Great vid! Worked perfect!

Thank you!!

Nice truck!

Lights are important

Mines wont close properly and it shifted to the side in the back corner. Im not sure how to fix it or what brand it is. It was my dads who passed away last year. He knows the ins and outs to the truck, im trying to learn myself

Beautiful baby. Love blk cats. Had one & will definitly get another one. 😂😂😂😂😂😅😅😅😅😅❤❤❤❤❤❤❤❤❤

as terrible as the recording was, that was extremely helpful. thanks

I repaired my 2013 Ford Edge SEL today and purchased my cooling fan assembly from a local NAPA Auto Parts here in the Oklahoma City area. It was listed for $253, but they were running a 20% discount this month. So after the discount and added tax, it only cost $220, a lot cheaper than a Ford OEM part replacement & installation! One note as a suggestion for the installation, take the module off the assembly before installing to allow for better clearance from interference. My cooling fan assembly only had two (2) 8mm bolts at the top and two (2) 8mm bolts on the air cleaner housing. I just used a 1/4 in. drive ratchet with a short extension...easy access!

Where's the old filter? The one you took out?

Wife panicked when she hard the noise, well then I did ,not knowing is the worst feeling. Googled for the Lincoln MKX and hoping to find something and there your video was Nearly word by word what I typed in. Thank you so very much, the time and money you have saved us and many more people

Thanks for posting an useful video❤

what is the dimension of the oven and the dimension of the pan ?

My 1998 dodge ram 1500 5.9 stalls at red lights so I gotta put it in park and give it gas so it doesn't die or if its dying i gotta keep pushing the gas to get through the green light. Or I gotta pull into a parking lot and turn the truck off then back on so it gets it pull power again. Can anyone help?

Hi RJ, thanks for a great video. Could you tell me the diameter of the area where the grommet rubber seal goes on the fuel tank rollover vent valve. We're having a hard time getting that part. Thank you, Larry

This job is HELL!! Damn distributor is buried and can barely be seen!

Use a screwdriver before taking caliper bolts out to compress the piston so you could take it off without beating it with a hammer just saying.

Awesome 😎

Nice wrap on the steering wheel! 👍🏼👍🏼🇺🇸🫡

Cut top to size and use Duct tape to seal the cut?

Those are great trucks 💪🏽

🇺🇸👍🏼👍🏼

👍🏼👍🏼

Love the float.😂

Edit???

Congratulations Collin! 🤙🏼😎

They don’t make them like that anymore! Sounds good! 🤘🏼🤘🏼🇺🇸🫡

That baby is sweet

"When it's too tight, spit on it!" Life lesson 😂👍

Slide a screwdriver behind those tanks and they come out much easier

I have a 2010 Ford Edge Limited with 207,000 miles. There are a few cosmetic fixes I need to make but the car is still running well and I’m getting 23mpg consistently. I also drive it very gently and don’t really speed because that kind of driving just tanks the mpg. I drove a hurried road trip home (approximately 250 miles) and normally would have made that on a tank of gas EASILY. But…I sped as much as safe and possible and only got about 200 miles on a 19 gallon tank. What an eye opener for me. I knew speeding really affects gas mileage. I didn’t know how drastically. I went from a typical 23 mpg (highway/country roads) to about 11 mpg (highway at 80-90mph).

Ur going to make how to videos adjust the camera so we can see

THE BODHI12345

"Momo the monster" 💀

Puedo ponerle aceite Full Sintético si anille o cambié los aros de los pistones.

I have a newer version of that lawnmower, I added gas and started it up, a couple of minutes later it shut off on it's own and I could only get it to run on starting fluid. Is it possible to be the same issue? The machine is 3 years old so I'm surprised it failed after using it all year. I suspect my gas can may have been left out in the rain, so I dumped the remaining gas out and bougt some new. I was able to dump 90% out of the machine and replaced it with new. Any advice?

I Did Many Vehicles Air Conditioner Without Vacuum Pump, Gauges And Garbage, I Replaced A Lot Of A/C Compressors And I Never Used Pump or Gauges, You Can Do It ? YES. Amén.

I've got one bought it second hand from a friend but it's staining thr clothes with these weird stains that look like oil. So now I know why she was selling it. 😂 it's now outside waiting for Junk Removal to pick up

This guy must be an idiot!!!!

Aw ❤

How can a net look like glass? oO

What the

🤙🏼

With socks like that I understand how he got athlete's foot.

That glass is so clean

Sad

I think it’s the claws or sum that stick

How?

Wtf is he spidercat 💀💀💀🤯

Subbed today. This is adorable. Tfs

How about if the other wheel doesn't move? My rear end has been making noise,especially when turning with power. I jacked it up the driver side I spin it the passenger side doesn't move. The passenger side I spin it the driver side moves in the same direction.