Nothing is better than the original Tabasco sauce. My favorite thing in the world.

Weber is great and last but man they high.

What size socket extension to remove drain plug? 1/4, 3/8, or 1/2?

Could this cause the "overload" LED to turn on / stay on? I changed the oil and this started happening afterward. It doesn't die but won't get out of overload state (with nothing plugged in; reset buttons don't work). Thanks.

My shit won’t turn on

Great information!!! can you also ask for diminishing value once your new 2023 car is fixed after three months of being at the dealership to get a engine

ok, my 4000 runs for 10/12 minutes then shuts down. i did remove oil to no avail, same results dies after 10/12 minutes. i took the fuel line off and the pump is working. whats next ?

How much are these new ?

Ok did those three tips and no electric to the outlets. Microwave work though. Next video?

Great job

Do you thread the dipstick all the way in when you check your oil, or do you just put it in without twisting it tight?

Holy crap....this is too hard to believe but it's so true. My generator is brand new with only 10 hours on it. Same issue, the darn thing would run for about 1 hour and the stall out. After watching this video, I noticed my oil was at the full mark, maybe even a little higher. I sucked out about 8 ounces, which dropped the oil level to about mid way on the dip stick, and my problem was solved. Had the generator running for 3 straight hours without any stalling issues. Thanks so much for putting this video out there!!!!

Man thank you ! I didn’t have any problem until I changed my oil . Since the I’ve had problems between 15 minutes and an hour shut down . Luckily I haven’t lost money over it yet . I have an appointment next month at an Rv deal ship . I’ve talked to Conan techs and few times . Nobody mentioned this . Even when I told them that I had no problem until I changed oil . I was told to plan on a minimum of $500 to $1000 to diagnose it . Because it has no code ???? Well long story short . It’s running like a top . Thank you so much !

3:58 2nd and goal at the one

Very good.

Thanks for this video. While changing out the fuel pump on my boss's RV I accidentally flipped that circuit breaker. Watched your video and it's working now. Thanks Again!

Love the video thanks for sharing. Definitely could tell which one’s your favorite because the bottle is less full than the others.

hmmmmm early oil changes are a waste ok if you say so😂

Thank you I'm in Florida 10 12 2024 during hurricane milton with power from my rv generator .. your video helped me , it was the switch on the generator in the off position.

good luck with that 1.3 turbo

My friend you just save me and my family in the middle of the hurricane Milton, GOD bless you ✝️🙏🏻

Thank you so much

Off topic, my PTO handle is fairly loose in the non-engage higher position. I was curious if yours is also loose? I tried to tighten the pivot bolt but its tight. My PTO works fine, but that handle seems loose (has a little side to side action). Maybe thats the way its supposed to be. The cable guide looks fine too. This is the assembly just to the right of the filter area and also has a safety button.

Thank you very much for the video. The same thing happened to mine yesterday and I thought it was the inverter.

WONDERFUL i had this problem and was about to go on a trip ,, oh no now an expensive repair .. but wait this man had the answer YEAH i took about 4 ounces out of mine and it started working again THANK YOU THANK YOU

Found this video after Hurricane Helene in 2024. The entire city is without power, and I was thrilled to be able to use my RV and it's generator. AC wouldn't work. I prayed and found your video. So, at 2:30 am, I flipped that switch and voila, there's AC power. Blessings to you for making these videos ❤

thanks . this is the third video I've found to point out that switch . my solar guy said there was probably a breaker around the generator somewhere

Fixed me!! Thank you I’m sure it saved me a boat load of money🙏

Welcome to the club!,

Looks easy but the plastic makes me nervous! Thanks for your video,about to do the first change on my wife’s brand new Encore and thought I’d better consult KZbin first! Lol

Too much oil will buy ld up crankcase pressure.....can push out oil seals makin a big messand alot if uneccessary work .make sure your crankcase vents are clean and breathing

Where is green one???

great vid! looking forward to your fajitas recipe next

congrats on the move! great vid as always

Thanks!

Thank you so much I just had to flip the switch on the gen and it worked.

Is this applicable to the RV QD 10000?

This guy is spot on. Fixed my problem right away. I filled to the midway and runs perfect now.

6 years later you saved me a WORLD of headache. I am restoring an old 1978 Itasca and could not figure out why the generator was not providing ANY AC power.... I had no idea the shore power cable need to plugged into the Powerbox that was just hanging in the opening! Working great now!

Do these stop the visors from going clear to the windshield?

I'm about to drain some out now, I'm having this exact issue runs good for a few hrs then dies and keeps dying after that ... update shortly

Holy smokes!!! I have a 2022 Onan 2.5kW LPG generator with 38 hours that kept shutting down after 20 to 30 minutes. I'd restart it only to have it run for 10 or so minutes and then the generator would then shut down again. I got under my coach to check the oil level and sure enough it was overfilled. Yesterday afternoon I removed the recommended amount of oil. I verified the oil level on the dipstick and then restarted the generator. It ran for an hour and half without an issue. It purred like a kitten. I hope the folks at Cummins are paying attention as well as all the RV dealerships. Thank you!!!!!

I made a bigger mess than you. This same engine on the tractor type mower, the drain plug is different, making it easier.

Thanks for the video, sir.

Question, is your flames too high? Because I just got one and on the 4 main burners the flames seem too high yellow. I’ve adjusted the vents and reset the regulator. Is this normal for this type of grill?

I just had to have a new engine put in my 2019 Jeep Compass back in May. Now in August I just got my car back from having a new transmission and radiator put in🤦🏾‍♀️ My car transmission cooler was leaking internally causing coolant to get into the transmission and transmission fluid getting into the coolant system. I’m seeing too many online saying they’re having these same kind of issues with their Jeeps, this is crazy!!! At this point they’ve built me a new car under the hood.

Thanks for sharing your thoughts on this! Just started having this “start/stop” problems… I run my generator under load each month for one hour. 12 months later it now does this “start/stop “… Hopefully this will fix problem.

Man I really appreciate your video , was about to replace filter and pump was on way to sturgis , watched your video , stopped by a hardware store bought a turkey injector to pull some oil out and BAM !! problem fixed .. thanks for your video

My pin was out I put it back in and it still didn’t move. I checked my belts and one of the belts was broken. Thank you

I understand this model has a 3.6 penstar engine,the upraded version which has a 11.3.1 compression ratio so definitely would take advantage of premium gas.