Sir how would the internal left hand thread look like in which direction?
@charleskaruru481Ай бұрын
@@tryphosamasenya6932 how are you.. You can see that we have drawn a right hand internal thread and we can see the lines representing the threads are sloping down to the left...now for a left the lines will slope in reverse direction of the right hand
@mahlulelimgandela3 ай бұрын
What angle did u use to measure that line which form a UAR
@vannesamomongan97624 ай бұрын
what software did you use to draw?
@charleskaruru4814 ай бұрын
AutoCad
@Annelie-o7o5 ай бұрын
Thank you. It was helpful sir
@tebogokhumane406 ай бұрын
Isn't on 1:35 to get the diameter [ min diameter (Dm ) ] you have to to subtract outside diameter and wire diameter ?!
@charleskaruru4814 ай бұрын
Yaah thats correct and the Dm is going to be 58....which is exactly the same as used on the video
@alwynstroebel5607 ай бұрын
thanks
@mrchapter941610 ай бұрын
Fast and easy 😊
@Mancakes_11 ай бұрын
I needed this , thanks Charles
@titusmonoke8857 Жыл бұрын
Daz greatb👍
@josefmuronga3197 Жыл бұрын
Thank you bra 🙏 💯 🙌
@nondumisomthembu6383 Жыл бұрын
I am so happpppy with is method of drawing a thread
@Amazing-bh4tc Жыл бұрын
Sound Voice is too bad
@charleskaruru48111 ай бұрын
Thanks will imporve on it
@heart413 Жыл бұрын
thanks Charles
@benkalemba32882 жыл бұрын
Where's that 16° come from, can you explain that please.
@benkalemba32882 жыл бұрын
Thanks a lot, keep it up sir.
@ellyzelly41122 жыл бұрын
but u have used anti clockwise ...the question was stating it should be clockwise
@charleskaruru4812 жыл бұрын
When the cam is moving in a clockwise direction...the numbering on the profile must be counterclockwise
@abrahamchimwanga9451 Жыл бұрын
He's 100% right.
@Ndazo_ Жыл бұрын
Thank you
@kaveshlutchman74912 жыл бұрын
How do you know it 16°
@benkalemba32882 жыл бұрын
Yeah I don't understand also
@charleskaruru4812 жыл бұрын
Which one are you referring to as 16°
@charleskaruru4812 жыл бұрын
On drawing those lines you are going to draw lines that are incline at 60° not 16°
@housechild36202 жыл бұрын
Which software do you use for drawing?
@charleskaruru4812 жыл бұрын
I use AS SW and AUTOCAD on this vjdeo its AUTOCAD that l used
@kreasiumum2 жыл бұрын
The theory about triangular threads (metric and whitworth) is very useful, thank you for the knowledge, sir.