Hermano..! no agarres el disco con las manos llenas de aceite...!

The chain tensioner is defective, all Kawasaki of this engine series from GPZ 900R to ZRX have this problem ... My tip is the tensioner from the ZZR 1100 C.

O visto dei video che dice che le forcelle sono troppo morbide c'è qualche modifica per fare un po' dure

It's milk or oil?

What's he doing

Michelin pilot road 6👍🏼👍🏼👍🏼

Sé fosse uma mola, dê 2000 rotencoes você não consegue abrir fácil

Why does he heat the stem? It will expand in dia and the bearing will be even more difficult to slide over it, or not?

Question sir how did u loose theat center bolt because mines keep spinning when I put the wrench on it

why oil like honey? and filter empty?

Should of sprayed some Dry Lubricant on the Rollers and inside the Casing

i love my mt07 did chain now mileage almost 60000kn still ok

Very good explanation, straight forward, thank you sir.

ano kapareho ng address fi 110 sa cvt at assemble nya ?

Please need help to fix it

Isome one pulled all fuses out of both fuses boxis now I don't no what goes werr

You can just remove the clutch slave and not undo the fluid pipe its saves loosing clutch fluid and making a mess.

thanks

Do you need to drain the oil?

What am i looking for?

What’s the advantages of removing it?

Hi 4:40 is important Put these plates back? I changed The pills but I didn't put those plates back in.

Рукожоп

Shouldnt be this dry

Thanks you❤

Glad I don't need to mess with a 1.4 L bike chain

Hello How much ml oil goes in 1 fork and what kind of oil you or yamaha recomends? Thanks

What should I do if that pen up top came out of the engine

Thank you, they want 500e for sprokets with chain and change. Going do myself 🤘

Oil looks new

very good video, you are the MAN

How many litre for engine oil?

Do you have job for me I'm also working in yamaha

Super brutal

This video shows just how ridiculous simple maintenance tasks have become. At least you can still get a few bikes where changing a spark plug takes minutes instead of an hour or two.

Why does Kawasaki have to make front sprocket removal such a painful process? It's so difficult to remove even on their 250cc bikes.

super vidéo très pro 😜😜😜

What do you use for to clean that ? I need that liquid too

How did you get those 2 Philips out on the rail? I swear mine are so seized up 😭😂

Thanks

What would the average charge be at a dealer ? How much did you spend ? Time ?

Do you have a video about bleeding rear brake on cb1000r?

Démonstration simple mais explicite. Merci 👍

Yours popped off quite easy.. any tricks to that? I removed all bolts but it's not coming off

What’s with the crap background music. Waste of what could be a good video.

Merci pour ta vidéo 👍 Elle m'est très utile, je dois le faire et ta vidéo tombe bien. 👍 Merci 👍 J'ai un CBF 1000 de 2010. UN bonjour de France à Nice.

Did yoh replace the slide and guide bushes or just re-used them?

HOLA TENDRIAS UN VIDIO CAMBIO DE RODAMIENTOS TRASERO Y REFERENCIA

...to think I'm charge 2 hours labour cost...this fella is said and done in under 15 minutes 😢

Конечно, тебе же не ездить, блядь, на этом мотоцикле - можно и раму антифризом облить и свечи бросить в колодец!