Looks good! I always over engineer things also. It's fun.
@clivewilliams6014Ай бұрын
Thank you very much
@mikesuch9021Ай бұрын
According to Foxtrot Mike 9 mm barrels are supposed to be torqued to 34ft lb
@mikesuch9021Ай бұрын
I see the threads on the barrel underneath the handguard but instead of the nut somebody welded it on
@jessepalmer69974 ай бұрын
Awesome info
@Weout774 ай бұрын
What ya smoking?
@mikesuch9021Ай бұрын
Bobbitt brand
@tylermulkey3304 ай бұрын
do you know if this works for the 8750 predator inverter model? i think its the 420cc engine?
@DudeSchit2 ай бұрын
I’m not sure. But the dude at Greenergy is awesome. I’d reach out to him.
@timmahccgАй бұрын
as long as that model does not have its own integrated regulator in the way (would require more work in removing or bypassing it). most of these conversion kits are generic and have a flow restrictor (like a screw that is tuned to the size of the engine and load) and most kits have you adjust the restriction for ng flow rate to match the engine size and intended load anyways. You can see the screw adjuster on the 90 degree fitting that goes into the outlet on the included BIG regulator on both kits. main issue is just the sizing of fittings. The ngk plug a good point as most generators come with a poor stock spark plug. should be gapped less for ng operation and 1 step down cooler range.
@bobdole234bd6 ай бұрын
Hey, just so you know the Montgo upper and the Mat-9 uppers are a bit different. The Montgo uppers are a bit shorter and seem taller and run on what looks like an earlier generation of their design. They're on sale because they're discontinued and being phased out. The new ones (more like what you have there) are the Mat-9 and the Mat-9K uppers that are going for 500ish. They all seem cool to me, so I agree that for $350 the Montgo is a cool upper. Just wanted to point out the distinction.
@DudeSchit6 ай бұрын
Yes. You are Correct. Thanks
@jimb92657 ай бұрын
Perfect! Thank You!
@tombond90329 ай бұрын
I'm a disabled veteran who cannot use my hands, These plugs should be OUTLAWED!! They are another Nanny state POS! WTF?? Many thanks for your video, I bought Leviton, very similar to yours for my old camper van and it has 4, very small, Phillips screws on the back. Sure hope it works on a Leviton and thanks again!
@tombond90329 ай бұрын
YAHOO! it works on Leviton also. Remove 4 very small Phillips screws on the back. pull the receptacle apart. Then remove both white pieces of plastic and the spring on each plug. Put it back together and you will have an easy plug to use, screw the Nanny state.
@DudeSchit9 ай бұрын
Hell yeah. Glad to hear that!
@MySierraNevadaLife11 ай бұрын
Looking for a conversion kit for the Wen 4800, because it only weighs 77 lbs! Do you know if these kits could work with another brand of gen?
@DudeSchit11 ай бұрын
No I don’t. But if you reach out to Grenergy they can probably help. The did is pretty smart and most of these gennies use the same or similar carb setups.
@declineofthewest.10 ай бұрын
Yes, they should have one for that generator. I just bought one for my WEN 4750