plese send softwere link or add on coment

Name of software?

باللغة العربية

If the sight forgets to stay in its place, will it redo the work or go back to the last point or read the cut before in the last station.thank you,

Good video for information

When the prism says -30 mm, you set it to 30 mm?

Only RL kiyase set up karega

Only RL kiyase set up karega

I was looking for point editing and found. Thank you

thank you

What is the difference between FastStatic and PP Kimenatic? And when is is recommended to use one or another?

Good Job Can you upload a video on how to make the arc from a Nikon total station?

Can you please tell me or upload a video how to make ARC refline by 2 points with or without an angle?

What is the CD? Saw yours said CD 20mm

File transfer error message: While converting to .SSF it gives me error message: Receive operation Completed. 1 File(s) Failed. Conversion failed, how can I solve these issues, or there is any to repair or convert it (Trimble Juno 5 Series)

File transfer error message: While converting to .SSF it gives me error message: Receive operation Completed. 1 File(s) Failed. Conversion failed, how can I solve these issues, or there is any to repair or convert it (Trimble Juno 5 Series)

Good

Me watching the video 10 years later.

where can i find the simulator?

How to use corve function

How can I change the language Nikon DTM-S405C total station?

How can I get the downloader apps?

Did you do ather parts as well?

Thank you. Can you please tell me how to stake out the point in continuous mode?

Thank you so much for very clear & nice explanation.

Nice lesson

Thank you sir

Great information

Donde puedo consguir ese simulador?

kzbin.info/www/bejne/iqi3c5Roq8urr7s

kzbin.info/www/bejne/iqi3c5Roq8urr7s

I am a fresher sir How to install instrument and total station function

my dtm 322 stuck in tilt telescope

How to check verticality in Nicon

What is list and stac?

How to donload this software

Tiene el emulador

Carve ... 4butten all work

hi ps tell methis.... as soon as i have started the base and rover is it necessary to make off the rover until i survey the next point? or i have to move to the next point as the rover is on? shortly when moving between consecutive points to be measured shall i keep the rover on or off? MANY THANKS

very informative. Can i get the simulator?

Hi, I have error saying sighting axis error. What could this mean?

Could you please provide this on board Software to get practice. If you wish please let me know via [email protected] Thanks in advance.

This total station it's possible one time set control points after job's change using ???

What is the ctrl job function? How to use this ? Please explain this

Hi.. please can I have a link to download the file?

Por favor enviar en español a mi correo luisguillermocuevadavila8gmail.com

I want software link for nikon dtm322

How to change prisam from card to mini prisam

It's 2020 and Pathfinder Office is exactly the same as it was 7 years ago! On the bright side, that means the instructions in this video still work perfectly! Thank you!

Excellent video. Necessary and sufficient. Might be the most direct route to the desired information that I've ever seen.