Wet muck on saddles ??

These valleys have there good points. Dry valley, Dry Ridge, dry verge = good in my book. No Mortar No Moss. Lead work still needed if eaves course are tilted (as they should be) as pitch angle differs, its no problem, a lead section of valley at eaves is still required, approx 750 mm in length careful cutting and abutment of grp needed at change of pitch. Lead is king agreed but some( not all )joiners today struggle to get the boarding right to support it. Besides when a dry valley is done right and tile cut abutments are true they are great looking and most of the water runs down the tile and not into the valley!! Great thinking.

Why clip the cuts when they can't go anywhere 😂

why would you have a paid advert in front of your own promotional video?

This stuff really is a gimmick, theres zero advantage to using it over lead, maybe a fraction cheaper but not near as good,you still need lead using this stuff anyway. These companies would try to sell you any stupid idea nowadays

What a gorgeous tile

Where is the video?

Wow!!!

As a DIY I know I should even think to do it myself but I can help myself... LOL

Red chalk no good on a roof John

Why he fixt the battens before he put the valey ?

rough job that wow hahaha

What colour are those roof tiles?

Them laths will b an inch higher than the rest at the valley . How will the tile sit flat . ?????

Thanks for the information lads bang on job 👍

What s rough fucking job !

Question, I have a dry bonding tray that meets an open grp cemented valley. My roofer have told me because of this they need to leave the width of the dry bonding tray incemented where it meets the valley which is approximately 25cm gap under the valley tiles. But he is confident this will remain 100% water tight...? Advice on this please...

Be hand if some of these questions was answered?? thanks in advance

How do you clear out the moss and silt from the gully under those tiles after a few years ? I don't understand this system.

What about the very top of the valley? How do you cover the joint on top between the left hand valley and right hand valley

Does the solid valley support not kick up the tile battens, as I noticed that it was sitting directly on the joists, just as the tile battens are?

Do it properly in lead the first time

Usually wen using these valleys cos they sit straight on valley board or rafters they won’t sail over the fascia kick so u bring it bk inside fascia and av to put saddle at bottom

Hello boys

Can you use this type of valley for a slate roof?

first one to comment🙋