Sean Tiner scholarship s,2015,www.usascholarships.com #scholarship

Amanda Brawn, I think he’s actually using kitty litter in the tray...kitty litter is clay-based, so that would make sense. I’ve used regular play sand with my castings. As far as a torch, you’d want something like this Victor kit with tanks and regulators: www.amazon.com/dp/B01GDRF9W2. Don’t skimp on your torch...you can pick up cheaper kits at different budget tool places. But since you’re literally playing with fire, you want a known brand and not a cheap knockoff. Smith is reputable, Victor, Lincoln Electric. Also, you’ll want a dual fuel torch...with propane and oxygen or acetylene and oxygen. The oxygen gets the flame hotter. I have an acetylene/ambient air setup, and it would not get this amount of metal hot enough to cast. If you’re doing smaller pieces of jewelry, you could use a Bernzomatic torch from a home improvement center...get the one with the yellow tank (MAPP alternative...hotter than other gas they carry).

Oh, also, expect to pay about $300 for a good torch setup with tanks and regulators. You’ll find cheaper kits, but they’re usually cheaper because they don’t include the regulators or tanks, which are a good part of the price of the setup. I would also recommend doing this outdoors...the cuttlefish burning smell is like burned hair...it’s pretty bad! Also, being outdoors will make sure that the gas and carbon monoxide dissipates. I was told by an instructor once to never use propane inside a house or a basement, especially where there might be a gas water heater...the propane will sink to the floor and travel. Also, if you buy your torch at a local welding supply, they are usually very good at educating you how to use the system safely.

Great tutorial...so peaceful by the pool! Another tip I had seen used in the past is to use a soft paintbrush to brush the carved cavity to bring out the cuttlefish texture a little more. Your pieces are beautiful, and the video is really nice. Thank you!

Very nice tutorial! Thank you!