SEAL CLASPER AMAZON OR IF YOU HAVE LARGE HOSE CLAMPS IN A PINCH OR WRAP BLACK ELECTRICAL TAPE AROUND TIGHT

Thanks I will order one

We are all dead! Just a matter of time besides i dont have to go to the beach for a tan, btw it tested out perfect....

not worth the time to set up the cnc....

john wick motivational music lol

30 years experience still have all my body parts, the gloves fit super tight. i respectfully disagree with you.

@@LOWBROW369 I wrote this for the following reason: In the Machine shop where I learned, there was a case where the person changed a milling tool with a glove on and couldn't reach the disengage button of the spindle. He then told a coleague to "press the button". Instead of pressing the disengage button, he pressed the spindle start button. End of story: Guy with gloves ended up loosing his middle finger and the OSHA from Germany (Berufsgenossenschaft) tells people to not use gloves where they can catch because of that since then. Therefore please don't use gloves on the following machines: Mills, Lathes, Drills and similar. Use gloves on: Benchgrinder (Disk or Belt), handling material. (Automatic saw is a special case, do as you please, I like working without gloves there.) Thank you for your kind answer earlier, I hope you understand, why I told you to do it this way. If you still want to use gloves on Lathes and so on, do so because you learned it that way and it has advantages. As a professional I was simply concearned about your Health. Best wishes and best of Luck to you.

@@miendust THANK YOU, NOTED, IF WE RETIRE WITH ALL OUR FINGERS THEN WE SUCCEEDED!

thank you i will correct and do another i lost the audio still learning how to operate you tube thanks

this cylinder works with another one 22 hrs a day hard, customer just authorized us to machine a new rod

the customer told me they were running at 3200 psi, note we repair and reseal the cylinders but seems like we are always responsible for customers systems lol. we will get it fix. my goal is to give insight of the hydraulic business and how it works.....

Yes i lost the audio but will do another one to explain, im still learning how to operate you tube thanks for the comment.....

would not be cost effective for us as small business

@@LOWBROW369 if you guys need softwares to be written for some hardware, hit me up

how would you do it to be cost effective the load is thousands of pounds, all we could do is a simulation, we have done 100s of thousands of cylinder repairs

@@LOWBROW369 I am sure you could rig together a universal fit kind of a thing for less than $1000

@@mechcntr7185 i wouldn't put my hand on that machine lol

could be system runs 22 hrs a day oil is hot as hell its just the way it is high pressures also

When the cylinder is run all the way out, it is the same as putting a load on it. Pressure against the stop would be the same as pressure against a load. And if he wanted, he could run a length of chain around the entire cylinder and press against that which would simulate a load at any length of piston travel.

@@HueToobBlows It could be leaking anywhere along the stroke, and without a load it would never show.

@@lastmanstanding9389 You saw the part of my post where i mentioned "chain" and "points along stroke" didn't you?