So sorry about that Joseph, when ever the motor get wet during operation it is impossible for it to recover again and it is going to short the windings, so you need to buy another motor and another seal, the seal is located underneath the spin, the shaft passes through it going down to the motor, don't install another motor before changing your seal

@@princereign6385 ok thank you very much for the information

You welcome

Is the motor silent or there's a humming sound

@@princereign6385 it's making sound but doesn't spin

@@princereign6385 there is huming

@@princereign6385 th is a sound

The motor or the capacitor is failed

People only pay attention on what my hands do and what my voice says, I find it unnecessary for the whole word to see my face, they need help, they must see what I'm doing and what I'm explaining no matter without face being revealed

I appreciate the support thanks for watching

Thanks for watching

Check my assistant number on the Discription below , and I can only assist you in English

He asking if possible to use an oi?l if there's no grease is available

No, you can't use oil

What's the problem

Ok bro, is the motor still making a hamming sound?

Nop it is not allowed dude

You welcome bro

I bought it at Defy store

Yes but be careful not to submerge or not to allow water getting into the combustion system

Hey you welcome I'm here to help you, if the motor is humming without turning the shuft, it seazed and there's a short happening somewhere in the windings that cause a cracking sound , it can't be repair but you have to replace it

Oh really sorry, Is the motor still making a hamming sound while you turn on the spin nob?

Thanks for the support, I real appreciate it

Hy Tammy welcome to dirty hands, yep I can help you, here is my whatsapp number 27 61 453 1577, it will help you to make some short videos explaining your machine problem to me, I will respond after seeing it's reaction

You welcome

Of course, it the same problem

So Where is the strange sound coming from, is it coming from the spin side or the washer side?

I really appreciate the support, God bless you too

Is the leak coming from the dryer side or is it coming from the washer side motor?

If you're talking about the slim pipe attached to the water pump I was holding, it is the pressure regulating pipe and it's end is suppose to be attached to the back of the machine by inside at a high point and you need to be sure that it is well secured but do not block it for the vaccum to suck freely , check the video properly

Get it's picture and share with me on WhatsApp 27 61 453 1577 , I'm gonna tell you what to do,

You're welcome!

Try Filling up your dryer with heavy clothes at the bottom first followed by light lighter and the lightest will kill the jiggling thing

Glad it was helpful!

Are you in Nigeria

So sad bro, we can chat, sharing everything about it on my whatsapp number, + 27 61 453 1577 I will tell you what do

Hey my machine was working but jus stopped spinning wat can be the problem nd sometimes it make some noise

You need to find a wire long enough to reach the sock, make a small hook on the other end of it with plier and use it to fish out the sock,

​@@princereign63850

Is it a squeaking sound or the sound is grinding?

@@princereign6385 I think it is a squeaking sound. I have a video of it but don't know how I can share with you.

Ohk you should open the back panel and run the machine at the spin tub side and start recording I want to see three things that causes that issue, I will tell you what to do next

27614531577 share on my whatsapp

@@princereign6385 Thanks I will do just that as requested.

Check the part 2 video will demonstrate the major cause of the problem, you will be saved

Thanks for the support, May God bless you ♥️