KZ
bin
Негізгі бет
Қазірдің өзінде танымал
Тікелей эфир
Ұнаған бейнелер
Қайтадан қараңыз
Жазылымдар
Кіру
Тіркелу
Ең жақсы KZbin
Фильм және анимация
Автокөліктер мен көлік құралдары
Музыка
Үй жануарлары мен аңдар
Спорт
Ойындар
Комедия
Ойын-сауық
Тәжірибелік нұсқаулар және стиль
Ғылым және технология
Жазылу
Joe Perzan
1:24
Me and dad flying drone - June 2016
4 жыл бұрын
19:09
Mexican Riviera Carnival Cruise 2020
4 жыл бұрын
0:07
Mavic Mini Crash
4 жыл бұрын
Пікірлер
@lewishall5118
15 күн бұрын
I’m trying to think long a way the slot can be notched out so there’s no exposed slit at the sides? Has anyone found a solution?
@michutch1
Ай бұрын
I didn’t want to butcher my posts either and was trying to come up with a tidy technique when I came across your video. Thank you for sharing
@TheChupacabra
9 ай бұрын
Good man, I’m always blown away by folks that can come up with novel jigs for old problems
@mattmatcuk
Жыл бұрын
Incredibly helpful. Thanks for taking the time to share this idea. Simpson Strongtie owes you one.
@dougabrams3264
Жыл бұрын
Best idea so far but I think I might try a router or square drill bit from the bottom and not have the exposed openings on the sides
@gregkeeyako
2 жыл бұрын
I would have made the jig tight side to side and just offset it by 1/2 the plate width and then just flipped the post 180 degrees and cut again.
@pacomarmolejos1869
3 жыл бұрын
Slick work! I have a new appreciation for wax paper.
@anitaperzan9736
4 жыл бұрын
Miss you dad
@sleepingbearffg5008
4 жыл бұрын
How the hell did you do that?
@istvanszabo4173
4 жыл бұрын
Ügyes!
@Freezeation
4 жыл бұрын
Lmao
@sleepingbearffg5008
4 жыл бұрын
Hate to laugh..but was funny..
@aarhusdc4298
4 жыл бұрын
Ohh @#%& Sport mode?