotate drone on all axis for calibrate of accelerometer
@zaneenaz49629 ай бұрын
You are correct, i failed to show the drone being rotated. At frame 6:42 we showed how the software: (1) prompts to rotate 3x clockwise for the horizontal stability control calibration, and then (2) prompts the operator to hold the drone face-down for 3x clockwise rotations for calibrating the vertical stability control.
@mariuszbernad39279 ай бұрын
Jaka aplikacja do filmów
@zaneenaz49629 ай бұрын
VLC player to view and OpenShot Video Editor.
@sergiogomiz36479 ай бұрын
Eso con cariño se arregla, es una Syncro 💪
@zaneenaz49629 ай бұрын
Mucho cuidado y amor.
@zaneenaz496210 ай бұрын
0:09 Surround Set 0:57 GPS Tracking of Drone 2:05 Video from Drone
@rockhoundingeasternwashing530810 ай бұрын
You need to use a battery electrolyte hydrometer
@eprohoda10 ай бұрын
wow~ very best drone~=))
@zaneenaz496210 ай бұрын
It's a start. Your work is very impressive. Thanks.
@HINCHOIWONG10 ай бұрын
Can show setting up waypoints?
@zaneenaz496210 ай бұрын
Thank you for the comment. Sorry it took so long to make the video. All kinds of technical problems. Here is my first attempt showing waypoints with Lyzrc L900 ... kzbin.info/www/bejne/pYLThaFsisiAqa8
@Buck756711 ай бұрын
Very poor customer service Their so called warranty involves them sending you parts so you can tear it apart and fix it yourself I made the mistake of buying 2 of them
@pyronitro Жыл бұрын
Sorry for your loss :(
@randphong Жыл бұрын
Oh noooo! It's a Syncro as well. 😭
@SUP-2101 Жыл бұрын
Як так?
@zaneenaz4962 Жыл бұрын
дивна аварія ... але тут часто дерева падають на машини. Легкой дороги тебе дружище!!!
@SUP-2101 Жыл бұрын
@@zaneenaz4962 Дякую!
@steveadal4735 Жыл бұрын
Is the successful battery a new Lithium what amp hours is it ❤❤❤
@zaneenaz4962 Жыл бұрын
Yes, Ampere-Time 100Ahr LiFePO4...fully charged its like 13.3V so the voltage sag is well above the 10.5 low-voltage alarm of most inverters.
@Syncere20 Жыл бұрын
Part of the problem is the size of your cables they are way too small you need some four gauge at least also the length of cables should be as short as posible. Thank you for making this video.
@zaneenaz4962 Жыл бұрын
Fortunately they provided four cables that i ultimately used (shown in the video). My lead acid battery was connected with very thick automotive grade cables. It appears 10 AWG, or lower is needed (6mm or greater diameter) to power the refrigerator via the inverter. It is noted that this inverter at idle, without powering an ac-load, consumed close to 2 amps. Even switched off it was consuming power from my batteries.
@DanTheManIOM Жыл бұрын
glad everyone walked away from it.
@DanTheManIOM Жыл бұрын
wow, that quite the hit. I came here since my two metal tubes are bent on mine and I had just enough clearance to get the radiator and ac out.
@zaneenaz4962 Жыл бұрын
vw tried and did make a solid front-end. A sturdy steel toy.
@lukebarber9511 Жыл бұрын
So, does anyone make a Metallica Combo Adapter? ...I hate myself for making that joke...
@bemsela3692 Жыл бұрын
Pretty clean video signal to the phone I guess...
@zaneenaz4962 Жыл бұрын
yes....no sd-card
@RODOLFO.M.S Жыл бұрын
🙏🏼🇧🇷🌱👍 Bobina Bifilar 🤔
@zaneenaz4962 Жыл бұрын
Thanks
@bemsela3692 Жыл бұрын
20% improvement by increasing the switching frequency. Lowered the battery drain rate. You went from 1.08v to 1.25v on the discharging battery. Great savings!
