This video sucks if you just got a new Dorado…

What size is that Chrome bracket are you using to hold the transducer?

I don't have any of these straps on Dorado v2 48V ...there is a rail in the middle and some orange lever... no idea how to set it up tho there. I manage to figure out the rear with seat adjuster, but a manual explaining the orange level would be nice.

I know I’m late to the party, but I’m looking to get a fishing kayak. I’m 6 foot 240 would this be a good kayak for me?

This thing is way over complicated, factory instructions suck, this video doesn't show anything very well. Little ridiculous for a almost $300 piece of plastic

Brilliant. Just what I need so I can continue to enjoy kayaking with my dodgy knees!

"@Feelfree Kayaks" At 2:16 the narration says "place the THICKER washer at the top of the opening for the rudder as shown" -- but the guy in the video is placing the THINNER washer at the top of the rudder. Then, seconds later, the guy in the video places the THICKER washer at the bottom during the install where the narrator says "add the THINNER washer to the bottom as shown". So.... Which is it??? Thicker washer on top, or the bottom? The paper sheet that comes with the kit seems to suggest that the THICKER washer goes on top (at least for the Lure 13.5 install), but there are no written instructions with the rudder kit - only very vague diagrams.

Great simple video well explained

If you tie a few knots on the end of 20lb monofilament line, you can use compressed air and it will blow the line up through the tube in seconds. Stink the other end of the fishing line through the cord, tie it off and pull it through.

The unitrack isn’t convenient at ALL. It’s a proprietary track system that doesn’t allow you to use universal mounts, rod holders, etc. you have to buy adapters.

There are no accessories! I have to buy the yak attack adapters for everything literally

Nice l need one

A positive review by the people that make the kayak? Go figure.

Do you trust this in the ocean? How’s the stability? Should I worry about tipping it or do you think I’ll be good? 215 lb 5’9. I ordered one but nervous about stability. I want to fish in little deeper of water, but don’t want to swim in it. I’ve caught too many sharks to know better.

Could you use well nuts to mount the plate to the bottom of the pod?

I love my feel free kayak, cant wait to upgrade myself!!

The wheel on the back end.. always starts leaking water inside the kayak, worst part engineering there

Great job with the innovation!

seat is bad rest very good

I just order your Lure 13.5 v2 with the overdrive system and would like to know if this stand up bar work with that set up . I could see adding a striping basket for fly line management . Any thoughts would be much appreciated.Thanks

does this system work with the moken 10 v2 lite? and if so, when will they be in stock on the website?

Not much info here in this old video.

I love my Moken 10 v2 but hate your rails. Why not stick with what everyone else is using? You won't be seeing anymore of my money because i'm taking your rails off and installing yakattack rails. This was a very bad business decision on the part of your company. I wish i had done more research before I bought.

How to do you get side scan to work when the transducer is recessed like that?

I’m more of a SOT kayak guy, I own 3, but this would certainly be a sit inside kayak that I would consider buying, very nice, well designed 👍

Is there area to attach fishing pole holder?

Thanks for the heads up dan u were right this is the Boat for me.. 6ft 230... U.S. Marine veteran.. yep 799$??? Great price. (Ill add the rudder and some Sonar action for sure.) also i want a trolling motor Any suggestions? Thanks again solid review. 👍.

You are about as clear as mud

why you design a uni track, and don't make any uni track accessories? suck like rod holder, fish finder mount, etc.... i have to but the adapter to use other band accessories? what is the point of make this uni track???? just make yourself different then other and add more weight on the boat and make us spend more money???

I have the 2017 Lure V1 13.5, and the internal tubes the rudder cable runs through have already deteriorated and turned to literally dust. Odd, because the rudder has bever been installed, so it's never seen any use. I would order replacements, but I cringe at the thought of having to replace them every 3 to 5 years. Apparently this is a common issue that others are having also. Although not a costly repair, threading new tubes through will be almost impossible. Not a job I look forward to doing. Just a heads up if you plan on buying this kit, and are having cable install trouble.

Same issue with the pull cord not wanting to thread through the lining. Use scissors and make the cleanest cut you can on the end and hit it with a lighter. I used my fingers to twist and compact it while it was hot.. it worked though.

I recently bought the Lure10 and 11.5. Very happy with both. The 11.5 came with a trolling motor, fish finder, paddle, battery’s for both. I would like to mount my GoPros on the side track also. Can you tell me where I can purchase that plate to mount it on? Thank You.

how does it paddle up stream

can you float fast moving shallow river in lure 10?

Well done Dan as always! Just bought one myself and the reviews from Dan, and Seth’s most recent vid “Best kayak for river fishing 2022”, is what sealed the deal for me. Fired up to get the new Moken on the North Alabama rivers!!

I am 60 yrs old, 6ft tall and 260 lbs. I have been trying to decide between the 10 v2 and the 11.5 V2. Do you think that I would be better off with the 11.5 due to my weight or can I get away with the 10? I am a brand new to kayaking.

Good job. My favorite Kayak.

I am only a fly fisher, I can’t decide between this boat, the lure, or the coosa hd I primarily will be in creeks. And rivers.

hello can you please tell me about this kayak for : LENGTH:... cm WIDTH:... cm thanks

What about the Flash

Have one on the way, partially because of this video!

Great video! It helped immensely with my install. Thank you guys for putting it out there. It took about 30 minutes from start to finish.

The rudder up line will not go feed through the hull. It starts good but then gets jammed up. What can i do about this?

I bought this bag from EcoFishing shop and a Moken 12.5 v2. Here is the review I copied from the EcoFishing website... I purchased a FeelFree Moken 12.5 kayak. Then I purchased a FeelFree Crate Bag. The bag costs $129 plus shipping plus tax. When it arrived, the 1st thing I noticed was that the support plates were wrong. The side plates are different, 1 has 2 mounting brackets for rod holders and the other has 3 brackets. Mine had 2 of the double rod holders and none of the 3 rod holders. This made assembly impossible. I kept going anyways planning on only having 2 rod holders. The support plates did not fit. When you force them in the sleeve the whole frame gets wonked. It is a crooked crate. I took my crooked crate with only 2 rod holders to my Moken and the crate bag did not fit... The Feelfree Kayak and the FeelFree Kayak Crate Bag are not compatible. The crate only fits in sideways. When you install the crate sideways the rod holders are in the front and block access to the top of the crate. The gear bags are not useable as they are pinned in by the tank well walls. Also the lid requires 2 hands to shut and you need to adjust it every time you shut it as the flaps never seat right. This crate is worthless and clearly never went through any sort of QC in manufacturing. I returned it... EcoFishing does not do returns. When you make them do a return you pay a 10% stocking fee and must pay for the shipping. I got the 10% fee waived but the $71.88 it cost me to ship it back was WRONG. They could easily have given me a shipping label that would have cost me about $9, but EcoFishing wishes to discourage returns and this is how they do that. Do not buy this product.

Have you guys considered making a smaller one for the Molken V2 I definitely would be intrigued...🤔

These factory videos leave so much to be desired. It says nothing about putting a hole in the kayak to run the up/down cable.

Is it possible to mount my Newport Vessells 46#thrust to back of this yak?

Awesome Kayak

Would love to see a review of this yak out of the ocean.

I like this Kayak! I have this Kayak and also to use on my fishing KZbin channel YakAngling. Great Video!!!