@RODOLFO.M.S Жыл бұрын
🙏🏼🇧🇷🌱👍
@bemsela3692 Жыл бұрын
Nice work .... worth the effort and money.
@zianzan4536 Жыл бұрын
Hi, it's a bug in the APP, with low current, no data is shown. Bluetooth frames (which are not encrypted) are sent each second with correct data. Hoping this APP will be corrected soon.
@zaneenaz4962 Жыл бұрын
Finally got the application program on the computer to intercept the bluetooth data packets. still very disappointed by the bluetooth protocols and the reduced precision in the transmitted data. This could have all been executed better. Drives me to want to program my own stuff.
@zianzan4536 Жыл бұрын
@@zaneenaz4962 True, I think precision is less in the bluetooth frame because it's written on 2 bytes for example 0x3275 => 327.5V. In my case, I don't intercept bluetooth data packets => I use a board HM-10 to directly connect to the tool and then I put the notification ON for one address. But I don't find the energy in Kwh in the notification frame, but as it's visible in the APP, maybe one command frame should be send to get it back (with bluetooth interception, it's would be possible to find it, i will try). Moreover, I can't find what Power factor means, because it doesn't seen to be equal to [cos Phi].
@konstantinschmidt9161 Жыл бұрын
Могу вас уверить.. Такой же Вус у меня в руках. Только положительные эмоции.. Конечно много надо было уже сделать и отремонтировать. Езжу только летом. Моему вусу уже 33 года и он ещё не старый. Техника и качество меня устраивает. Я очень сожалею что ещё один VW Bus T3 умирает на свалке.
@zaneenaz4962 Жыл бұрын
С наилучшими пожеланиями .... эти вещи - труд любви.
@nikolajhol Жыл бұрын
Overall very pleased with my unit. Some observations re solar charging: After thorough testing, I can't figure out why solar input to the Pecron E600LFP is relatively low with panels in series (all other configurations, i.e. single panel or in parallel behave as expected). This is our test results (done with 340 W qcells rigid panels - Voc of 40.91 V and VMPP of 34.10 V): 300 W solar input from a single qcells 340 W panel 270 W solar input from two(!!) qcells 340 W panels connected in series So even lower input from two panels connected in series, than from a single panel!!?? 390 W solar input from two qcells 340 W panels connected in parallel 393 W solar input from three qcells 340 W panels connected in parallel Anyone got an idea, why the Pecron E600LFP has such a relatively low solar input from panels connected in series?
@zaneenaz4962 Жыл бұрын
The MPPT senses the photovoltaic panel(s) voltage and currents (I), the change in I with V is then used to determine the operating point for the charge controller. Was not impressed with this charge controller....the controller was slow and sub-optimum. My testing of the borrowed Pecron unit showed that parallel solar panels deliver more energy and recharged the Pecron faster. Otherwise the Pecron and its inverter were great !
@nikolajhol Жыл бұрын
@@zaneenaz4962 Thank you for replying. Just really disappointing - and strange - having a lower solar input from TWO panels connected in series vs ONE single panel on its own. Under sunny conditions, it doesn't matter much, but in cloudy conditions (with much lower amps), it would be nice to have 80 volts from two panels connected in series rather than 40 volts from a single panel.
@zaneenaz4962 Жыл бұрын
@@nikolajhol Power=V x I ...the current times the voltage matters. Early low light turn-on/charging always desired, but the mppt still manages to catchup. My preference is the panels in parallel, so each has the ability to deliver max current.
@senshiendo Жыл бұрын
Que preciosidad, felicidades al dueño de un vehículo tan genial
@zaneenaz4962 Жыл бұрын
Gracias, después de criar a cinco niños con vanagons, ahora es bueno tener una casa rodante para escapar...
@Shantiman Жыл бұрын
Эх...жаль хороший был бус
@zaneenaz4962 Жыл бұрын
Спасибо .... вы правы.
@strannikgalaksi5431 Жыл бұрын
И ещё раз повторюсь, консервные банки.
@zaneenaz4962 Жыл бұрын
все же намного лучше, чем сегодняшние пластиковые автомобили....